Subwoofers / Speakers

i dont understand with ports some ppl say that you always put your ports on the same side as your subwoofers. looking around on forums i see ports being put on all different side what is the best way. does it even matter i have a van and i want to put the subwoofers facing the front of the car and van the ports facing the tailgate what is best

I was drinking my coffee at the local install shop when I noticed this 10" woofer install in a Ford F150 this is with out a shadow of a doubt the worst sub install I have EVER seen if you can top it show the pics...LOL..

i was searching ebay looking at what was out there and came across these link lanzar is not a company i would normally even look at but these look like a solid daily pounder for cheap anyone have any exsperience with them

If i were to get two 12 ixls and push them with a sundown 1200d, would they be louder than if i were to just purchase one and put the full 1200 watts to it? Also this may be a dumb question but a friend of mine's dad is gonna build me a box, and if i were to make 1 cut out on one side, later on could i add another cut out to the other side? Its gonna be a sealed box but i was wondering if that would mess the frequencies up and stuff. thanks

Hey wussup Guys, Can sumone tell me what would be the best way to power up and wire these subs together. I'm just about done making a fiberglass enclosure for them.its all one chamber. Should i use one amp two etc. The 3 subs are dvc 15" fosgate 2 ohm 250 rms P2d215 .After the box i will be making a panel on the door for one 8" sub and an 6-3/4 component set along with two component sets in the rear. Help me understand the science of installation. i want to blueprint the install but dont really know where to start. thanks

Im so happy my Oz Audio matrix elite 15" arrived yesterday I just thought id post some pics. I can't wait to see what this sub can do, ive heard nothing but good things about Oz. Im in the process of building the box as well and ill post some pics once i get further along with it

my friend is wanting to get a new sub and doesnt wanna spend alot of money probably no more than 150 on the sub and it needs to be around 600 watts rms. the sub will be more for sq than anything i found this one but not sure about it. http://www.sonicelectronix.com/item_13201_...dio+KMX-10.html if yall have any ideas to throw out there go ahead let me know and it needs to be a ten inch. thanks

Ive posted about this subwoofer on a few other forums, well it took me a couple weeks to even get the guy to tell me the shipping and send me a paypal invoice, well he said the subwoofer was $250 for 1 Oz audio 15" ME15.2 ......which is a good price, but hes trying to charge me $55 to ship that seems to high to me even if he is insuring it and using their packaging...the reason is, is i just shipped 2 RE SE 15's UPS ground to a guy in the same state where he lives and it was only $38 dollars....and he is using UPS ground too. The subwoofer is brand new, but i saw them go for $200 new shipped on here before....i realize they used to sale for over $300 normally easily and …

im planing on putting 2 icon 15's in the back of my explorer... what kinda mids and highs would i need to keep up with the bass? i've only done like small setups before so im not sure what kinda speakers i need, i dont have much of a price range, just wanna make sure my money is spent well and not something crappy. i wanna run them to a sundown 100.4. and suggestions? (btw all the door speakers are 6x8's) thank you for the help

I just recently bought a Sundown Audio SAE-1200D, and I was going to buy a pair of JL 12w3v3-2 subwoofers and wire them in parallel to get an impedance of 1 Ohm. Now I have heard that the SAE-1200D is underrated and I was wondering what SVC 2 Ohm subwoofer could handle the full power of the amp. The main prolem of this whole thing is that I already paid the money for the box and if possible, I would like to use it. The box is a dual 12 inch ported enclosure with a shared chamber and one terminal cup for each subwoofer (If that even matters). Im also not looking to pay over 300 dollars for the pair of subs. (Which shouldn't be hard becuase the 12w3s that I was going to buy…

i have rockford fosgate phase one 12 inch subwoofers 8 of them in a 16 cub ft box im trying to get them to hit low and hard they do hit very hard and loud!! but when the songs go to the low bass it drops out they are ported 6 ports 4inch by 3inch deep the ports are all on the front side with the subwoofers thats what rockford gave to me they say that will tunes them to 37hz but it sounds like they are tuned to high and out put around the 50hz and lower drops off and i dont get that lower end that shakes the car and flexs the car just trying to get my point across on what kind bass looking for please help me

I will be running them of the 3 & 4th channel of my sundown 50.4. I havent a clue right now how to hook them up Thanks for any help Specifications: *Power handling: 70 watts RMS/110 watts max *VCdia: 1" *Le: 0.53 mH *Impedance: 4 ohms *Re: 2.9 ohms *Frequency response: 48-20,000 Hz *Fs: 48 Hz *SPL: 86 dB 1W/1m *Vas: 0.64 cu. ft. *Qms: 2.63 *Qes: 0.85 *Qts: 0.64 *Xmax: 2.5 mm *Tweeter crossover: 10 kHz @ 6 dB/octave *Dimensions: A: 6-1/2", B: 5-3/4", C: 3-

