Leaderboard

12 BEAST 15's, 33,000+ watts of power, 30 batteries, Plexiglass windshield, and a badass 4th order. A must see video!

220 amp HO alt from Js Ultimate Alts with new belt. Misc electrical. Fuse holders, fuses, terminals, volt meter. New Optima Yellow Top Group 34/78 for under the hood.

What exactly is your goal ? When you strap two amps, each amp will effectively "see" half the load. So a 1ohm load strapped on 2 amps would mean each amp would be operating at .5ohm, below their recommended range and risking damage. Not recommended. When strapped, the lowest (safe) nominal load that can be ran to those amps is 2ohm. The other option is to buy a second amp and run one to each coil. But then each amp would be driving a 2ohm load and the net power to the subwoofer would be virtually the same, so absolutely no gain there. So either way your plan of purchasing a second amp is not going to work out. From what I could find that sub is rated at 1500w RMS, and you already have 1200w on it...so I don't see increasing power as a viable option anyways. Even if it were, I'm assuming your goal is to get louder...adding more power is the least effective manor of doing so. With the power compression and already being near the driver's limits power handling wise I doubt it would make much of an audible difference if any. Look at redesigning the enclosure first if you are looking to increase output.

If its build good, tuned fairly low and enough power all port locations will demo well. If you want sealed numbers dont do top port! I lose 5-6db sealed on dash.

Look forward to hearing about the Audison.

Looking good !