Jump to content

suicidal

Members
 View Profile  See their activity

  • Content Count

    39

  • Joined

  • Last visited

Posts posted by suicidal

  2. Posted

    the amp i have is a rockford punch 201s

    specs:

    50 watts RMS x 2 at 4 ohms

    100 watts RMS x 2 at 2 ohms

    200 watts RMS x 1 bridged output at 4 ohms

    stereo or bridged mono output

    4-ohm stable in bridged mode

    Tri-Way capable

    120 Hz high-pass, 80 Hz low-pass crossovers (12 dB/octave)

    selectable Punch Bass (0/6/12 dB boost at 45 Hz)

    speaker- and preamp-level inputs

    10-1/8"W x 2-7/16"H x 9-7/8"D

    0

  5. Posted · Edited by suicidal

    I have a 1994 GMC Jimmy 4-door. I am looking to replace my factory speakers. I have 4x6 speakers in the dash (not sure of mounting depth, could not find that spec. anywhere) and according to my research 6 3/4" in the rear doors (again not sure of mounting depth). This will be the first time i go with components or run the speakers off of anything but the head unit. I will be using an old rockford 2 channel amp to power the speakers, it is 100.2 (if memory serves).

    I need help choosing speakers to fit in the stock location. I would like to keep the cost ~$200, but i can go more if need be. I am open to all suggestions since i am a noob when it comes to this. So any suggestions are greatly appreciated. Also, any amp suggestions will be entertained. I'm not married to the amp i have. As soon as i dig it out of the garage i will post more accurate specs for the amp.

    For my subwoofers, i will be using a single RE SE 12" dual 4 ohm ported in a 2 cu ft box tuned to 32hz. I'm debating putting both of my RE's in the truck, but am not sold on using up all of my hatch space with a 4 cu ft. box. :rofl2: I also need an amp to push the subs, so any suggestions on that as well. The subs are 600 watt RMS each.

    Thank you in advance for any suggestions.

    0

  8. Posted

    I figured i would start one of these since i'm a n00b to this forum. I've been into car audio since my teenage years, and I know my way around installing the basics, and have even built a few slot port boxes. But, i joined this forum in hopes of learning more. There is a wealth of information on this forum, and i am trying to soak up as much of it as I can in my old age (ok, maybe i'm not that old). LOL.

    0
×