Jump to content

tc3k101

Members
  • Content Count

    33
  • Joined

  • Last visited

Everything posted by tc3k101

  1. tc3k101

    Rlp motor?

    Hi mike I am looking to see if you had any Rlp motors hanging around with triple .75" slugs? I am building a lms 10" and am hoping to make a matching driver but cannot find a motor to save my life I'd like to buy one if so. Please send me a message with contact info Here is my motor I am looking to match
  2. This is my little build log on my car. Equipment Pioneer 880prs Fusion PP-AM300010 Fusion PP-AM60020 Kicker 04ss65.2 components two runs of 1/0 hyperflex All kicker speaker wire I will be switching it up from a 10" Eclipse TI to a 15" 3hp if and when i decide i want to do that. Stripping the car New Engine Big 3 done Wires ran Trunk Lid with a few layers of Raamat. I do plan on adding more of it and some Spectrum Sludge Car Interior going back in
  3. you deleted the pics. can u please re host them
  4. tc3k101

    06' XXX 18" Can anything beat it?

    i believe the newer xxx has the highest linear excursion, dont quote me on it though. but its not all about xmax, doesnt this driver use a split wound coil too?
  5. tc3k101

    Sub Comparison pics

    18" trf vs 10" 3hp 18" is in the process of being reconed so bare with me
  6. tc3k101

    Sub Comparison pics

    10" tc sounds 3hp proto vs 12" trf 15" tc9 with 1" slugs vs 10" 3hp proto 12" EHQS vs 8" EHQS
  7. tc3k101

    I cut two fingertips off today

    so what did you learn? and did it hurt? lol jk man i would have dried like a girl and not taken pics
  8. tc3k101

    New guy here

    some of you have prob seen me around other fourms. just though maybe its time i join up on here. this forum seems to have alot of good things to read up on. ive read up on some ie devil drivers linear bl tech comparison thread. setup is in the sig
  9. lol, sucks but hurry up! i want this done with some good results
  10. do two runs of 1/0 awg 1 for ground and 1 for power or just ground to my chasis? i dont plan on running a ton of power. around 2000rms total. i do plan on adding a couple batteries though. i already have a run of hyperflex for power and picking up another 24ft in a few hours. i know running the ground to the batt has less reistance than a chasis ground but would i really notice anyhing between the two with such little power? if i dont do another run i can do my big 3 today, but i would rather do two runs while my car is apart than doing 1 run and big 3 and come back and tear everything apart again.
  11. well at this point in my life money is the issue. im trading my old cd player for the 24f of 1/0awg. i got lucky i guess.
  12. i know it wouldnt hurt but is it needed? if it isnt then i dont need to buy more wire for my big3
  13. wow those indeed look beefy that massive is uber long. i had a visonik too and never realized how long the massves are. subscribing to this forsure
  14. tc3k101

    Infinite Baffle pics and vids

    The IB3 is for "true" IB applications, not "fake" car audio. True infinite baffles require the driver to be in 25 times it's Vas. The IB3 18 Vas is 13.8 cubic feet. My trunk is less than that(let alone 25 times that), therefore my trunk would be a chitty leaky flexing sealed box, nothing close to an Infinite Baffle. That asside, I don't choose my drivers by being labeled "IB" or "sealed only" or "SPL". I choose my drivers by Thiele/Small parameteres. It has a low Fs, low inductance, high Xmax, and enough power handling to reach it's potential if I put it in a large enough box and tune low enough... exactly why i chose it. agree with you, but most people dont know what the tsp's are for sadly. and op why would you want vids? i/b setups dont have heart pounding bass if thats what you are looking for.
  15. tc3k101

    Infinite Baffle Wtf Is That? Car? Home? Pro?

    i was about to say i thought it was 10x the vas. nice right up forsure
  16. not a seat belt close. would the seat belt have less resistance than the batt? doubt it but would it be close?
  17. sorta noob question but ive never had this particular predicament before Would it be ok to run 4 awg from the ground on the batt to my amp and run 1/0 from the+ batt to a distro to my amp. i know the ground and power have to be the same awg when putting them into a amp. my car has a very poor ground in the trunk and this option will save me some money an time until i can get more 1/0 to run from the front to the back. my amp has 4 awg inputs so would i be ok doing this since i would be using both 4awg for ground and power. i do plan on upgrading the the gound to 1/0 since im goin to add a few batts but this is only temp for maybe a month.
  18. i dont think i have enough 1/0 for that. basically what im asking would it be ok to run a straight 4awg ground since the amp is getting a 4awg from the disro. sorry if im frustrating but im really confused
  19. no batts in the back yet. thing is mustang have very poor grounds so i dont want to ground my amp in the trunk anymore.
  20. tc3k101

    Parts Express 1000w sub amp

    not to be a jerk but im not a fan of those amps at all, and this is coming from personal expierence. they dont do know where near rated. Just not worth the money you drop into them.
  21. tc3k101

    Infinite Baffle pics and vids

    you have to totally seal it up. rear deck everything
  22. tc3k101

    Sub Comparison pics

    ^^^^ my subs pics not taken by me
  23. tc3k101

    Sub Comparison pics

    12inch tc 3000 15inch tc 3000 neo
  24. tc3k101

    Sub Comparison pics

    15" Adire Audio Brahma MkI vs 15" Tc Sounds lms 4000 12" tc9 vs 15" tc 3000 8" ed ehqs vs 12" tc9 vs 15" tc 3000 15" Adire Audio Brahma MKI vs 15" Audioque hd315 18" tc 5200 vs crunch amp would have more pics vs other subs but my camera broke when i got this sub:( two rli8 vs 10" tc 3hp proto vs 12" tc9
×