Nothing to see here yet, just starting a place to post crap pics.

looks like fun

those torsion bar things are the devil

You should just leave it like that.

At least you managed to sneak a pic of the stang in

IB ?

cut everything out. cut it all out!

Angle grinder fun ftw!

angle grinder hell...go plasma cutter FTW!! be done in like two seconds..lol...

wheeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee

No IB, but the cabin and trunk will be sealed from one another.

As for the torsion bars. They're perfect actually. The deck is rather large, I mean, I could eaily fit a pair of 15" drivers on it, maybe even three if I were creative enough. They are located pretty far back and no modification to them will be necessary.

And, Sawzall FTW!! Waiting on my steel to be milled.

Like the plasma, but you can't get one for $15 like an angle grinder.

No IB, but the cabin and trunk will be sealed from one another. 

As for the torsion bars.  They're perfect actually.  The deck is rather large, I mean, I could eaily fit a pair of 15" drivers on it, maybe even three if I were creative enough.  They are located pretty far back and no modification to them will be necessary.

And, Sawzall FTW!!  Waiting on my steel to be milled.

you're lucky then

with the torsion bars in B-bodies, you can BARELY fit 2 12"s in there

that should be very sweet once done

Like the plasma, but you can't get one for $15 like an angle grinder.

u get what u pay for!!!

and we use a sawzall at work too!!

wheeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee

Cutting thin sheetmetal upside down sucks!

Whats all that white stuff ?

IT's not white. It's a very light green. It's liquid deadener.

Damn, that deck is uneven as hell, must be a biatch. Good luck Ryan, I'm sure it'll turn out real nice.

IT's not white.  It's a very light green.  It's liquid deadener.

<{POST_SNAPBACK}>

to lazy to move the wires...cmon.

Nice hole.

I can finally say that and not get slapped!

IT's not white.  It's a very light green.  It's liquid deadener.

to lazy to move the wires...cmon.

It's a beater dammit. No need to move them anyways. Factory speaker cable and a pinswitch for the alarm are all that got covered.

Got a new amp today. I'm actually so impressed with this thing, I think I'm going to order the 2300 for my sub. Too bad I'll have to run it at 8 ohms, but I think 250 watts should be plenty with it being vented.

cute lil thing isn't it??

wheeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee

Those terminals make me *barf*

I love the terminals! Set screws rock, and they are ALL THE SAME SIZE!! Only a single allen wrench needed.

Clean, simple, and sexy. Have you benched it? I expect them to perform, but have really been wondering how they actually do. I'd surely guess they would at least meet spec, but every now and then PE can really give you a pleasant surprise.

No way to bench it. If you have the means, I'll be more than happy to send it your way.