Subwoofers / Speakers
Discuss Subwoofers And All Aspects Of Speakers here.
6,865 topics in this forum
-
We're fast approching December when I can "officially" modify my Rav4 that I share with my girlfriend. The big thing is that everything must fit in a storage well under the floor in the cargo area. Yeah, I've shown this before: And heres a side view of my box: http://www.mustangmods.com/ims/u/474/572/179813.jpg Basically the sub will fire upwards. And in order for the Mag to fit in there, there is only going to be 1 1/2" from the top of the box to the underside of the floor when I close it up. I measured from the bottom of the gasket to the top of the surround, and it's a little less then 1". I also tried measuring how far the surround shoots out when it's moving. …
-
0
Reputation Points
- 5 replies
- 1.4k views
-
-
My gf just bought a car and I'm helping her set up a system in it. I have an enclosure for a 15 that is 3.5 cubes tuned to 34hz. Would that be ok for a Level 2 15 being powered by about 500 - 600 watts?
-
0
Reputation Points
- 11 replies
- 1.4k views
-
-
I've asked this a few other places and have not gotten much help at all. One day I'll learn. Anyway, I drive a small SUV. I absolutely love my Dcon, but the box just takes up too much space. I do plan on trying it sealed, hopefully in the next few weeks, but I kind of want to try something else this summer, just to play around. My budget will be around $200 or less. I've been looking at running three 8's, a single 10" or 12", or a pair of small box 10's. Not having much luck with the last one, except for the Fi X, but a pair would be a little over my budget. I currently have an RF Prime 500.1, but I'm not opposed to getting a new amp in the future (I'd like to k…
-
0
Reputation Points
- 12 replies
- 1.4k views
-
-
How are these subs for everyday use, the DD 9512.
-
1
Reputation Points
- 4 replies
- 1.4k views
-
-
Hey guys, I want to rebuild my 1803s with 5 or more spiders... be it very loose or very tight spiders to kryptonitewhite-proof them. When I replaced the AP30001D something amazing happened... the van started playing as it was supposed to. Most incredible amzing low end output. Air movement that no one would believe unless they actually sat in it, but if you did, rear-end leakage was destined to occure. My family and I had a blast for 2 days, so many looks of aw and amazement and sometimes fear when suddenly things would be recorded louder and lower. Looks of "is the van going to explode? Are we going to die?" Then, as it just always has to happen, there was a quiet song.…
-
2
Reputation Points
- 9 replies
- 1.4k views
-
-
I'm toying with a few change ides for my system. My sig is what I am running currently. My two 12's are in ~1cu ft boxes, sealed. Due to space constraints, I cannot go much above that, ported or sealed. I've always been a fan of sealed enclosures for their sound quality and ability to get low. However, I am also a spl (""SQL"" really) junkie, and need more volume. I'm looking at the RL-p 12, ICON 12, and Fi Q12. Goals: fit may car, sound great, get low, and get loud. Power will be through, either, my 1000x (which meters at ~600 rms/ch @2ohms with a 50Hz sine wave), or an equivilent US Amps (depending on another issue I am having). Givin this info, and t…
-
0
Reputation Points
- 10 replies
- 1.4k views
-
-
between these three subs... which would u do? two of these infinity's? these two alpines? these two diamonds? remember, these are going into my wife's car, now going to be pushed by this hifonics amp lemme know....btw due to price (staying under $300 shipped, her budget, not mine) these are the only choices unless u know of a pair of 10's brand new, either svc 2 ohm or dvc 4 ohm that can handle 375 wrms a piece, and will ship the pair for under $300...then those are my only choices.. btw, i'm starting to go infinity(love the look), diamond, then the alpine later.. wheeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee
-
0
Reputation Points
- 9 replies
- 1.4k views
-
-
as the title states. i like how the xxx sounds, it gets loud, but im thinkin...maybe a 12" mt on 2500w....behind the seats, i can get like 2.7 cubes ported, should be enough for 1 12" mt right? and weight, the 05xxx is like maybe what, 10 lbs less than a 12" mt? i know the xxx has better SQ, etc. but i would probably like either one, i like just straight up loud bass. heres the xxx on a power acoutik a2400db
-
0
Reputation Points
- 15 replies
- 1.4k views
-
-
Stuck between the two. I like the e12a.22 option because of the displacement/$ value - it's adding another driver at under $200 vs. spending the $400+ for a new LMT. Leaves me with cash left over. But if there's something really special about the new SS offering that dual underhung drivers with 50+mm of Xmax combined can't touch...I'll fork over the cash. Just interested in your opinions. Supa, I know what you're going to say Figured I'd post on here because it'll stay up longer and I'll get more intelligent responses.
-
0
Reputation Points
- 13 replies
- 1.4k views
-
-
-
Im goin to be buying some 10s soon and I was wanting to know what the difference in the 10 inch FI Q and the 10 inch ICONs are? Im looking for a sub that will sound clean and drop low while being loud aswell. I was goin for the AQ HDC3 10 subs at first but I am wanting to meet my expectations running only 2200 rms watts. Not to mention also sounding clean. I know the FI Q and the ICONs are known for their good sq but which one will get louder off 1k rms to each sub?
