Optimus_Prime

It was moving silly amounts of air had the one sub wired up to 2ohms at about half volume, with amp at 1/2 gain, cant wait till i get my other one and the enclosure, The one Xcon was as loud as the 2 12" hx2's when i compared them, of course at the time the con was getting more power but still I was impressed. LOL the box i put it in has a lil 3" id port these are gonna be ridiculous. So far the Rubicon seems to be pretty stout.

A quick vid firing up the amp messing with the Xcon.

ABQ18WHEELER TDM Black ops 15th prestige.

Anyone know of a good priced agm trickle charger, kinetik 2400 has been sitting for some months now without charge and is pretty damn dead, kept making the alt default to a lower charging status, charge on car starts at 15.1 then drops to 12.6 floating there after the big load overheats my alt.

Going to use a low level to rca till i can get a deck, my question is should i run it from the factory sub leads or just a reg speaker lead, I do believe the factory is amplified, or at least the factory sub for sure.

Ya sorry guys pic is pretty raw, wires are not in their final positions, will clean it up when everything goes live. Using all blue cable with black tape on negs and red on +. bought a 50' spool of the blue kicker Hyperflex, so its all blue. Kind of like the fact that my subs and amp both end with Con. RubiCon Xcon.

No i do not.

Number 2 With some enhancements, really like the reflective effect on bottom of logo.

Wanna do some comps eventually. Having a hard time deciding how to do the box, i mean as far as rear firing ports sub placement etc, Going to have a tune of 31-32hz wanna do the low end monsta thing. Ive got a cracked windshield and im hoping when im done and ready to go, make a vid to see if the setup will finish it off.

The hole which i ran it does not share the wire harness for the doors or anything it was a blank hole with a plug, I assure you i will insulate the wire where needed, and as of right now the wire is not even live.

Couple pics of interior Leather and suede, and paddle shifters. Need to clean it up a bit.

Wire was ran through factory hole that had a plug in it and the metal has a smooth rolled texture to it, however i will be doing some precautionary insulating at a later time as well as plugging the hole around the wire, and if something happens i hope the whole purpose of having a fuse gets put into play, Good looking out thanks Julian.

I have 2 runs of equal length kicker 1/0 both fused from my previous setup, I think i will be fine with one run here what do you guys think. Running one Rubicon 2500d with stock alt stock batt with one Kinetik 2400.

Some pics started with The wiring. Using All Kicker Hyperflex 1/0

Ya i will be posting some pics of the install soon, getting a box built by Argent, and going to order my other Xcon hopefully this week, Also gotta finish wiring the car and installing the other battery.

I have no experience with FI, and am not liking what i am hearing. Good luck with your troubles.

1399.00 Kicker warhorse.

Will do, maybe even some photos etc.

That should work, but i recommend buying a lil more than you need just for running into unforeseen obstacles, Example: having to run wire on opposite side of the battery in the engine bay etc. Better to have more than not enough.

For the fuse I think you should get a 120 -150amp fuse.

Ill take you up on that free shipping, Ordering fleece and beenie now.