Incriminator Audio

spirit left the older version DP and the new one go bye bye :/

So my friend Roger decided to throw his LI 15 dual 4 in 3.0 tuned to 30 and his APSM-1500 @ 2 ohm into our friend Kyle's 2001 Mountaineer for giggles, and asked me to put it on the SPL Labs. Results were not shabby: 134.10 on Air Forces 134.66 on a 43hz tone This was with stock alt, battery, and a shitty Walmart wire kit. Just wanted to share the results. Not bad for a amp/sub/box that's less than 400 bucks

i have a pair of 12" death rows.. and space is getting kinda tight if i have to account for a big slot port. so i was wondering if a pair (2) of 4 inch aero ports would be sufficent, or would i be better off just using 1 sub and keeping the port size up.. thanks in advance.

Okay im building a nice custom box for my 2003 honda accord. But I need to know how tall and wide the port needs to be and what hz I need to tune it to. Anything you all can say would be helpful! By the way im making it out of 3/4" mdf plywood.

just got a 40.1 and am wanting to run it @ 1/2 ohm...this will be a daily/bass race set up. I'm running a 200 amp h.o. alt, optima yellow top under the hood, and 3 of the older hc 2200's...will this be ok? installing it tomorrow but wanted to get some input first.

well for the 99 bucks is that just for one speaker or the set? i know sounds dumb but just wanted to know

As the topic says we will be gone for dB Drag Finals! Any emails, PM's, calls will be returned as soon as we get back! Thanks, Nick

I was wondering if anyone knows if the 21s are shipping. I got a friend that wants a little bass in his ride and I think this would fit the bill. Do you guys think a sundown 3000d would push it pretty good? What kinda box am I looking at as far as cubic feet and tuning for a daily ground pounder? Thanks for the input and I will post pics on the build. Peace, Lee

I know the cones aren't ready for the 21's yet, but the baskets are there, so what's the cutout sizes on both of those, so I can decide which one would work best for my situation?

I was wondering if you guys though a DP21 would be logical for a daily sub for all types of music. I'm thinking either that or maybe 2 DP12s I'm not sure yet. I'd like to get REDICULOUSLY loud, like 150s + where i don't want to be in the car. But also be able to turn down the sub and use it for regular music too. what u guys think?

Hello, I have a 12" Flatlyne on order that I plan to use in an IB setup. I am working on the baffle and a couple questions have come up. I am under the impression it is alright to install the sub with the driver facing the cabin of the car (inverted mount). Anything wrong with this plan? If it is a problem is tilting the speaker at a slight downward angle OK (cone facing down a bit)? Thanks

Ok guys, im in the process of selling my current amp and sub... I have a buyer for my current sub but not the amp... heres the amp... Rockford FosgateP5002 I am planning on buying a 15" death row once my sub is sold, along with a new enclosure for it... But my question is... will my current amp be able to push it enough to get sound louder than it is right now hooked up to a 12" w3v3... this may sound like a noob question but i have really never underpowered a sub this much before...

How would a IA DP 12" sub do in a box that is 2.742 cubes ported to 40??

Here's a few pictures of two 187 12's under the back seat of a 2006 Fored F-150 powered by a Rockford 500.1BD. It was one of the loudest installs I have heard under the back seat of a pick up.

Is the wired remote on the 20.1 a remote bass boost or gain? Just wondering.

im thinking about getting two of these. Twelve inch dual 4 ohms. Just a couple of questions about them. I always read about how people are raving about them, but they have a very small linear excursion compared to other woofers. Im not exactly a guru at car audio, but if a woofer has a larger excursion isn't it better able to produce the lowest frequencies? Also i have and saz-1000D so would i be over powering them too much, or are these woofers really under rated because i have read that they can handle a lot more. Anyways im either getting the woofers stated above, or the id12D4's. Which would you think would be better in your honest opinions. I have good self control …

Guess ill use the newbie list to make this as clean as possible, 1.Subs, Six 10" series 187. 2. Vehicle, backseat of a 1996 ford mustang. 3. Amp, Audiopipe 3001.d 4. battery's, one kinetic 600, and one kinetic 2400 5. electrical, Alll 0 gauge, Big three. 6. had two fusion 15's ported at around 38hertz, sounded alright, wouldn't mind deeper lows. 7. im having a wall built for the backseat. a square common port in the center with three on top and three on the bottom. If anyone has any advice on what the box should be ported to, i was thinking around 33-35, my goal for getting all my systems was to be able to do a hairtrick, and since then have been unable to, so if anyon…

Just received these yesterday. Cannot wait to get the box built and get these playin'! And finally some a$$ shots! These pics didn't turn out the greatest but you get the idea. A big thanks to Nick and the rest of Incriminator for building great products and great customer service.

We shut down production late yesterday evening to bear down and focus on redoing the website...hopefully we will be able to keep it more up to date from here on out. www.incriminatoraudio.com

I sent an email in two weeks ago, and all I got was the standard automated response saying that you guys would be with me as soon as possible. Two weeks later, and I haven't heard a peep. What's going on? You guys are usually good about emails.

hey I have a 12" IA Flatlyne on the way and I am trying to finish up my box. I need to cutout the hole for the woofer and need to know the diameter of the hole. Any help would be appreciated. Thanks

i need 2 12s for a sealed box. about 1.3-1.4 per side. how will the LI 12's do in this setup? 500watts a piece for now. im also looking into RE SEs. I have idqv3's now and they dont get loud enough or low enough. but i have to stay sealed the box is behind the rear seat of my crew cab. thanks.

i have been looking endlessly online to try and find the best enclosure for 2 12in IA LI's. i am stuck between a 4.0 CUBIC FEET TUNED @ 32Hz,and a 5.0 ft tuned @ 34. both boxes are single slot port.I was looking for one tuned around 2.3 but didnt find any and dont want to pay to have a custom box made.i dont care about sq, i just want it to pound as hard as possible. any suggestions would be great i am putting it in a 2000 taurus i believe the trunk is 17 inches height and i think i have plenty of room for these enclosures.also i am powering these by a kicker zx1000.1 (1180 watts)

In response to the pm: Right, I bought a 12" DP off of Justin T. and it came blown!! So I figured I'd upgrade to the 15" and if I like it, maybe buy 1-3 more for my vehicle.. Thanks, Matt

Does anyone have a pair of 40.1s that I could borrow for Finals? I already have two and if anything happened I would replace with my amps. I would obviously pay shipping.