Subwoofers / Speakers

Ok Im looking on getting my amp for my door speakers.. I only listen to rap and NOTHING else.. I plan on using the Mach 5 Audio MLI-65 They say they are 100 rms at 4 ohm? Now the question is, Cud I wire them up into 2 ohm and just use a two channel amp ran at 2 ohms? Or shud I just buy the four channel amp and run them at 4 ohms? My amp choices that im stickign with are.. Rockford Fosgate T4004 Does 50 x 4 @ 4 ohms and its under rated.. Or.. Rockford Fosgate T3002 Does 100 x 2 @ 2 ohms and its under rated.. Not sure which to choose.. And are those Mach 5 Audio speakers straight speakers to run? And other suggestions im open to but Im sticking to Rockford Fosgate for the …

Can I get any information on picking up DC sound as a line in my shop? pm me please or post here.

i am kind of a newbie and i was think of getting an 18 ssd fully load with a 1800 watt kenwood amp wired to 1 ohm @ roughly 1000 watts RMS. in a 6 cu. Ft. box tuned to 26 hz. do you think it would be louder then 3 cheap 12's

I currently have a Polk Audio SR 124 SVC 12" subwoofer. It is not particularly loud but sounds great. I am more concerned about SQ. I plan to redesign my trunk and would like to go with 2 or 3 10's. I plan on a false floor construction in my 2003 Mustang Cobra trunk. The subs will be facing up in the middle of the trunk and powered by a Zapco DC reference 1100.1 amp with about 850W @ 4ohms. Source unit is a Pioneer AVIC N3 navigation system. I currently have a Polk Audio SR6500 component set in the doors powered by a Zapco DC Reference 1000.4 amp. My picklist is below: 2- Soundsplinter RL-i10's : pros: great price & reputation cons: not sure 2- Audiopulse Epic …

just curious....... and I have in fact seen the 60" one that apparently does 1,000,000 watts. Im talking about practical subs

Hey guys i have done some googling and looking around but i cant find a good enough answer to my question... Its it ok to invert subs when mounting them? The general feeling is due to the low frequencies it is ok but at what crossover level does the sub being inverted affect performance? I was thinking of mounting my IXL 10 inverted to protect the cone from occasional lose crap in the boot plus the motors look really sexy :clap: However i cant help thinking that the motor structure must effect the sound quality as the air wave is being impeded by the Basket Anyway if you guys could give input that would be great I was thinking something like this with 2 IXL 10's *This i…

i just want to c what other people think 18 ssd fully loaded or 18 Q no BP

Anyone know how tall the wall is in the bed? If I wanted to do a blow through with 6 15's (ICONs) is there enough height? I don't have a truck in front of me to measure, just wondering if you guys would know.

basicly i want to build a box and i cant find any info on how to tune it. what i want to do is have round not square ports.

I really want a 18, extremely bad but I have been lead away from it due to trunk space. My question is, if I put a SSD 18 in a 5.5 cuft box how would it sound compared to a SSD 15 in a 3cuft box. I wouldn't have a problem fitting the 15 in but the 18 would be a snug fit, but its much more appealing.

Well im just starting to learn about the car audio scene...i have a 1999 Jeep Cherokee stock and trying to find the best setup i can get for under a grand for just the sub and amp...hopefully without having to upgrade the electrical alot... i think it would be best to go wit a single sub instead of spending more on 2 subs and cheaper amp...figured better amp would be worth it in the long run..so either looking for one 12" or a 15" sub, space ain't a issue...i mainly listen to rap and r&b...basicly im looking to get a nice clear sub that has plenty of bass wen i want it, not looking for SPL just a good quality daily driver...probally going to go with a ported box also.…

I was just wondering how much different the 2004 models L7 to the newer ones. how much louder they are if they they sound better stuff like that.

