I Have a fully loaded BTL 15" Running on an SAZ-3000D

my question is will getting another one make that much more of a difference?

since they will both be running off the same amp.

Eventually i plan on getting another SAZ-3000D when money will allow

but since i only have 1 3000D

will sending 1200-1500 watts to each be louder than if i sent 2500-3000 watts to 1 ?

The 2 of them off of that amp will be fine. It should get a lot louder with double the cone area.

Shit a BTL off of 300watts will get plenty loud.

Ok i thought cone area would make a difference. Just didnt know since the power would be cut in half and splitted between the two.

Thanx rodney

What are you running your current BTL at ohm wise on that amp? 1 ohm? You'll need to get a recone in order to run the amp at 1 ohm again.

My BTL is dual 2

and i have it wired to 1 ohm on the Amp right now.

that amp should run @ .5 ohm with a good electrical. so i say get another