Sorry im somewhat new. done quite a few low end systems, but not familiar once it gets into amps and stuff. so any help would be nice.

I put in my order for a 12" SSD with Copper. i have a box that I built for the sub at 1.1 sealed. none of thats the problem. my question/problem is in the amp. I recently bought a Kenwood 9104D, and wanted to continue using it but not sure if its overkill. Was thinking of running my 12 at 1 or 2 ohms as my amp is 1 ohm. but spec wise it runs higher RMS. it runs 900W RMS. im pretty sure, just becuase an amp "says" it puts out a certain amount it doesnt put that out all the time. so technically it shouldnt matter? but im not sure, thats what i need help on. plus i was told Fi's can take quite a bit of extra wattage.

Any help or insight would be greatly appreciated,

Spyke

Edited April 9, 200916 yr by spykexx

that amp would be fine..

It'l be fine!

Thanks!

Nick

thanks guys. just had to make sure, didnt wanna kill such a fine piece of work =]

plus absolutely everythign that can go wrong with this audio setup has lol