Amplifiers / Head Units / Processors / Electrical

hey guys, just wondering if anyone knows (or heard) of soundstream making good amps. im debating buying either a soundstream pca2000d or a kicker zx1500 amp. they both push 1500rms when wired at 2 ohms. naturally i would just go for the kicker because no one seems to have anything bad to say about them and are under rated, i just dont like the fact that the kicker can't wire down to one ohm if i decide i want more power. please lemme know if you heard anything bad or good about soundstream...thx-phil

I have an 04 escalade and am wondering if I get a new Deck from say pioneer a dvd player double din style, can I still have my steering wheel controls? There is a lot more than just audio on my steering wheel pertaining to oil readings and gas readings and mileage and all kinds of stuff. Does anyone know what is all controlled by the current head unit and what can be lost from changing it out?

I got my box design, I got the sub I want in mind. (Fi BTL 15''), I got the Big 3 finished. Getting a free yellow top optima battery. In the works of a 200amp alternator. Will a 200amp alternator run a SAZ-3000D amp with/without ease? I want to make sure that this setup will not stress my cars electrical system if I have everything that I listed above. I would like to make this my daily system and enter small competitions. Comments much appreciated. Thanks, -Curt

http://cgi.ebay.com/KICKER-PKD4-4-GAUGE-DU...1QQcmdZViewItem will this amp kit work for a kicker zx1000.1 and a zx350.2?

I have 1 polk audio MM2104 10 inch sub which runs 300 rms and 600 peak. I want the best SQ amp but do want it to hit. It has to be brand new and no more than 200$ What should I get?

Hey People....I will soon be the proud owner of the SAZ 1500D!! I am wanting to get your advice on how to properly power the amp. I currently have a car with the stock 105 amp alternator. I've done the BIG 3 with 4 gauge wire. I also have 4 gauge running to my trunk.....It then goes into a capicator and then to a distro block where I have it going to a 2 channel 300 Watt Denon amp and also what will now be the SAZ 1500D.....I'm pretty sure that I will be starving the amp for power....SO...My question is mainly budget related. How can I give the SAZ enough power the cheapest way??? Can I run another 8 guage power wire and just use it for my 2 channel and leave the 4 g…

Amp is from 2001-02. There was a mod for it put out more power. I can't find it anywhere. Thanks

Earlier this week I had an opportunity to listen to a DD S4 amp. It was pushing a 6.5" component set up-front and one ported 12" in the trunk. Color me impressed, it sounded very good to my ears. I was just curious about other's people's opinions on the DD amps. *Are they reliable? *Are they expensive? *How is their customer service? The 4ch amp is rated at 100x2 and 200x2. Are there any other amps that can perform similarly for lower price? Just trying to weigh out all my options here by using ya'lls keen sense of cost vs. performance. What I really like here is the idea of simplicity. Headunit, amp, a set of comps, and one sub. I'm not looking to compete, but I a…

I just got a Denon DCT A100 and it didn't come with a manual or anything. I went to put it in and i saw that it has a few extra wires that I don't know what to do with. They are labeled as light, acc, aux in, and p. ant. What do these need to be connected to? Also, will I be able to use the same dash kit that I used with my old Pioneer HU?

Looking at the KDC-X792, looks like its got all the right features. 3x4v preouts, USB/iPod connection, aux connection, 2nd aux option, PAC wire, attenuator, 24 bit DAC, and the oh-so-handy Attenuator aka "Oh s... a cop" button. I like how it looks, and it sounds like I could integrate it well into my future car, with the USB jack replacing the stock iPod connector, and rewiring the stock 3.5mm AUX input to go to the HU. Anyone have any experience with the Excelon HU, especially the 79x series? SonicElectronix has it for $229. Your thoughts on Kenwood in general? The Alpines don't really float my boat with all the buttons bunched up on the side.

I currently own a 1995 Ford Mustang that I am thinking of trading it in (this car is great and cursed at the same time). This car has a 130Amp stock alternator and I currently have a SAE-1000D powering a Stereo Integrity Mag with 1000W RMS @ 1ohm. I also have a Crossfire CFA302 amp rated at 75W RMS x 2 @ 4ohms. I've never had a problem with these amps, so I never thought about upgrading my alternator to an aftermarket model that produces 200+ amps. Anyway, I'm looking at a few different possibilities for my next ride. I want a Nissan 350Z or a new Mustang GT, but that would require saving up for the next few years. I also thought about getting a truck, either a Toyot…

So the other day I did the Big 3 in my car. Everything had always been fine before it, I just did it to prepare for my next system. After doing the Big 3, I noticed something weird. In my car, there is a little heads up display for the driver, and after bumpin for a while, it said "Batter Saver Active." Wtf is this? I mean I would guess that it senses low power from the batt, but two different voltage meters show 12.8 w/ car off, ~15.2 idle, and ~14.6-15.1 while bumping. My voltage never drops below 14.3 volts, and I was just wondering why it would say something about the batter saver? Btw, i just added new wires, I did not remove the old ones.

