Amplifiers / Head Units / Processors / Electrical
Discuss Head Units, Amplification, Processors, And All Electrical System Inquiries Here.
5,712 topics in this forum
-
Ok, SOOOO, I'm reallllly baffled and just plain pissed off. Last night i decided to cable tie ALL of my wires, put plastic tuding around all of them, and tie them back. (kinda clean up my wires/install real good before I make my amplifier rack.) So, that's what i was doing last night. Not installing anything...I only unhooked my subwoofer amp...nothing else, i didn't even take apart my dash or anything. That's the pre-face, here's what happened. I was hooking my subwoofer amplifier back up, (don't THINK it had anything to do with this...but it happened at the same time i was hooking the sub amp up.) Keep in mind my car key is IN MY POCKET no where near the ignition and m…
-
0
Reputation Points
- 4 replies
- 1k views
- 1 follower
-
-
I'm going to purchase two 12 inch RL-p soundsplinter subs and need an amp to run them. They will be going in a sealed box. So far I am considering these 3 choices: HiFonics BX 1500 D - $279.00 http://www.onlinecarstereo.com/CarAudio/Pr...ProductID=13121 Orion 1200D (refurbished) - $265.00 http://ikesound.com/product-product_id/2167 Elemental Designs NINe.1 - $275 (b-stock) http://www.edesignaudio.com/nine1_overview.htm The prices are so close that they are not a factor. I have no experience with these amps and looking for a little input or opinions. If you have any other suggestionsin this price range, I'd like to hear them Thanks
-
0
Reputation Points
- 7 replies
- 1.1k views
-
-
Hi, I want to uppgrade my stock system. I need a pair of 6.5" component in front and 2 12" woofers in the rear. My ride is Renault Trafic van. Can someone advise what and which model of the RF family to buy. I believe I also need some amplifiers, capacitor and accessories to go with. Thank you very much
-
0
Reputation Points
- 12 replies
- 1.3k views
- 1 follower
-
-
I'm just curious without the ac converterr, what would happen if I cut the power wire and connected it to the battery, or a 12 volt connection. Would it A. burn up the ps2 B. Not get ebough power C. work just fine. I say B
-
0
Reputation Points
- 4 replies
- 940 views
- 1 follower
-
-
Look at all these Awesome old school items. http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...5738660528&rd=1 And another little tidbit at an awesome price! http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...mMakeTrack=true
-
0
Reputation Points
- 5 replies
- 894 views
- 1 follower
-
-
ok so if i got 2 amps hooked up how should i ground them, so far i got a 1/0 spliced to 2 8 guage wires. its not working very well, should i get another distro block for my gound wires as well?
-
0
Reputation Points
- 6 replies
- 904 views
- 1 follower
-
-
What's the deal with them? When will they be available? Got any specs?
-
0
Reputation Points
- 11 replies
- 1.2k views
-
-
any suggestions? i'd like to not spend more than 120 on it. but i dont' want it to give out on me like my optimus did
-
0
Reputation Points
- 6 replies
- 899 views
-
-
B) http://www.mtx.com/caraudio/products/amplifiers/indexMXA.cfm above is the link to their site, I was wondering who has used or played with them, and are they the step up or the entry level?
-
0
Reputation Points
- 5 replies
- 904 views
-
-
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...bayphotohosting
-
0
Reputation Points
- 3 replies
- 808 views
-
-
I have a punch 2002, what speakers would work best for that amp. Prefer 12's. I already had a pair of wimpy C4's that crapped out in 2 months, and want something different, but affordable.
-
0
Reputation Points
- 4 replies
- 837 views
-
-
I got this HU recently from soneone. The Radio creates music through my RCA's but when I try and play a cd it read the cd and says its playign the cd but viola no signal......And if there is signal its not audable........can someone help here??? J
-
0
Reputation Points
- 0 replies
- 643 views
-
-
will this amp run at 1 ohm daily? http://jbl.com/car/products/product_detail...ser=GTS&cat=AMP i want to get two of them and two brahma's, 1 amp on each brahma. since the brahma is dual 2 ohm, the amp needs to be 1 ohm stable right? will that jbl amp work? thanks for any replies.
-
0
Reputation Points
- 5 replies
- 1.1k views
-
-
How do you measure the actual output of an amp in watts? I remember my friend Aubrey telling me how, but cant find the info again. Im trying to figure out what my 601S Rockford Fosgate Amp puts out. It says 600 rms, and 1800 peak, which is strange for the peak to be so much higher, but anyways I've also heard that RF underrates their amps substantially like Kicker does. So my question again is how do I measure the power an amp puts out?
