i was looking into getting a new system i looked at this amp an re audio vlx 3de and running two subs. i know it would split the wattage between the subs but how do i wire the subs to this one amp? any help i know its a stupid question but it still confuses me.

What are the impedances of the woofers?

d2 is what i would get.

What would your final load be? 1 ohm?

To get down to a final 1 ohm load you would have to buy either dual 1's or dual 4's

i guess what im needing to know is how u connect the wires from to the other sub to the amp.

What ohm load do you want to run the amplifier on? 1 ohm, 2 ohm, 4 ohms?

one ohm i mean i understand the wiring part but i just dont understand what people use to connect the wiring going from one sub to the other sub then to the amp. do they splice them then solder them together or what?

Edited October 9, 201014 yr by bjballar41

one ohm i mean i understand the wiring part but i just dont understand what people use to connect the wiring going from one sub to the other sub then to the amp. do they splice them then solder them together or what?

just have your standard 12 gauge wire going from amp to the first sub and then just use 12 ga as a jumper to the other terminals

ok gotcha thanks.