Hey I am just wanting to clarify that this box design meets the specs that I was told.

This is for "1" 15" Fi BTL.

It was designed to have 4 cuft. tuned to 35Hz.

(Calculations done by BKOLFO4)

The box with a slot port will need to be 17" tall in front, 14" tall in the rear, 31" wide, and 23" deep.

The slot port will be 12.5" x 4". You will run it into the box until it is 4" from the back wall, and then turn and go 2" parallel to the back wall.

(Designed by BKOLFO4)

Like this (note the port dimensions are internal dimensions):

Thanks in advance,

Curt

wrong area mod should move

thought i could get an answer from a guy who builds boxes sorry

I have a line up of orders pre paid at the moment so time is an issue for me

there are others on this site that are more than willing to help with your situation

I have a line up of orders pre paid at the moment so time is an issue for me

there are others on this site that are more than willing to help with your situation

I dont want it made, I just wanted someone else (as in expert in making boxes such as yourself) to check to make sure that these calculations are right before I go onto making it.

Sorry for any confusion,

Curt

Moving to Fabrication section.

Hey I am just wanting to clarify that this box design meets the specs that I was told.

This is for "1" 15" Fi BTL.

It was designed to have 4 cuft. tuned to 35Hz.

(Calculations done by BKOLFO4)

The box with a slot port will need to be 17" tall in front, 14" tall in the rear, 31" wide, and 23" deep.

The slot port will be 12.5" x 4". You will run it into the box until it is 4" from the back wall, and then turn and go 2" parallel to the back wall.

(Designed by BKOLFO4)

Like this (note the port dimensions are internal dimensions):

Thanks in advance,

Curt

I got 4.228 ft^3 after port displacement before sub, tuned to 33.5hz