ProgMtl

If not maybe I'll just make a sticker and put it on myself...because I doubt I could convince to to let me swap them out once the new batch is done

That's what I needed to know...I didn't know if the heatsink/cover was attached to anything inside or not...a lot of amps can have the covers taken off to show the inside without having to take apart anything...it almost looks like I could unscrew it...flip it around so it read right...and screw it right back on...I CERTAINLY don't want to take any innards apart...didn't buy your very nice amps to monkey with them

lol no all it takes is to undo the 2 alan screws at the ends of the silver bar and to lift that bar out and turn it around Correct, it's just two allen screws to flip the name plate. My amps are showing up Monday and I think they'll only have the SAZ-1500D on one side...I want to flip the whole cover around (not just the chrome nameplate) so that all writing on the amp reads properly...does that make more sense?

I have pretty good connections...have a 260amp alternator (175amps @ idle)...a Red Top (needed the cranking amps as I don't sit and listen to it with the truck off)...big 3 done with 1/0ga...and 1/0ga running to a distro block in the back...will only be about 12" of 4ga to the amp from that...1700rms would be plenty for me...any more would simply be icing on the cake.

Any violation of warranty if we flip the cover 180 ourselves (from the pics they look the same on both sides)? I'll be getting my Sundowns at the end of the week and one needs to go with the logo upside down.

I figured it was...was just checking to make sure. Any idea what kind of RMS that amp will do @ 1ohm seeing a 14.2 voltage?

I'm going to be replacing my HiFonics BXi1606 with one of these amps...I currently have 0/1 guage running from the battery to a fused distro block that has (4) 4ga outputs...the length of the wire running from the fused distro block to the amp is about 12 inches...would it be okay to run 12 inches of 4ga to the power input of this amp?