sundownz

I'm not sure what you mean... you would hook them up to an amp.

ETA is Friday - this is ALWAYS subject to change on pre-orders as I'm sure everyone knows. I asked yesterday and everyone in the line expects it to at least be close.

It is 96 in^2 of port.

It is 12 dB. The remote is for gain on CH 3+4 when the LPF is enabled.

About 2.5 cubes tuned to mid 40s.

YGPM.

Hopefully we will steadily grow to get fairly good sized in a few years

My 1996 Jeep Cherokee Sport 2-door.

Show on Saturday: 152.1 @ the windshield 154.4 @ the passenger kick with drivers door open 169.5 inside my port

Nightshade with a copper coil is a pretty good low-end monster - I may consider offering them a bit later.

Probably not going to happen any time soon... unless I decide to do a limited production run at some point. It is possible but on the back burner.

"Competition Only" - small org, but I always have a great time at their shows.

I have 7 lines planned total.

Maybe. Would have to order extra parts and get custom wound coils made... would cost extra of course if I did so.

No ETA... all depends on the economy.

*laughs* Everyone thinks I should be old. It was a great show, congrats to everyone in Competition Only - thanks for all the hard work and dedication!

Thanks guys I still have fun doing it too!

Awesome!

I know you can't wait to put one in the Jeep and strap a pair of 3000s on it. You know it :)

Optimal sealed 1.25 cubes or so. Optimal vented 1.75 - 2 cubes or so.

I don't want this to turn into a battle ground so I will close this post. I think everyone got their 2 cents in --- Fabio, Again, I don't know of any direct swap tests so I don't think anyone can 100% answer your question at this time.

These are a different series - my most SQ oriented line will be the "X" line - it will start with a 10" model.

It will look at the least very similar - the only possible change I may consider is a slightly larger outer-diameter magnet (maybe 10mm). Depends on how my testing goes. I really like the simple, industrial look of this woofer.

Indeed We will see how it does when I get to testing it.

Sundown Audio SA-12 Prototype 600-watts RMS / 2.5" Coil / D4 configuration Estimated MSRP - $200 USD ETA - Don't have one yet, will be testing prototype in a few weeks Yes, it will have "Sundown Audio" on the dust cap by the time it reaches production. Designed to be used as a pair with the SAE-1200D. Will first be available in 12s when production is ready, then other sizes later (no 8s or 18s). May see some changes before production but you get the idea