BTL15

I currently have a fi btl 15 fully loaded and i planed on using knu konceptz 8 gauge speaker wire but when i tried to wire the sub up the wires were too big haha...so is there anyway i can make the wires fit ive looked at banana clips and wire reducers but i dont know what to use and if it will distort or loose power

It depends on the wire;s amperage capacity, depends on what that Autotek will pull but I would do 2 positive runs of 1/0 power wire if you can. Thanks will do. Im also looking into mounting the sub with 4claw t-nuts...what size bolts and t nuts should i get i'm not sure on the sizes of the mounting holes so that's why i'm asking

Sorry i must have stated it wrong what i was trying to say is should i run two 1/0 POWER wires or will 1 be sufficient enough.

Im looking to run a extra battery (XS Power D3100) to the back of my truck. Then run a Autotek 4000.1 from it. Should i run 2 1/0 cables from the starter battery to D3100 battery or will 1 be enough to fully support everything.

sorry if i used anybody's these just came to the top of my head so i typed them Second Skin Thermal Kill Second Skin Heat Wave Extreme Second Skin Blaze Shield Second Skin Arctic Shield Second Skin Fire Shield Second Skin Heat Shield

Not an expert on it but sanding it with 120-150 grit then use a solvent-based primer must be solvent based cant be water based otherwise it will cause the board to swell up, then paint should be the best way to do it .

Perfect timing right as i start looking for a new amp. Can't wait for pre-sales.

Looks good thanks i meant to say 4.75 each but my brain was not working haha. Will show a build log next week when i start building it.

I would rather have the depth cut down a little the rest dont matter, im lookin at sub and port both up but i still want it to be 9.5 (4.25 each chamber) NET cubic foot after all displacements. Thanks

Yea i know i can cut it down i was just giving the max dimensions. Its going in a Silverado ext. cab.

Max Dimensions are height 27" depth 22" and width 60"

Lookin at 2 220 amp alt., big 3 uprgrade with 1/0 and two xs power d3100 batteries.

I'm looking at building a custom box for my 2 fully loaded fi btl 15s and need some help with the dimensioning. Im looking at have a 9.5 net cubic foot box tuned to 32-34hz with a solid wall brace in the middle separating the two subs. For power im looking at either 2 rf t2500-1bds, 2 sundown audio saz 3000ds, or a autotek mean machine 4000.1. Does this seem like a good setup. Im looking at putting it into a chevy silverado ext. cab of course with all of the electrical upgrades also. Thanks for any help