sundownz

Two MOJOs would work nicely on this amp. Check out Knu Konceptz : http://www.knukonceptz.com/ I suggest simply using the low-end Klarity RCAs and using the Kolossus Fleks 1/0 cable for power and ground.

Remember these won't be in until late October - you can get your 3500D 2 months sooner.

Who needs furniture ? Cinder blocks + lumber FTW.

Regular price will be about $1549 MAP / $2149 MSRP.

Proposed pricing schedule... Before July - $1000 During July - $1100 August until October - $1200 Who would be in now ? Especially with the early bird price breaks

I believe you only get one-year -- you will have to e-mail or call Chris to find out more information on his warranty as it is all through him on refurbished models.

Less than 1%

Between 2500 and 2640 in the Jeep.

D4s only at first. We'll eventually get D2s in stock.

I am going to close this one too as I'm sure it will also get out of hand. You have the phone # for dB-R now so you can get anything you need. (281)454-9496 -- Chris @ dB-R

Where did I post that you are a moron ? I also deleted most of the messages that were out of line as I don't tolerate that on my forum. I made one post to ask if you e-mailed me and another to close the thread because it got out of hand. You can also call dB-R and get your invoice - he posted his phone number and it is also available on his web site.

I decided to keep running this through June!

Congrats!

I wouldn't use an excessively long cable for strapping - I use 3 ft cables.

Indeed... don't suggest using the 1200D under 1 ohm.

Whatever it is may be ready for testing in 4-5 more weeks.

My fuses are Stinger.

If you pop a 300-amp fuse with one 3000D you need to turn it down I don't pop 300-amp fuses with 3500Ds on 18v and 1/2 ohm

The 1200s run unusually cool when used properly The sample casing for the 1200 was about 1/2 the aluminum mass of our tooling and still ran cool - we added double the aluminum and more surface area and you see the results!

I will say that picture was taken right down the road from our shop at a local machine shop

The motor is more than 8" across - so no

Indeed.

The steel hunk was originally about 9" in diameter

Not quite!

I'm not telling