sundownz

Great job Gary!

I just e-mailed you.

Time is almost up for the $1000 price! Estimated width is going to be 12.25" or so... most likely a hair less. Still working on the final design.

Not yet but I do expect them soon.

12 - 15 volts 15.0 is maximum.

Yours made it safely

?hey jacob is that a nightshade 10 behind the laptop on the floor in the video? It is a 12" that UPS broke.

The SAZ series are a substantial upgrade in toughness and low impedance / high voltage stability. The SAE-1200D is a great every day amp when set up properly.

And it climbed again to 154.7 at the nSPL show later in the evening

Well then... forum updates for the lose! I'll fix em.

I will be gone all day today and back at work on Monday.

Glad you like em - these things are great... can't say enough about how much I like them.

Had a few requests for videos. Made one playing "Trap or Die" by Jeezy. Seemed to be about the same on the meter door open or closed. Link to video : Four of the new SA-12s being used on two 3500Ds @ 1 ohm each (turned down of course as these are 600-watt rated subs).

Walled truck... wall will hold four 18s but only has two right now. Only using three 12v batteries at the moment so power is limited Video is processing as I post this... so click in a few minutes.

Sounds great

Bit too large... go for 3 - 3.5 net after displacements.

what was the rise? Didn't measure rise. My clamp will give a power read out without breaking down voltage and current.

Two 3500D. I am not using the full power, of course, but I had two 3500s installed already

Looks good

Just clamped power... 4840 watts total power on my clamp. So about 1200 per sub on a burp to do that score -- this run was 153.4 dB as well, a tenth higher

153.3 dB @ 47 Hz so far I'll clamp the power shortly... but I don't think it is really all that much all things considered. HU is at -10 on sub control -- as far down as it goes. I had it at -4 to put up the 154.1 with the single Nightshade 15"

RE: 7.09 ohms (D4 in series) Fs: 28.4 Hz Qes: 0.511 Qms: 5.75 Qts: 0.469 Vas: 40.3 L BL: 25.04 NA Le: 7.7 mH Mms: 252 g BL^2 / RE: 88 600 watts RMS Depth = 6.5" Cut-Out = 10 15/16" Enclosure Suggestions: 1.75 ft^3 ported tuned to 30 Hz -- F3 of 26 Hz * Tune higher and use a smaller box for more SPL oriented setup (Use 1 - 1.5 cubes) * Enclosure can be as big as 2.25 ft^3 with lower power levels 1.00 ft^3 sealed -- F3 of 44 Hz * For SQ and space limited applications

They are here! Will be shipping them over the next few days.

It's a totally different amp.

All of the remaining SAE-1200Ds are being sold on e-bay @ blowout pricing.