i have a quick question...

i bought a dual 2 ohm Fi BL

i want to wire in to 1ohm so i can get 1500wrms out of the SAZ-1500D to the sub

can i not do that..can i only wire the sub to 2 ohms not 1ohm??

Edited June 20, 200718 yr by Ryan R

A single Dual 2 ohm speaker can be wired to a 1 ohm or 4 ohm load.

A single Dual 1 ohm speaker can be wired to a 0.5 ohm or 2 ohm load.

If you're using multiple speakers, then the possibilities grow from there.

Dual 2 ohm sub can be wired either to 4 ohm (series) or 1 ohm (parallel). You could also of course only excite one of the two coils with half the power of the subs ratings and have a completely different sounding woofer as well-yields a 2 ohm load.

It couldn't have taken me two minutes to type that....but DD's response wasn't there when I started.

can someone give me the wireing directions to wire my BL 2ohm sub to a 1omh load....its a mono amp..

Parallel.

voice coil (1) positive to voice coil (2) positive. voice coil (1) negative to voice coil (2) negative. basically run a wire from red to red and black to black. then run a red wire from one of the red terminals to the (+) side of the amp. then take a black wire and connect it to the negative (black) on the same side as you connected the (+) to and run it to the (-) side of the amp. if you need more assistance go to crutchfieldadvisor.com and go to woofer wiring options.

+to+ & -to-

go here :

http://www.crutchfield.com/learningcenter/...mp;amptype=mono

do that just ignore the 4ohm part! that should help! let me know if i can be of anymore assistance

voice coil (1) positive to voice coil (2) positive. voice coil (1) negative to voice coil (2) negative. basically run a wire from red to red and black to black. then run a red wire from one of the red terminals to the (+) side of the amp. then take a black wire and connect it to the negative (black) on the same side as you connected the (+) to and run it to the (-) side of the amp. if you need more assistance go to crutchfieldadvisor.com and go to woofer wiring options.

You beat me to it.Also explained it.What he said ^^^^^^^^^^

sweet thanks guys...and one more question..to link the (+)-(+) and (-)-(-) on the sub can i use 12guage speaker wire? is that big enough?

That'd be fine.

cool! thanks everyone for the help!