this is pretty much what i am trying to do.. red ill have a few questions for you..

ill wanna do it with a twist but this is pretty much the jest

http://www.youtube.com/watch?v=tLlC6c17IB8&feature=related

here are the max number for my trunk im trying to figure out if whats best 3-4 SA12s or 2 15 nightshades. subs up

the picture on the left hand side is a top view the line shows where the box Ls shows on the side view.

any advice or even somone that can figure out how many cubes somthing like this may be

thanks guys i know im a retard when it comes to wood.

birthday bump

Jon, I can't really tell what dimension goes with what, but to simplify separate it into two boxes. Then just do X*Y*Z/1728 = cuft. Add the two together and you are set. Make sure to subtract the dimensions of whatever material you are using and then realize you will still need port room, but that should give you the right idea.

8.6849 + 3.63759 = 12.32249 with .75 MDF kinda guessing what you meant.

use this to calculate your ft^3 http://www.the12volt.com/caraudio/boxcalcs.asp#wed

2-15s (353.25 cone area) 3-12s (339.12 cone area) 4-12s (452.16 cone area) so if you had the room for any of the listed the cone area of 4-12s would be the most. Like m5 said its going to matter most on calculating what your going to need/want/use for port area obviously doing 2-15s 100% right vs trying to cram 4-12s in there with limited port (basically cutting corners) is going to be the best idea. Doing something Half A$$ will more then likely never give the results your after.

Edited December 5, 201014 yr by jmanjr

thanks, guys..

im still in the dark i know i know.

i was thinking the same lines as far as not to cram it in.. thats why i was thinking 3 12's aswell.

i may just have to build it and see what happends.

If the choice was 3-12s done right or 2-15s done right I dont think there will be much audible difference. Best of luck though