ANeonRider

Likely not set in stone until the final revision is completed. Remember people, this is the first version aka prototype.

Very nice! Your attention to detail is awesome.

Mach5ness... unless you have stuff already kicking around. Updated the build log yet again.

More pics... Just need to do some finishing & adjust the gapping with the doorpanel. I have also cut a hole in the rear of the pod for it to be IB into the door as well. FYI. Finishing the door pods in black fake suede & the bottom of the doors in black vinyl. The top of the doors are already done in black vinyl from factory.

4+4 shit

Progress from yesterday & this morning... Tolerances are tight around the protrusion for the woofer, so it has be 'glassed from the inside.

They do, but not sure if they are available at the moment.

Ya, he used a tuning fork & adjusted the strings to suit.

If it is a 3-way front end, you can do both. My 8" midbass is going to be running only up to 300-400Hz anyways, and likely will be diggigg down to 20Hz at times & being my subwoofer.

That's not an Infinity driver, it is a DIYMA 12. I don't see any problem with it. You may be looking at a lower output vs. your TL enclosure, but you might even be able to port the Rl-i in that space.

Received it yesterday. Good packing, can't wait to install.

No, IT DOES NOT WORK. HAVING TWO DRIVERS PLAY THE SAME FREQUENCY RANGE DOES NOT WORK.

No, IT DOES NOT WORK. HAVING TWO DIFFERENT DRIVERS PLAY THE SAME FREQUENCY RANGE DOES NOT WORK.

Well, yes. It was quite obvious from the start. But, at least he fits in with the majority of people that fill this world.

Asshole mode, activated.

Stupid is, as stupid is. That is all.

It's terrible, start over.

FUCK

Women are going to turn me into an asshole.... maybe then I'll get some respect. Bitches.

what do you have up front?

here http://www.soundsolutionsaudio.com/shop

Don't mix & match please.

Quick update on the build log!

OK, after almost a month, I have more updates.... Drivers side door pod in progress.... Duct tape is the only thing that would stick... and its strong enough to make the mold with too. The mold completed. I am just waiting for it to completely cure, then Saturday I'll get the passenger side done (wedding to attend tomorrow).

Trying to clear customs myself did not work ... $49 instead of $14 now