Subwoofers / Speakers

m5a are you guys going to start selling any tweeters&crossovers Is that true that there is going to be a m5a car amp series? so i hear that the M Series is no more so do you have a new series around the same dollar or is that a thing of the past? any news on the new subs? in the past m5a had a plate amp do you guys still sell them and if so whats the cost?

Does anyone know where the t/s parameters to the 18's of either the 9500 or the hdc3 can be found? I am trying to get a box designed but the companies don't have them posted that I can see.

are the ixl 15s more of a spl sub? Whats a good amp to power it?

Not my thing, but my sister wants some output. Looking for a sub for her boat. Nothing magical to blend with, just a set of tbd comps and an amplifier. Have 350w @ 4ohms (or 175x2 @ 2ohms) on tap and up to a few cuft to put it in. Would prefer loud for playing hip-hop, but at least mildly musical as I won't build a box for a fart cannon as it would piss me off too much. This one will be ported. Budget, less is more but $200 tops. New, used, a pair, or unusual is all fine with me I'd love a Maw, but the coils don't work for the power we have Same problem with the SD's. At the moment, I am leaning towards a 12" JBL GTO for $50 but would love to kick it up a notch …

Ok I am putting the finishing tuches on my rear setup but want some input on a solid midrange. I am looking at getting 4 HiVi F6 single 8ohm midrange speakers from partsexpress and wireing them into a 2ohm load to my amp crossed over at 150hrtz or in that area, also in the rear i'll be running 2 Audax 8" subs for the midbass crossed over at like 80hrtz. just wanted to see what you think about this set up.

Old system: Some cheap Sony deck Infinity Kappa 5.25" components (2007) - KAPPA50.7CS Infinity Kappa 6x9" 3 way coax (2007) - KAPPA693.7I Infinity 10" sub - KAPPA PERFECT 10DVQ MTX Thunder564 - 4 channel MTX Thunder421D I will replace everything and all ready have: Alpine 9885 12" Fi BL - Dual2, Cooling, Flatwind, Daily Hifonics ZXi 6406 Hifonics BXi 1606D I was going to use the 4 chan. Hifonics to power the new Kappa 2008 speakers since they are 2ohm, but just decided how much I hate my current kappa's so want to do something else. Wanted to get: http://www.woofersetc.com/index.cfm?fuseac...Product_ID=4630 and http://www.woofersetc.com/index.cfm?fuseac...Product_ID=3078 …

What is the loudest and boomiest sub under 1000 watts?

I was looking at this set of Hybrids, I had already set my budget at $500 before looking around a lot and I have heard good things about Hybrid Audio so how do you guys think they would do running active with a Sundown 100.4? Also I'm not so sure that the 6.5's will fit without mods to the door so if they don't then how will the 5.25's compare to them?

So ive been convinced by a third party to swap my fosgate amps for some audison amps and im wondering if i should still go all active up front. Im looking at 2 SRX 5 channels rated at 4X75, 1X160 @ 4ohm or 2X150 1X160 @ 4ohm (all my drivers are single 4) and i was planning on keeping my 301x fosgate amp I need to power pair front tweets, pair front midrange, pair front midbass, pair rear passive componants and center channel (9 channels) Ive sorta boiled it down to either All Audison active = 2X150 front midrange, 4x75 rear and front tweet, 2x160 midbass and center channel off the fosgate Fosgate/audison active 2X150 front midrange, 2 X150 rear, 2X160 midbass and center…

Hey guys whats up. I'm selling the Exploder and getting an Accord coupe. I want to do an IB setup...I'm moving away from the SPL deal. I am starting to crave more SQ. Possible drivers I was thinking about were: 1. single ED 19Ov.2 (already have) 2. two Exodus Audio TempestX 3. four ED 13Kv.2 (on sale right now) Not really sure about what else. I really want to do two 15 inch subs...I'm thinking it should get pretty low and have decent SPL. Also need some advice about midbass...I was thinking about making some 8" kickpods lol.

