Bayt

update: recieved the amp today, installed it, its good to have some thump in my trunk now.

I looked over the speaker cables and they looked fine. How would I go about testing "everything"?

I have no idea. heh. Value Electronics?

Alright so I had a nine.1 I bought used. Worked great for a couple months then all 4 fuses would blow on it. So I sent it to eD under warranty. Finally recieved one back after like 3 months of waiting. Installed the amp, worked for about 5-10 minutes then did the same thing. The amp was extremely hot to the touch also. eD wasn't much help so I decided to say fudge it and I purchased a used SAZ-1500D from Jacob which should be arriving Monday. I've been talking back and forth with Jacob about this problem and he said that there might be a short in my power wire. Theres only one spot where the rubber encasing is wore down a little bit but none of the wires inside it are poking out and that part of the wire doesn't rest on metal. So I'm just seeing if anyone else has any input. I personally think its eD's amps but I don't know. I don't want to install the 1500 and have the same thing happen and be SOL. I took the bottom off of the amp and the bottom cover had blackened around the green wire/mosfet area. also the green wire in the middle seemed to not have solder on the end of the connection.

sent you an email.

nice man what song is that

Everytime I read a post like this it makes me want a SUV even more haha...then i remember the cost of gas.

MAT? I know Algebra but I'm terrible at all math and I'm out of practice since I didn't take a math class this year. I'm at Ironwood Ridge.

I'm going to pima next fall. Have to go take my assesment tests this week. I'm graduating next month.

Do you go to UofA or pima?

haha i'm in tucson as well.

What part of az are you in why?

i dislike the filters on the images. just make them lookregular imo. text is too plain on the messaging box.

stereotypes FTL.

I don't have any wiring ran in my car yet. Smart ass haha.

eD nine.1 and its going into a 3.5 @ 32hz enclosure by fishercustoms.com

Just purchased a 15" D2 Q Can't wait!

I just recieved a used nine.1 Is there anyway to test it here at home to see if it works? Thanks

sick. that's a rather large sticker haha.

So if I were to keep the bracing like it is will that really effect the sound? Or should I be ok? Thanks

Anyone else have any input? Scott can you clarify on whether or not the bracing is ok after my example pic?

making a mix?

When you say in front of the port do you mean in the actual port? If so there is no bracing in there. haha. The bracing just goes to the inside box port wall if that makes any sense. Or is that what you mean when you say "in front of the port"

Thanks for the compliments on the box. So Scott, if i leave the bracing the way it is its not going to sound good?