Ordered my amp! It's an old school Soundstream Tarantula monoblock. Specs are as follows:

Continuously Variable Low-Pass Crossover

Three Stage Level Input Indicators

Output Clipping Indicators

Phase Inversion Switch (0 - 180ﾺ)

Selectable Differentially Balanced Line Inputs

Fully Balanced PS-2 Input

Line Output

Gold-Plated 1/ ? Power Connectors

Discrete Balanced Class A Drive Boards maximize linearity on low impedance loads

Drive Delay 2? eliminates "turn-on" and "turn-off" pops and noises

Chassisink? Semiconductors are situated between the circuit board and

heat sink for optimal thermal transfer

Power Grid? design optimizes current delivery to and from the power supply

Tone Sweep Calibration optimizes the power supply to the connected speaker load.

All chrome plated

NUMBER OF CHANNELS 1

OUTPUT POWER (WATTS):

RMS @ 4 Ohms 2000 @ 12.6v

RMS @ 2 Ohms 2000 @ 14.4V

T.H.D.: <0.02%

FREQUENCY RESPONSE (Hz): 20 - 500

SIGNAL TO NOISE RATIO: >86dB

CHANNEL SEPERATION: >60dB

DAMPING FACTOR: >500

INPUT SENSITIVITY: 300mV - 5.0V

CROSOVER SLOPES: High-pass/Band-Pass 24dB

CROSSOVER FREQUENCIES (HZ): Low-Pass 35 - 500

HAWKINS BASS CONTROL (SUBSONIC POSITION): Variable High Pass (no boost) 13 - 30Hz

HAWKINS BASS CONTROL: (On position)

Variable Bass Boost 30 - 70Hz

Variable Bass Boost 0 - 9dB

DIMENSIONS (INCHES) : 19 x 14 x 5.5

Edited May 7, 201015 yr by johnecon2001
fixed pictures

dam how do i get the pics to show up? lets try this.

much better

Edited May 7, 201015 yr by RaTtLz

Fixed your first post

Fixed your first post

Thank you! what do i need to do in order for it to work the first time?

Nice Amp-I remember those in the day along with the Davinci. Hope to see pics once you get it installed.

Fixed your first post

Thank you! what do i need to do in order for it to work the first time?

Your pictures already had the tag wrapped around them. There was a second set on each picture that was basically canceling out the embedding process.