Subwoofers / Speakers
Discuss Subwoofers And All Aspects Of Speakers here.
6,865 topics in this forum
-
How do the Axis 15" stack up to the 15" BTL in terms of SPL running off a SAZ-3000? I never heard any of Audiopulse or any TC Sounds products I'm just curious and I know the BTL beats pretty hard.
-
0
Reputation Points
- 3 replies
- 1.3k views
-
-
Hey Mark, I still haven't used my SPL-12s that you sold me about a year or more ago. Haha. I remember you mentioning something about the SPL-12s popping the dustcap off when they are pushed? You said drill holes in the dust cap, I can do that carefully, but is there a specific pattern or anything like that? I want to make it look neat, not look like somebody attacked my subs with a drill, haha. I'm not sure how far I'm going to push these, this is just for reference.
-
0
Reputation Points
- 2 replies
- 1.3k views
-
-
I have been shopping a bunch of different subs to upgrade to. I have locked my budget to 450 MAX. I have been looking at 4 12" type r's. Just recently, I got more interested in 2 15 type r's. Now I am between the 2 15 type r's and an aa havoc 18. I will be running small sealed- 4 cu ft. right now, probably get another cube with a few mods to my box. I have 4 10" mtx thunder 5500 at this time, and I listen to mostly rock/metal, 70's,80's and a lot of Pink Floyd. I want: 1) better low freq extension, 2) keep the tightness that I have right now 3)more spl. I have an saz1500d for power. Any honest opinions/recommendations plz? Pricing: 4 12 type r: 440 shipped 2 15 type r:41…
-
0
Reputation Points
- 14 replies
- 1.3k views
-
-
As most of you know I unloaded my xcons below tuning and did some damage. Only one had visible damage and I corrected that with some devcon epoxy. Now that they are both back in and playing my wife and I both agree that they have lost output. Is this possible? Could I have done enough non visible damage to the soft parts that they would lose noticeable output? I assumed they might be a little sloppy now from stressing the spiders, but to lose output? Thanks in advance.
-
1
Reputation Points
- 11 replies
- 1.3k views
-
-
I am getting a new 2001 mustang soon and looking into a new system to put in it. I measured and the largest box i could possibly fit into the trunk is 15x28x38. Somewhere suggested 2 SDC2.512-D4 and a AQ1200D which would run me a little under 600.I would like to be able to hit lows pretty good if possible. I was just wondering if this would work or if there is anything else that would be a better fit. Any suggestions would be greatly appreciated.
-
0
Reputation Points
- 15 replies
- 1.3k views
-
-
im looking for 2 12s or 1 15 that will handle 1500 rms daily
-
1
Reputation Points
- 16 replies
- 1.3k views
-
-
So how about it Mach 5? Why not take the current IXL motor structure from the 10 and 12 and use it to make an 8 inch version? I think it would be awesome and if priced as the IXL 10 and 12 they would be very competitive... I'd order a few, with the same motor as the 10 it would be one very very beefy sub :bigclap: It seems these days more and more are looking to drivers in a smaller size which can be seen in Soundsplinters sucess with their 8. Mach 5 should cptialise on this market Anyway... PLEASE
-
0
Reputation Points
- 10 replies
- 1.3k views
-
-
I recently bought a 2000 s10 from my grandma. It was my grandpa's truck who passed away over a year ago. It has less then 40K miles on it and hadn't been driven more then 200 miles in the last 4 years. Anyways, I've been thinking about a new system for it. I pictured in my head that it would be cool to build a shelving unit above the sub box in the back of the s10 (extended cab with 3rd door). Would include two open bins on either side of truck, with open space in between with metal rack to bungie to. Not sure if you can picture that but I think it would be useful. I've narrowed it down to using woofers no bigger then 10", due to height. Currently I have a 12" xcon…
-
0
Reputation Points
- 7 replies
- 1.3k views
-
-
Im going to replace the stockers in the womans jeep commander. shes got 6x9's front doors and 3.5 in dash and 6.5 rears. going to do minimum of 6x9's So im pretty set on Morels. im liking the pricing on the Maximos Maximo Any experience or reviews of these or this line up from Morel? or Morel co ax in general All speakers to be run off stock head unit, No amp for the time being maybe one later
-
0
Reputation Points
- 1 reply
- 1.3k views
-
-
hey iv had my dcon 12 in a sealed box that is a little too small for it, and im now looking for a ported box that is big enough to get the job done. i want loudness. im trying to stay cheap as possible, limited on money. its in a 94 blazer pointed back right now. i found a ported box on ebay http://www.ebay.com/itm/2-0-FT-3-TUNED-32Hz-SLOT-VENTED-CUSTOM-MDF-BOX-ENCLOSURE-for-12-INCH-SUBWOOFER-/400334071728?pt=US_Speaker_Sub_Enclosures&hash=item5d35c527b0 how is that?