-
0
Reputation Points
- 6 replies
- 1k views
-
-
i'm curious as to weather this amp would be safe to run at in a one ohm setup. the seller... of course says it is. but i'm not to sure
-
0
Reputation Points
- 7 replies
- 1.4k views
-
-
Looking for an amp to power my soon-to-come SS RL-p12. I found a Digital Audio amp that didn't look too bad. Just wondering if anyone has/had any experience with them. The key thing here is I also need a two channel (75 x 2 - 100 x 2) that matches. (I found a 75 x 2 Digital Audio also.) I am also leaning towards the Directed 750d and 300/2.
-
0
Reputation Points
- 6 replies
- 1.3k views
-
-
holy crap they are making a monster too http://www.kicker.com/ShowPage.cfm?filenam...tml&menu=KXAMPS
-
0
Reputation Points
- 7 replies
- 1.1k views
-
-
Do any of you guys follow the same routine over and over again when installing an amp? In what order do you plug in the wires? Detail always helps. eg: 1. Tear vehicle apart. 2. Run all wires. 3. Disconnect negative, then positive at battery. 4. Connect ground wire to amp. 5. Connect ground wire to frame. 6. Connect remote wire to amp. 7. Connect remote wire to HU. 8. Connect RCA to amp. 9. Connect RCA to HU. 10. Connect power wire to amp. 11. Connect negative to battery. 12. Connect positive amp wire and positive to battery. 13. Insert fuse. Just trying to generate some action here. - Steve
-
0
Reputation Points
- 8 replies
- 1.2k views
- 1 follower
-
-
My audiobahn 18001DT amp isnt getting enough power out of my car a 2000 Mazda Millenia S. The stock alternator is putting out 110 amps the amp is drawing 150 amps to put out 1800 watts to 2 12" audiobahn ultra excursion subs. I have upgraded the battery to a optima red top and have installed 2 1 farad caps. When i have the car running the amp recieves 13.5-14 volts when i have the bass turned all the way down. When i turn the bass up half way the voltage drops within 5 minutes to 11.5. I currently have 4 ga wire planning on upgrading to 0 ga to stop some of the voltage loss cause im running the wire 20 feet. should i upgrade the alternator or put more caps or a battery? a…
-
0
Reputation Points
- 2 replies
- 973 views
-
-
Alright guys I need your help, Ill most likely be getting either an sx 10 or 12 and i need suggestions for an amp that i could use to power one of these beasts. Ill be honest, Im poor lol so the cheaper the better! Thanks Tom
-
0
Reputation Points
- 8 replies
- 1.2k views
-
-
I need some help guys/gals. I will most likely be running a set of Focal 165K2P comps and a 12" ED kv.2 sub from Elemental Designs. The sub can handle anywhere from 400-900 watts and the 165k2p's are a 200W max speaker although i have been told they can handle every bit of 200W if done correctly. I would like to buy one nice amp to power both the comps and the sub. the first amp i have found that is capable and in my price range is the SoundStream TR800.5. its a 5 channel amp that does 200x2, 400x1 in bridged mode. Amp specs found here>>> http://shop.store.yahoo.com/discave/trsost5chcar.html This seems like the perfect amount of power for the comps and the sub. I…
-
0
Reputation Points
- 2 replies
- 1.2k views
-
-
I am looking for a small amp (literally) for my wifes van power a Koda 8" at 4 ohms. Looking to have roughly 200 RMS. Here are my choices so far Arc Audio 2050 CXL Planet Audio BB50.2 Anyones tried any of these series? I am leaning toward the Arc just because I have always wanted to try one, and I think they are one of the most beautiful amps out there. Anyone have any other suggestions. Here are my specs 1. Must have a crossover (most do, just thought I would add that fact though) 2. Roughly 200 RMS into 4 ohms 3. Size restrictions Length - 9.5" Width - 8" Height - 3" If it wasn't for the damn size restrictions a lot of amps would work, but as always, I have to …
-
0
Reputation Points
- 2 replies
- 949 views
-
-
i wonder if it will be ok with a 1.3 ohm load... a friend wants me to put three single 4 pr12's in his x-cab ranger, he already has the mtx....so what do ya think?? 1.3 close enuff to 2 ohm to be alright?? wheeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee
-
0
Reputation Points
- 7 replies
- 1.2k views
- 1 follower
-
-
Well I have a kicker 500Si and it ran into a problem when I got it. I hooked it up and it would go into protection mode after 5 seconds. I sent it in to kicker after asking them on the phone if it could be fixed and after two weeks they emailed me back and said that they could not fix it. I know they could because anyone that's can fix amps can fix mine. Well I want to know if any of you guys may know how to fix this amp. The man I was going to go through just retired. I also have a kicker 40ss that has the same problem. Any help would be great. Kicker rocks!!! B)
-
0
Reputation Points
- 1 reply
- 2.2k views
-
-
I am thinking about getting a Sound Stream Xstream 480.2 and 360.2. I know that some of the older Sound Stream amps were really good. But is this like other "ghood back in the day" companies or do they still make strong products?
-
0
Reputation Points
- 1 reply
- 779 views
-
Who's Online (See full list)
- There are no registered users currently online