Leaderboard

Glass insurance is usually a stupid good idea. I think mine is $15/yr

I finally finished the enclosure a couple weeks ago and installed everything. It's 36x14x14 (24mm MDF)...2.67 ft^3 which is about 1.3 ft^3 per sub. I hooked everything up and it sounds pretty good on some songs but I know it can get lower. I don't know what the frequency is currently. I don't have any washers or nuts on the PRs. I need to tune it but don't quite know how to tune PRs. I don't have the ability to look at winisd (I have a mac). Any help would be appreciated. I've attached the T/S for the OEMs and VMPs: TSP's Qts 0.357 Qes 0.400 Qms 3.35 Fs 30Hz Res 3.11 ohms Ls 4.0 mH Lp 6.26 mH Rp 9.9 ohms Dia 208mm Vas 19.3 liters Mms 224 grams Cms 119 um/N BL 18.35Tm Spl 83.3dB VMP TSP's Qms Variable Fs Variable Dia 208mm Mms (unloaded) 370 grams Cms 180 um/N Nut mass 175grams Washer mass (each) 80 grams

I am about done drinking for the day

Hi Aaron I like these amps, a lot. My system is configured to run active. One amp is driving mids and tweets and the other is bridged to my two mid bass speakers. These amps have a ton of power for my front stage. I was at a car audio meet and greet last weekend. Everyone that listened to my vehicle loved how dynamic it sounded. My front stage is full of energy that you can feel. These amps are small! Build quality and overall cosmetics are superb. I have not contacted NVX regarding their turn on/off click. This turn on/off click is not desirable. If this can be eliminated I would rate these amp 10/10.