-
2
Reputation Points
- 7 replies
- 1.3k views
-
-
Im looking at both of these setups to be ran as a daily driver setup in my second car .... both can be had for about the same price and require the same power ... what do u guys think? both have good reveiws, work well in all types of setups ... im looking to put either one in a 4.5 cu ft box .. tuned to 32hz ... ish depending on what i wanna do with the application .. just looking for some input .. thanks guys
-
0
Reputation Points
- 7 replies
- 1.3k views
-
-
What are a good 6.5 mid by SEAS and where can i purchase SEA's in general?
-
0
Reputation Points
- 13 replies
- 1.3k views
-
-
Hi, people! I've been sending some e-mails to SI lately, but have been getting zero response because I get a delivery failure notification. If somebody can tell me how to reach these guys, I'd be very thankful. The subject is getting a SI Magnum D2 15" sent to me in Norway, and possibly getting myself a dealer status if it's possible. Norway needs some better equipment than Pyle/Boss/Sony/MTX etc... By the way - just out of curiousity - which is better: The Stereo Integrity D2 15", or the SoundSplinter RL-p 15". The RL-p's cost less than half, but seems quite good after what I've heard. Is the SPL and SQ comparable between these two, and what about the durability? In my …
-
0
Reputation Points
- 10 replies
- 1.3k views
-
-
..iam interested into Kicker solo-baric L7 15" ...i will be usin a 1800Wrms amp ..and i thought.. a 5cube box at 36Hz.. ...what do u guys think about this SUB ...(can it handle 1500W,whats with the build quality and this is not SQ sub-right?)
-
0
Reputation Points
- 4 replies
- 1.3k views
-
-
I'm looking for a decent sub that i could possibly find on the internet for cheap with no warranty or anything. This sub is temporary so i'm not concerned about the sub blowing in a short amount of time; i just need it to last until this summer. I'm concidering buying 2 kicker cvr 12's...they are like $80 a piece...does anyone know of a sub that would be better around the same price range maybe $20-$50 more expensive btw i have a box that is like 2.5 cubic feet per chamber and the port is tuned to 33 hz according to an online tuning calculator
-
1
Reputation Points
- 9 replies
- 1.3k views
-
-
im getting 2-15pbx and going to power it with a optidrive2000d amp (2000w x 1 @.5 ohm).... id like a 70/30 (SPL/SQ) spit, so if anybody has used a setup like this please tell me what you thought of the sound and loudnest of the sub....
