redlineaudio
Members
-
Joined
-
Last visited
-
are these still available - if so how many are there left? Working on a project that will have roughly 1.8 ft^3 and these might work perfectly!
-
on another note, I got the recone all put together and at low volumes---there is a "scratchiness" to the bass. It goes away at higher volumes and it gets it on, but just a little worrisome I guess....is it really anything to worry about?
-
ttt, just 'cause I feel bad
-
sent PM as well, but I got the recone today---but no label to ship the sub back. I don't know if there's a way to just email me the label and I could print it off and ship it out....??
-
make it 16/18V? I don't think I understand, it's powering up just fine....
-
sorry, just re-read your post - do you mean remote as in turn-on? No, it is off the 12v post of one of the Kinetik's
so is my correct recone being shipped with the label?
they were supposed to be sending a call tag with my correct recone - sorry, but I'm not gonna pay to ship this beast back - and I haven't heard a word since 7/24/08
dunno, I got a D2 15" XT - all I needed was a D1.4 recone for the motor/basket I have here.
everything was turned all the way down @ first. I unhooked the "y-splitter" Maxxlink showed for the inputs, the amps are able to "fully" power up and play at a lower volume. As I take the volume up, the subs start to "flutter" and one of the amps goes into protection--not always the same amp. I've heard good things about these Maxxlink, but I'm not having good luck so far....
well, hooked everything up - and one amp goes into protection just as the other one is "fully" powering up--before any audio signal is even sent....any thoughts? BTW this is with voltage @ 18.9
what ohm load is it safe to burp (2) SAZ3000D's strapped w/ a Maxxlink? Right now, resting load is .8ohms - we have (6) 16V batteries that rest @ 17.4 and are @ 20.8 when fully charged. Would the amps go into protection? Thanks...