What would you guys buy if you had 250 dollars and you could only have a coaxial speaker. What 5.25" would you buy?

ok so i looked around and found some speakers i like. they are Hi Vi D6.8 and SEAS 29TAFW. i plan on running 4 of the hi vi and 2 seas' up front. what type of crossover would i need to make this compatible?

i am just trying to get a idea which ones i want to choose. which ever one i choose will be in 4 cubes tuned around 30-35 with a AQ 3500d running them. which one would have more potenial to get low? thank you for you input

Twins

I am new to audio so I am going to play dumb. Can I have boston acoustic 3 ohm speakers in the front and 4 ohm jl audio in the rear or is the ohm difference going to cause a problem.

i am in the market to buy a whole new setup for my car. i have no knowledge of any good component systems and i really need to be pointed in the right direction. my car takes 5x7's in the front and 6x9's in the back. in the rear i will be using 6x9's but in the front i want to run something other then a 5x7. maybe a mid driver. i want to stay with a component in the front but can u match components with mids? or r they the same. i have been looking at boston acoustic for the speakers and maybe a sundown 100.4 to power them. maybe an mtx amp. i am willing to spend around 800 for the entire setup. any suggestions on other manufacturers?

I am looking for a 12" or a 15" sub. I want it to be daily. I dont want it to require to much power beacuse i dont want to upgrade alt and run another battery. I listen to rap. I can make a box up to 6 cubic feet. I want it to get loud and boomy.

Planning on pairing one or the other with the L1 and taking advantage of the group buy. My question becomes which is going to be better for my application? I'm quite sure that I can fit the L3 in the A-pillar, not so sure about the L4. The tweet will likely be an A-pillar install either way. The L3 would be a pretty simple install the L4 not so much. I'm not sure that I need the extra top end of the L4 since it will be paired with a tweet. Through the midrange freqs (say 250hz-10k) is the L4 worth the extra money and install hassle? I should be able to get the L3 much more on-axis if that matters. Thanks for any inputs.

is it getting closer to the time?? just checking to see if there has been any recent development. getting anxious but patient. Also any box recommendations yet for this killa. thanks

did a search and didnt find anything... looked on google and didnt find anything...does anyone know anything about SPL audio subs? thanks Doyle

Anyone have experience with the new Tang Band Neo 6x9 subs? My new truck will have 6x9 cutouts in the front doors and I'm looking at these for dedicated midbasses in a 3-way front setup matched up with Hybrid 4s and tweets. Power for all coming from a trio of Sundown 100.2s and filtering from a Altomobile Drive 30. I really want to do the Hybrid 8s in the doors but it doesn't look like that will possible without some heavy cutting on the door and door panel which I'm not willing to do this time around. If there are any other ideas, I'm open to those as well. 6x9 cutouts stock. Apparently about 3.5" of depth to work with, though in all honesty the guys on the Fronti…

Im looking for a 12" sub. Im looking for a louder one but still sounds good. It should probably be under 1000 watts because the car i have right now i dont want to upgrade the alt or run another battery because i might not have it much longer. any help would be great

Ok so im pretty much getting brand new everything What I have now... HU: Alpine CDA- 9831 Current Amp: Rockford Fosgate Punch 500S And I got a rf 12" sub in the back. Speakers: factory Car: 1997 Honda Accord SE So far I'm planning on.... (havn't bought any of these yet) Im pretty set on the sub and amp, not so sure about the speakers. Subwoofer: 15" SSD w/ copper wire (i want it sealed, but coudlnt find the specs...) $215 ( I might go with the 12") Amp: AudioQue 1200D $240 Front Speakers: im looking at these http://www.cadencestore.com/ProductCart/pc...mp;idproduct=95 $70 They looked like a good deal, but I just want some feedback because I'm pretty new at this. If you…

I have a set of alpine type R compenent speakers and the mounting depth is 2 5/18 and my cars stock speaker location is 2 5/20. How would I be able fit them if possible. Would a kick pod work? I need help asap.

Hey just want some guidance and suggestions. I have type-r's which I'm really starting to get sick of. The 6.5 is in stock location and tweeter is flush mounted in the door. All I really want to do is replace it, and not change the locations. I want component set with a passive crossover which has good sound quality. My price range is around $400. But give me some suggestions in the 300-200 price range as well. I know anything will sound better then these Alpines. I need the new tweeter to fit into the hole which is there for the type-r tweeter. The dimensions of the type-r are Tweeter Mounting Diameter (in): 2'' Tweeter Mounting Diameter (mm): 51mm Tweeter cannot be s…