-
0
Reputation Points
- 14 replies
- 1.4k views
-
-
Hi, I'm new to this forum, and fairly new to car audio. I happened upon this site a few days ago and saw the MAW-15's, and have read some reviews on them. I'm pretty sure I want to buy them, but I would like some input on them, first. I've been thinking about buying an IDQ15 for awhile. But, if I can pick up a sub for 1/3 of the price that sounds as good(or damn near close to it), then it's a no-brainer. I'm willing to go up to $300 for a sub. That doesn't mean, though, that I necessarily want to spend that much. I'm figuring on 500-600 wrms, and I don't want to go over 2.5 cu. ft. For the most part I'm looking for SQ. Keep in mind I'm not trying to do a competi…
-
0
Reputation Points
- 11 replies
- 1.4k views
-
-
setup will be going in a 97 explorer ran off of a single american bass 500.1 @ 1 ohm...1250 watts per woofer. Objective....loud as chit, uncomfortable, cant breath, cant see, daily driving setup to demo at shows. Option A Sub up port back 10.62 cubes after all displacements 3 6" aeros @ 20 inches long each 30 hz tuning Option B Sub up port back 10.35 cubes after all displacements 4 6" aeros @ 20 inches long each 35 hz tuning I think option A will work very well but 30 hz tuning might miss a lot of songs apart from bass mekanik and the odd really low rap song. Any thoughts? thanks
-
0
Reputation Points
- 2 replies
- 1.4k views
-
-
-
My dad is looking for a good sub for the boat. It will be in a cutout in the inner hull in the cabin area, so it will need to perform well in IB. I'm not too sure of the amount of moisture it will be exposed to, and I'm not sure if any of the actual marine subs will perform in IB. Any suggestions?
-
1
Reputation Points
- 13 replies
- 1.4k views
-
-
I have two 12" JL w6v2 subs. I dont have an amp powerfull enough to power them anymore, so I'm going to run with a single sub for a while. I'm want to build a new enclosure for it... it will either be a sono tube or a fiberglass enclosure. I'm just wondering what some of you JL owners are running a single w6v2 in?? I know JL has some specs on their site for "suggested" enclosures. I've made their slot port before... but I sold it when I upgraded to two subs... and to be honest, I dont think its the best it could have been. I would like to go ported, will most likely used a round port. What are specs you guys using for your jl?? Any and all help is needed. I certai…
-
0
Reputation Points
- 8 replies
- 1.4k views
-
-
I'm not planning on getting any (way too much for my needs) but has anyone dealt with splc subwoofers? They seem pretty legit. Just wondering if anyone has first hand experience with them. I see a craigslist posting for two splc neo 10" subs almost every other day(along with a stetson 7k and some battery's) for $2000. Either way, who has dealt with these bad boys and has videos?
-
0
Reputation Points
- 0 replies
- 1.4k views
-
-
I'm wanting to go active with front stage. I've been shopping around Seas, Peerless, Aura, etc, and was wondering if anyonce has used the mli-65 midbasses-midrange in a IB door install. If so, looking for opinions on their performance compared to the other offerings mentioned above. Note: tweeters have been decided on either.
-
0
Reputation Points
- 3 replies
- 1.4k views
-
-
I decided to take pictures of my sub with the original claws. I am hoping to get this thing inverted here soon. Either way here they are for you all to enjoy.
-
0
Reputation Points
- 7 replies
- 1.4k views
-
-
So ive got the Fi 15 right now, and adding a sundown 1500D and an extra battery in the trunk this weekend.... But i was looking around on the for sale/wanted... and saw someone has a fi 18....and made me want to go louder before i even got my new amp in! So do you guys think i should stick with the 15 or go with the 18.... Its the 04 Lexus IS300 which are pretty small cars, and i dont want to rattle the thing apart since i just got it ... just so confused! what do yall think?
-
0
Reputation Points
- 11 replies
- 1.4k views
-
-
My cousin is telling me of some subs he is trying to get rid of. He dosent have any pictures of them but all he says is that they are competition subs and they have a red C on the cone. Now whether or not they are competition is totally speculation. But I just wanted to know which sub company uses a red "C" for their logo on subs? Thanks in advance ~MadroX
-
0
Reputation Points
- 7 replies
- 1.4k views
-
-
What is the consensus on usability of the volume of air behind the red panel ? This a box for an RE SE 15, that should go in a 2000 Mitsubishi Galant, very weird trunk and it's a 2-piece box. Box height is not enough at this point but I can get it 1/2" taller, which should be good to go.
-
0
Reputation Points
- 12 replies
- 1.4k views
-
-
Ive got 2 15'' d2's and about 7 cubes to work with if that. Should I port it or just go ahead and seal it off? Im running a jbl 1200.1 to them and its in a hatchback. I want all the spl I can get.
-
0
Reputation Points
- 9 replies
- 1.4k views
-
-
I found a deal on a 12" TREO SSX and to be honest the best system I've ever heard was a TREO sub, which model I'm not sure. I was looking at 2 AA Avalanche 15's (old model) and I know that would pound and sound amazing, only problem is they are both dual 2 ohm and not only that the box would be much bigger. With the SSX recommending 2.25 cu ft tuned to 31.8hz would it do well playing low? Obviously it wouldnt be 2 AA avalanche 15's but what kind of performance could I expect from a 12 of this caliber? I'm gettin excited here Can't wait till I finally decide on something.
-
2
Reputation Points
- 12 replies
- 1.4k views
-
-
I would like to find a good selection of tweeters to pair with my MCintosh 630's https://www.ebay.com/itm/MSS630-McIntosh-COMPONENT-SPEAKERS-TWEETERS-MIDS-X-OVERS-GREAT-CLEAR-SOUND-NEW-/130617525735 and Audison bit1. I am also looking for a 100X4 amp that sounds clean. This has to fit in my 1990 Lotus esprit. The plan is and is going along. To finsh building my custom doors that house tweeters near the handles and midbass by the knees. The midbass will have boxes of around 4L-6L of capacity and be ported. Then when the speakers are built I plan on adding in a 4x100 amp for the front connected to the bit1 and having that connected to a CD or better quality audio so…
-
0
Reputation Points
- 3 replies
- 1.4k views
-
Who's Online (See full list)
- There are no registered users currently online