So I got laid off and decided to do a very budget center console sub build for my dodge ram qc. Just looking for opinions, good or bad on the following Phoenix gold rsd memphis pr jbl gt5 alpine type s Also open to suggestions in the $50 - $100/sub range. This is kind of a challenge to see what I can come up with on limited funds, not expecting any miracles. Haven't decided single or multiple sub set up yet, I am sure single would be the popular vote, though not as fun I listen to mostly hip hop, so ported is preferred, but not that big of a deal. The amp will be bought after subs are selected. Any other info needed let me know Thanks for reading Chad

Hey guys i just started looking at DC today and i rele like what i see about them so far. I just wanna know how they compare with the BTLs? It would be (4) 18s walled with (4) saz-3500 on them in a 03 Yukon Denali. I want it for a daily ground pounder... Witch one will be better for what i want to do? Thanks Shane

I know that too small a port area will lead to port noise, but what happens if you have excessive port area? For example 20 sq inches per cubic ft of volume? I know many manufactures recommend 12-16 inches per cubic foot of volume, but is there a downside to going over this?

So I wanted to ask some questions about XCON's. How much wattage can these things handle? I'm looking at buying two 12 inch XCON's for my second sound system ever. Last one was stolen, but since then I have a viper alarm and a bunch of other safety stuff. But anyways, I just wanted to know a little more about them since on the website it doesn't really say how much they can handle. Also, one of the package deals on the website for a 12 XCON with a Sundown amp, is the XCON a 1 ohm or 2 ohm sub in that combo? And can that amp power two of the XCON's? Or would it need to of those amps? I would greatly appreciate these being answered.

im very interested in getting an LI 12'' in a sealed box but i dont know what amp would be a good match for it. i will be using as a daily driver im getting the knu 4 guage wire kit. budget around 200 there are tons of amps on ebay,just need help deciding. thanks

Add mad DEEBEEZ with a Funky Pup Dust Cap! That's right folks, now's your chance to break the sound barrier and your eardrums. You too can shake the ground you walk on simply by purchasing a pair of the authentic Funky Pup Dust Caps. Impress girls, get back at law officials and show those North Koreans what we are really made of! All it takes is one set of Funky Pup Dust Caps to achieve truly seismic events! Available for 10", 12" and 15" drivers. Follow the link below to officially own a piece of e-history! Funky Pup

Up until recently Ive been thinking about going with a single 12" BL, SX, LVL4 XL, or BTL. But now after talking to Rusty, Im thinking anout going with 2 10s instead. Im still currently in the planning stage and i wanted some imput on what to do. Ill have roughly 2.5ft?^3 to work with under my back seat after I lift it 2 inches. I mainly listen to rap, and my goals are to get loud and low. ill currently do not have an amp, but ill be matching the amp to the sub/s.

I want to upgrade my midbass and highs. I am not sure what to look for with this. I just want something more clear than what i have now. I plan on getting a 100.4 or 50.4 or 125.2. One of those sundown amp. I was looking at the infiniti kappas, I know someone around here that might sell me some really cheap, I guess i just need some input on what to look for when buying a set.

hi guys. i just want to share some installs that we have made here in the philippines. "Proud Member of Team Projekt AI" PART I (sometime May 2008) The System Head Unit: Pioneer DEH-P80RS Separates: Focal POLYGLASS V1 165V1 Rear Fills: Focal ACCESS 165CA1 Subwoofers: Digital Designs 3515e (2) Amplifier for Separates and Rear Fill: Rockford Fosgate T15004 Amplifier for Subwoofers: Massive Audio P3000.1d Mono Amp Rear Extra Battery: Kinetic hc2400 Installer: Projekt AI

2 level 4 xl 18s to go in the avalanche im getting tomorrow :bigclap: :bigclap: :bigclap: :bigclap: More pics when i take em.

Which one would hit harder The hdc3 is 370 shipped and the btl would be around 450 fully loaded. I want a hard hitting system but I don't have much space I drive a 2000 accord coupe. So what do you guys think I should get.

Got a phoenix gold titanium 1000.2 and wondering what i should get a 15 bl daily driver @ 1 ohm or a 15 Q? itll be in a 93 civic in a 32 cu.

i have a 94 caprice wagon and had purchased infinity693.7i 6x9's for the rear. they work fine up until i actually go to screw them in. they actually seem to be grounding themselves out on the bracket where the speaker goes. i checked all the wires and nothing is wrong as far as i can tell. i think it may just be a defective speaker. any input/help would be greatly appreciated.