Ok so how do i wire my speaker wires from my box terminal to my amp just - - and ++ this is for 1 ohm

you just wire the positive wire to the positive, and then negative to negative. but if your talking about how to actually wire up the subs it depends on which coils you have d1 or d2?

but this should help you out a bit but it doesn't have d1 ohm on it, but just follow the patterns and you should be able to figure it out

http://mobile.jlaudio.com/support_pages.php?page_id=161

that is what your wondering right?

Edited March 12, 200916 yr by wetapoo

Do you have the options not to use the terminals?

I find the add resistance and cause problems.

Do you have the options not to use the terminals?

I find the add resistance and cause problems.

Must be some crappy terminals to add noticeable resistance.

Do you have the options not to use the terminals?

I find the add resistance and cause problems.

Must be some crappy terminals to add noticeable resistance.

Might have been

Best way and most efficient way is to go directly to the woofer.

How are we supposed to help you if you don't tell us what sub and voice coil configuration you have?

Sorry my internet went out. I look at it again and figured it out.