JimJ

The last generation will, although if sound quality's what you're after they don't need anywhere near that. The SPL install I mentioned was sending them about 2.5kW, but that wasn't recommended for everyday use

To me, anything's going to sound like ass at that volume. Sound quality involves having subbass that blends well with the front stage, and unless you're trying to fill Wembley Arena 150dB is just way too much. Just a question of where your priorities lie...my point was that in an SPL-oriented install the Mag will get up there. But while you can have a woofer that does well for both, trying to get both at the same time is impossible.

The first time I heard SI Mags, they were doing over a 150 Not sure about "sounding good doing it". That install sounded like ass. But when I heard them sealed...amazing.

Eh...

I don't think you have any worries about SSA being confused for those goons.

I'd post and say "Let's see what Tang Band says", but I'm banned from the eD subforum anyway

Huh?

PE order out. Just as soon as it comes, it goes...

Whole lot of pr0n, huh...

A lot of movie soundtracks have a lot of very deep subbass. Of course, most mainstream songs that are produced today can be made to "hit" well (i.e., sound like shit) by boosting subbass to oblivion...

PE also put those chrome speaker spikes on sale this month. Wewt, I can actually take advantage of a sale for something I need.

If gas was 88 cents a gallon again it would make my life a whole lot easier right now.

If it's not a dedicated competition vehicle...meh. Not a real big fan of walls in vehicles being driven on a regular basis.

1TB with an eSATA interface for under $300 is pretty good to me. Should last a while...hopefully...

http://www.newegg.com/Product/Product.aspx...N82E16822148306 :drools:

If anything, I would replace those HTIB speakers before the sub.

For Matt... np - Deep Purple - My Woman From Tokyo

"Loud & clean" really isn't going to happen with a head unit internal amp.

Very possible.

Why is everyone so concerned with how much the sub moves in a ported enclosure? Like it matters...

Homework, pfft

You know that's going to make me go out and find something recorded with the 64-foot stop of a pipe organ down to 8Hz, don't you?

That's an installation problem...given the right setup, it's not pointless Also, once you get below the peak at resonance, impedance is decreasing...but not any more than above Fs.

What does where the gain is set really have anything to do with...anything? It's meaningless just to say that...

And destroy one of the reasons for going sealed in the first place? There's plenty of people running IB with no SSF's, it's all about being careful (and using products with enough rearward travel for the application desired)