icy_chris

no problem when you get it done post some pics

i figured after displacment your at about 6.75-7 ft3

hope that helps you out

and yes i would recomend bracing the less movment in the box the better

it is net volume

its before port displacment so you have to minus the displacments from it.

i use 12 volt.com 12volt

yes port to 5.5 and length would be 42.75 long to get tuning at 30hz or if you made the box wider by 1" port 5.5 and legth 40 would tune to 30hz

15 has more cone area so it will move more air if your going for loud this one will be louder not sure how much but it will be louder

that tuning sounds off with those dimentions it would be around 34-35hz you would need a port length of 46 to get your tuning down to around 30hz

your welcome i have a 12" btl on a saz2000d and it hammers i think you'll love that 18"

that amp is stable at 1 ohm so wire it at 1 ohm and hammer away

for soldering use a pencil torch crimp the terminals best you can heat them up and add solder to the terminal till it bonds to the wire and terminal than makes sure they dont pull out for the on off switch/ button wire on in the remote wire from your deck to your amp and mount it some were you like and that can be used to turn on/off your bass you won't need a heat gun for anything

yea i have one last piece of carpet to put on tonight and the finished pics will be up soon! but its a grey tweed with a 3" strip of white rock down the mid

would these make a good mid bass driver ?

so if you take 2" off the port and with the bl the tuning will ba really close to 33-34hz

it's only different by0.02 so it's going to affect it by probly .5 hz

i'm not sure on how much it will affect the tunning tho

yes the more your sub takes up the higher the tune will go

no problem

Correct. If you wanted to tune a tad higher, i would do 2" longer than what it shows in the diagram and you would be fine. wouldn't the longer the port the lower the tune ??? you mean shorten the port 2" shound raise the tune aprox 2-3 hrz

to tune it higher you can shorten the port leghth but i'm not 100% on how much id say around 2"-2.5"

hey do you guys just sell the bass knob for the sundown saz2000d mines acting up it goes to 1/2 and stops pluss when you go to 0 it doesnt get low it stays on.

welcome and wow nice score

dude sweet pics but i got bit by a brown recluse a few years back and now spiders give me the willies lol