:bigclap:

looking to get some nice midbass+highs, looking to upgrade from my infinity's was looking at the cheaper cdt audio comp sets was thinking of getting a 6.5" comp set and a 4" comp set so 2 6.5's 2 4's and 4 1" tweets i would put 1 of each per door and then 1 tweet in each front window pillar or next to me in the verticle pillar by seatbelt would that be a bad idea? too much tweeter?and could i wire two 4 ohm crossovers together for two ohm's? so 2 crossovers per channel

Hi i just installed a hifonics bxi 2608 im running it at 2 ohm at 1700 watts. my box is tuned to 34 hz @3.5 cubes. my bl is over extending itslef so i turned down the gain. My question is what should i have the low pass filter set at right now i got it at around 75 i think thats too high. it kind of sounds messy. and if i turn it down could i put the gain a little higher?

I need help finding out what sub or subs I should be putting in my car. I have a camaro, and I am able to put a 5 cubic ft box in my car and I currently dont have much power as an amp. 750 bridged at 4 ohm. The RF 500/2 Where I work I get discounts on Alpine's and RF. Thats why I am currently running 1 12" P3 in 2.5 cubic ft. sealed box. I was orignally going to put two P3's or 2 Type R's in but from what I have heard from you guys thats not the way I wanna go. I am on a limited budget of 500 bucks unless I can sell my old school memphis 500D amp and my Rockford.(I hate being a poor college student lol) I am after some clean bass. Not so much spl...even though I like ev…

A 33w 16h 18.5d space for an enclosure a 1995 accord coupe a sundown 1500 for power i listen to classic rock and rap. i have approximately a $500 budget for two woofers. spl is my goal, but i do not want a fart box. i want loud low music nothing more. couple of woofers i was thinking about: IA DR 12d1 fi Q d1 ssa icon d1 PAP WMD 12d1 (they're so cheap!) im running a RE sx 15d2 that has been reconed by fi with some cooling and suspension upgrades. i'm open to suggestions on woofers and box designs, what port size, length and orientation especially.

I have been getting a lot of opinions lately for sq subs, amps and setups. I was wondering, per a suggestion earlier, That if I ran 8's in my door for mid bass and a 3" woofer for mid range in kick panel with tweets in A pillar. Has anyone ever made a custom speaker pod in the A piller for a 3" or a 4 " woofer. And if so how does it sound, what are the trouble you run into with that kind of set up. I am trying to shy away from kick panels just cause I am a big guy and the kicks being so low I am afraid I will lose alot of imaging. But here is what I am afraid of putting the mid ranges in the a pillers, that it will be to splashy or high pitch and make your ears bleed wit…

I am looking for a pair of D2 15's that have at least 30mm Xmax, 20Hz or less Fs.

I was looking for a 10 inch sub for my 96 accord, and was interested in the digital design 3510 sub, but have never actually heard it. Im looking for a sub that is slightly more "compact" than my 12s, but still delivers the bass that I crave. Any opinions? pros/cons, etc.? Any suggestions towards another choice will be gladly accepted. Will be running this off of a JBL GTO1201.1 II. Thanks in advance.

What would you guys recommend for a Beefy 10 inch woofer? Its gunna be run in a standard/regular cab truck and run by a sae-1000. I was thinking a BL 10 or an icon 10 but im not sure. I just want loud, shaking, low bass. Any suggestions?

looking for specs or plans for sub woofer box for two 12" subs for a 94 camaro.Something similiar to the one in this link, http://www.audioenhancers.com/catalog_prod/gmc_93NCT300.html

My IXL's are getting delivered today, on the SSA site it says 800wrms, on the Mach 5 site it says 1000. Which is correct?

A mid made by CIARE (Italian company) for Car Audio. They have a bunch of products home and car... even horns like ID but I don't know what they are worth. http://oaudio.de/media/products/0861656001182438423.pdf I was thinking of pairing those with my ID CD1v.3 horns for a 2way front stage. The new version has pretty much the same specs except for the Fs = 75hz // Re = 3ohm // Qts = 0.16 // Qes = 0.16 // Qms = 4.88 // Mms = 13.19. Your opinion appreciated, Kelvin

A teammate of mine (Bumpinbuick on most forums) got his Omega 15's in he sill be using in a daily setup. His comp car will be using 2 18's. He will be testing them soon for those that were interested in the t/s parameters. ** Black powder coated baskets with the lime grren flakes are for team members. Regular Omegas will has a deep metalliac purple baskets.. Which i kinda like a little better LOL!! 18" baskets will just a 6 spoke design.