ABXX49

I finished the access cab and the rear wall today. The pictures of everything are on my buddies camera, so whenever he gets them freaking sent to me I'll be putting them up! If the weather is nice on Tuesday, I'll probably finish the floor! Again, I can not emphasize HOW important this is to any stereo. Most of my noise comes from the road, so I can't imagine how much better it's going to be after that! (All of my vehicles will be deadened from here on out, even if I'm not doing a stereo.)

I've been doing sound deadening for the past 2 days. I have pictures, but I'm waiting until I finish it tomorrow and do all the pictures at once. What a noticeable difference in the acoustics in my truck. I can't stress how important this step is for anyone doing a stereo. Pictures tomorrow! (maybe Monday)

My only real complaint is that I would like the one hole to be a little bit larger. Other than that I haven't found anything I don't like. Keep in mind that I've only been using them for a week too!

Tomorrow, my buddy is coming over to do a little of the sound deadener. Our goal for tomorrow is to get the rear wall, and the sides of the access cab done. Maybe more if we're lucky!

Question is...are you on his juice regimen as well?! Yes.

I completely believe this.

I also have a Eclipse 8454 ( I think) that I purchased off of our very own Mr. ///m5. Forgot to take pictures of that, but there will be some. *M5 Edit*

SDS Mass Loaded Vinyl SDS Closed Cell Foam Box of wires and fuses. Sundown 100.2 and 50.4. I plan on upgrading the 50.4 in the future, so if anyone has a 100.4 the don't want.. And a whole bunch of SDS CLD tiles!

And so it begins... I bought a 2005 Ford Ranger back in December and decided since I finally have a solid vehicle that I trust, that I'm going to do my big SQ install. Although this is a low power system, I decided to do the Big3 anyways. I have yet to do the engine block to chassis, so I'm only at the Big2. New battery terminals from KnuKonceptz. Additional ground from battery to chassis. I've read many different opinions on whether or not to fuse the power wire, but I figure that it can't hurt. The new power wire coming off of the alternator.

Make speaker rings out of MDF. Mount your mid in those. The tweeter is going to be subjective and you should experiment with many different mounting locations using Velcro to see where you like them.

Going to kill someone with that...lol

I'm using these, love them so far. Check my build log in about 5 minutes, as I'm uploading the pictures now.

I just bought new battery terminals off KnuKonceptz and love them.

I'm trying to get pictures uploaded. My computer won't recognize my SD card.

So far all I have done is the Big2. Pictures of that tonight and of all my equipment I currently have. (Plus the game plan.)

It's all box dependent. The BL's are the choice for you though. Most rap peaks in the 40-50Hz region, so there's no reason to tune that low really.

It starts tonight.

You might want to read the article on setting gains and try to understand clipping. You may be simply over powering your sub with a good clean signal, but you may be pushing your amplifier into clipping which is dangerous for all of your equipment. You'll probably be satisfied with any of the Fi woofers in a ported box.

If I had to guess I'd say $115-150.

Just sellin' black tar heroin.

This is possible, but as Brandon recommended, pictures (when available) would be worth 10000000 words.

You have 2 12" woofer and you want to add a third? Is that how I'm reading it?

Welcome!