Amplifiers / Head Units / Processors / Electrical

I'm getting ready to help a friend out with adding an aftermarket sub and amp to her 2008 Ford Edge. She is keepint the stock H/U. She bought a Stinger Line Output Converter (SLOCII). It a two channel LOC and I'm installing it into a Zed Minilith. Now the Minilith requires that all four input channels have RCA connected to get full signal (6db less for each RCA that is not plugged in I believe). The Stinger converter has five connectors 2 each for + - and a ground. I'm installing an Alpine Type S 2+2ohm to the Amp. Here is my question... I cannot just plug in the factory harness to the Stinger unit (It has 2 channels and all I need is one). How do I connect this sucker? …

Im planning on having a 2,000 watt rms amp (hifonics) hooked up in my 95 lexus es300. Im also thinking of a new battery. is optima a better battery than kinetik? or are they two different types of batts? sorry if this is a newbie question...lol.

Hey guys so heres the deal... got a DLS CA31 amp powering my whole system right now... which consists of a pair of DLS R6As for components and a Sound Splinter Rli-10 sub downfired in about .8 cubes sealed.. this is all in a regular cab truck so i was trying to save on space with an all in one amp when i built my system but the amp has been problematic... in the first month it was in a transistor went out... and now bout 10 months later it started hissing at me.. so i sent it back for repair again and half the board was fried... anyways im contemplating getting a new amp depending on how the DLS does when i get it back.. i would like a 3ch unit but my only problem is my s…

ok so i have the audiobahn flame q 12's (yes i know not the greatest but thats what i have to work with till later) ok so i know these say 1100rms but im pretty sure thats over rated but anyways i have them in a ported box right now with about 400 rms i think going to each one but i know they can do more cause they are barely moving....so does anyone know how much they can really handle or whats a good mono block that will push them good just not to the limit????

RE does not sell the 12.1 anymore, I am wondering if they can repair a damaged one. I have a friend who has one that needs minor repairs. Anybody know?

im looking at upgrading my system. im planing on useing 1 bl 12 and was looking at using a hifonics bxi1606d or a bxi2006d. which would be better to power the bl? and what options would i need? or is there another amp around the same price range as the hifonics that would be better to use?

Can someone recommend me a good pioneer headunit? I'm trying to keep it on the cheap side, around 100-130 bucks. It will be used in a '95 suburban and i was also going to be running 2 12" L7s (not sure if that matters). I just want it to sound good and go well with my subs.

what is the best amp for 1200RMS at 1 ohm that is pretty cheap.

I am wanting to put an aftermarket DVD player in my 2004 GMC Sierra 1500 ext cab. I have factory onstar and xm and want to keep both. I know that I have to get an adapter like this http://www.logjamelectronics.com/pacos2.html in order for it to work. What can I get to in order to retain the factory XM radio? I also have settering wheel controls. I know for the steering wheel controls I have to get a PAC unit in order for them to work.

I know there numbers but would like to know,of any personal opinion's which one and why

Okay, So here in a few days I am ordering some Mach5 MAW-15's and I was wondering what Amp would be best to push them...... I have a list of some amps that I "THINK" would work good with them. So tell me what u think. Feel free to inform me of any amps that arent on the list that would be good for the MAW's Kenwood KAC-9103 US Amps XT-2000D Kicker ZX1000.1 Crunch PZi 1000.1 Hifonics BXi 1606D Hifonics ZXi 1006 Kenwood KAC-9152D. ~MadroX

Where did the gain setting tutorial go? I've searched everywhere and can't find it now. Can someone link me to it plz.

OK, so if I don't have it completely backwards, I understand that the higher the preout voltage, the lower the gain can/should be set because the amp doesn't have to be as sensitive of the incoming signal - so the amp can put out full power with the lower gain. My question is since the gain isn't set as high, is the amp drawing less current because of it? Or is it drawing the same amount of current as a signal with a lower preout voltage and higher gain setting? Just curious.

I am going to run 2 Fully Loaded Btl 18" s dual 1ohm coils and I was wondering if anyone had some ideas for an amp or amps to run. electrical is upgraded and I was wanting to atleast give them a true 4k RMS. Also I am wanting to stay under $800. Thanks, Brock

first off is it better to stick w/ the same brand when dealin w/ amps for a system? i plan on purchasing the pioneer premier ts-c720prs comps powered by the zed audio gladius burr brown. i have a 10w7 (for testing purposes) and my friend says if i go w/ the gladius for comps i should get another zed for the sub. so now im thinkin bout doin two ppi art series amps thx in advance

I was deciding on what brand of amp to go with I have cum down to five for my setup. The amps are Directed, Planet Audio, Massive Audio, Concept, and Autotek.

I was deciding on what brand of amp to go with I have cum down to five for my setup. The amps are Directed, Planet Audio, Massive Audio, Concept, and Autotek.

How do I connect my subs to my Amp to Bring it down to 2ohms? The amp rating is 200x4ohms 400x2ohms 800x4ohms Bridging the amp L- R+ brings the amp to 800x4ohms So I was wondering how to do I connect it to bring it down to 400x2ohms. Right now it's connected R+ R- and I don't know if that's 200x4ohms or 400x2ohms. Please help.

So the plan right now is to pick up (2) 12" SSDs for the new car. Originally I was going to power them with a SAZ-1500D and call it a day. Now I have been pondering the idea of powering them with 2 SAE-1000Ds for a little extra juice and a little overhead. I just don't know if the price difference is worth it. So the question is which do you think I should do? I've heard the 1500D is underrated with the right electrical, but will I get more out of this setep with the 2000W? Thanks in advance.

Just out of curiousity, for those that are running batteries in the trunk, how many are running them without some kind of isolator? Are you seeing any issues? For those that are running an isolator, what are you running and where can you find them? What kind would you recommend, if any? I am thinking of running a Yellow Top in the trunk, or possibly a Kinetik. If I went with Kinetik, which battery do you recommend (besides the 2400 which I think would be a little extreme for a daily driver, but maybe not)? Thanks in advance.

One amp produces sound but no matter how loud I turn it up it stays the same.The Other amo turns on but no sound comes through, Anyone know where I can get them fixed.

When most people get external fans to cool their amps off,Where are they often pointing at.

I am looking for the screws that some amplifiers use to screw down wires into the amp channels and power/ground/remote etc. You have to use an allen wrench to tighten/loosen them. I do not know what they are called or where I can get them. I need some because I have 4 missing from my amp. 2 for a channel on the amp and 1 for the power and 1 for the ground. Im sure I can get them somewhere local but I'd like to order in bulk off the internet. So if you know the name of them I would appreciate it if you would share your ungodly wisdom upon me. Thanks in advance ~MadroX

Used Birthsheet 2960rms $375 shipped is the price what do u guys think?

I called a few friends but noone knew, so as soon as I got home, next step was to ask here. I sort of remember some people mentioning some kind of ground loop noise in the system, or had grounding issues with this head unit. Is this true or am I thinking of another Pioneer deck? I ask because I need to get a new deck for the civic to compete and Amanda's old Sony is not going to cut it. And before anyone asks, yes I want eclipse, but I just don't want to lay out that much for a deck right now. Thanks