Leaderboard
-
hdrox88
Members3Points730Posts -
j-roadtatts
SSA Supporter L21Points9,752Posts -
Tirefryr
Super Moderators1Points30,516Posts -
Penguin4x4
SSA Regular1Points19,468Posts
Popular Content
Showing content with the highest reputation on 02/18/2015 in Posts
-
1 point
-
1 pointI think I inhaled more than enough dust today. Got all my cuts made, now it just needs put together. I used some scrap mdf to make the rod type brace instead of spending the money on 1.5" dowel rod. Came out well enough. My inner port wall seems to double as a small table. Baffles are cut and ready. I stopped here for the night to let the glue dry before further assembly.1 point
-
1 point1 point1 pointHad to tame some rattles on the rear hatch. Glad I did, the sub stage blends much better with the front now. Bare skin Push clips with a little CCF to keep them still. Hard to see, but there is some pieces of CLD in there. Giving the panels a CCF treatment of their own. Closing it back up.1 point1 pointDamn those things are heavy! Makes the Diehard Platinum G31 look small. Wiring to .5 ohm on the BC3500. I learned the value of a clean signal first hand today. Not the hard way either. Wired at 2 ohm I could get the zcon to warm up after a good beating. Now at .5 ohm it can get more brutal and it's not even warm at all, while paying attention to the voltage and sub control of course. After adding the two hc3800 the voltage hardly flinches. Now I have box hop to contend with.1 point