-
0
Reputation Points
- 10 replies
- 1.3k views
-
-
So I bought 2 15" polk/momo subs off crutchfield (way before I found this site) and they rock my Geo very well. The other morning on the way to work (my beautiful biweekly commute from Sac to Fresno, Ca on the nasty smelling 99) bumping as usual, I smelled something funny besides the highway and quickly realized it was the subs. I know I had too much power going to them ( Hifonics BXI2006) from the start but used it anyway. So before I could turn it down the subs shut off...then the smoke started coming from the port holes and I thought the box was going to start on fire driving down the road! So today I pulled the speakers out to expecting to find something fried but..…
-
2
Reputation Points
- 11 replies
- 1.3k views
-
-
I know its a noob question but: I have a single 12" Fi BL 12 in a 2.5 ft^3 box tuned to around 33 hz or so. Its dual 2 ohm wired to 1 ohm on a SAZ-1500D. I am wondering what 2 of the Skar 12s or 10s in the optimal box would be like in comparison. I know that based on cone area alone, it should be louder. My Fi is so much beefier though. My current box is sealed to the passthrough with port and sub firing into the cabin when the seats are down. Any new box would be the same configuration.
-
0
Reputation Points
- 11 replies
- 1.3k views
-
-
so i have a trailblazer. im looking for a 15 0r 18 inch sub that will be mainly used for rap. enclosure size is not much of an issue. my limit is about $500 for the sub. i need more of an spl sub for a daily driver. any suggestions would be appreciated. thanks ahead ps. please spell out the brands, i have no idea what the initials stand for. thanks
-
0
Reputation Points
- 9 replies
- 1.3k views
-
-
I want to put some bass blockers on my speakers until I can upgrade to a set of components. Which one of these would be best to get? http://www.parts-express.com/wizards/searchResults.cfm?FTR=Bass+Stopper&search_type=main&WebPage_ID=3&searchFilter=Bass+Stopper
-
0
Reputation Points
- 7 replies
- 1.3k views
-
-
i loled watch it all. the finale is awesome
-
0
Reputation Points
- 9 replies
- 1.3k views
-
-
I'm sure I won't be dissapointed with the new one, but if the claw is in perfect working condition and I sold it for a new one, how big of a differance is there? I would rather send in the claw and get it a face lift with all new SID2 parts, but I'm sure that would cost consideralbly more that a new one and more than I got. I'm also considering it just to get something new. I tried an avalanche, did not compare, type r (just cause) sounded good, but not a mag. But in order to get a new SID2, the claw would have to be sold. Hmmmm what to do.......
-
0
Reputation Points
- 10 replies
- 1.3k views
-
-
To start off with, I have a 2000 Silverado ext.cab with RF 400.4 on mids/highs. Diamond Audio m361 components in the front doors and m341 components in the ream so I have quality mids/highs to hang with the subs I choose. I want to go with 2 12" subs in a 1.15cub ft box per sub(sealed). I will be running a RF BD1500.1 on the subs, at 13.8volts it puts out 1,627watts @ 2ohms. I was dead set on the IA Lethal Injection's, but I wanted to know what was everyone's impression of the FI Q. How does it compare to the LI in the air space I have and what are the pros and cons of each? I know the LI's come fully loaded, but you have to pay for the extras in the FI Q. I want s…
-
0
Reputation Points
- 3 replies
- 1.3k views
-
-
http://our6thplanet.com/garage.php?mode=vi...amp;image_id=92 Nothing much to look at, just 5.5" ID sonotube, 10" long. Should give me a 40hz tuning frequency for each sub. It feels louder, and there's another SPL comp on the May 6th weekend, so hopefully I'll be able to meter it then
-
0
Reputation Points
- 8 replies
- 1.3k views
-
-
hello, just needs some inputs on the best possible tweeter + mid for $500 or less. also intallation will be pillars/dash @What music do i prefer? music would be all kinds, simply depends on my mood. rap, rock, lovesongs etc. @What sound do i prefer? something smooth, detailed, with an airy treble, something that you could hardly tell that theres a speaker when position properly. neutral to warm side of things. @Do i have a midwoofer? yes, i have already, but still thinking of a mid that can go down to 150-200hz
-
0
Reputation Points
- 5 replies
- 1.3k views
-
Who's Online (See full list)
- There are no registered users currently online