All right, i have a question about grounding. I have an 1 F capacitor, got it for free and just using it untill i have enough to buy all new equipment for my truck. I was wondering if it would be alright if i grounded my amplifier to my capacitor, and then my capacitor to my floor? would there be any problems in that? thanks, scott Edit: This is gonna be for my sub amp

what would be a god amp to run it?

My HU has Front and Rear RCA outputs. If running front stage only, should I combine the front and rear outputs going to my external amp with a Y-adapter or should I just use the front RCA's alone?

Are the zapco SP7-SL and arc audio PEQ 1/2 din mountable, as in can I mount them under my denon HU in my 1 1/2 din dash? If so, how would I go bout doing this? Just take out the pocket and slide in the eq?

Looking to purchase a good amp kit to power my SAZ 1500d. I was looking at the Kolossus 1/0 Amplifier Installation Kit on Knukonceptz.com, but I'm open to suggestions/brands. Thanks for the help.

Well, the used Orion 8004 crapped on me and after trying to pinpoint where the issue was, I decided to scrap it. Noticed the Zapco i-450.4 selling at a local shop for $190USD (on EBay). I know it is a new line, but I'm curious if anyone has used one, or can tell me if the price is decent. Looks to be about what I'm after - 4 channel @75watts RMS, has all the xover bells and whistles which I won't need. Using it for complete active setup. Thanks, Mark

I drive a 2001 GMC Jimmy 4 door with a 4.3L Vortec V6 and want a 200 amp or so alternator to replace my stock one with and would like recommendations on what companies to look at. I am considering Excessive Amperage, Mean Green, PowerMaster and KnuKonceptz. There were others but I forgot them. Any feedback is appreciated.

when someone says there amp is 80% efficient at 2600 watts what exactly does that mean electrical system wise?

I am currently running a set of Crystal 6.5" componants on my Sundown 100.4 The HU Is a Pioneer DEH-P6000UB I keep having some "popping" from the mids.........as if they are almost over excurting at times. HU High Pass is set at 125 Hz The amp is set at Full Range. I cannot seem to find a way to shut off the High Pass on the HU and i wonder if turning on the High Pass on the amp could cause some issues. Also what could be the other causes of this besides it being too low a crossover point? Gain is slightly less than 3/4 no bass boost or anything else. Ideas are VERY welsome. J

From those who have experience with these batteries- I need a total of about 4000 worth of their model numbers... For instance 2 hc2000s or 3 hc1400s, get me? Ok, i got a small area to put batts in, i had emailed them asking if i'd be all right if i ran 6-7 HC600s in the back... They told me no, it wouldnt last that long before they were completely discharged. They said the HC600\800 are like large caps, not long-term batteries due to their short reserve time(too bad they dont post reserve time on their site!!!) So, i called them up just now and got ahold of someone on the phone who sounds like he has less experience with them than i do... so i come here. For daily driv…

i was really close to ordering a Pioneer AVIC-D3 for the Mini. well, its 700 shipped, 6.1" screen, navi, etc. for a couple hundred more, why not get a carPC? so im doing just that. i ordered the 10.4" samsung VGA touchscreen. i need to figure out the PC thing now. im mostly concerned with the audio output. im going to keep my Head unit, and run audio out from the PC, to red/white aux in on the nakamichi HU. then sub/front/rear outs from the HU, to the EQ, then to the crossover, then to the amps. my question is, if the audio out on the PC is a standard 3.5mm jack, would is sound bad if i ran 3.5mm out from pc, to red/white aux in on HU? (i ran my ipod this way for a while,…

http://www.woofersetc.com/index.cfm?...category_ID=58 http://www.sonicelectronix.com/cat_i...isolators.html http://www.hifisoundconnection.com/S...8040/SFV/30046 Of those which would be best for a second battery for my system? I am capping it a ~$200, so a $220 would be an option but thats at the most. I am mostly considering the HC800, but was wondering if any of the Stinger batteries are better.

hey guys if you could get one of these 2 amps for the same price which would you go with? kicker zx 2500.1 2500 watts birth sheet around 2700 watts us amps md.3d 2000 watts again same price