PRV Audio

• Neodymium radial slug motors for extreme speaker control and sensitivity • Full copper pole-piece sleeve for low distortion and inductance • Durable cast aluminum frame A bumped backplate, vented pole piece, vented magnet assembly, Kapton® former, and treated-cloth surround allow for high power handling, while protecting this driver from extreme transient power peaks. Available now at SSA Store: http://store.soundsolutionsaudio.com/products/prv-audio-5mr450-ndy-5-inch-8-ohm-mid-bass.html http://store.soundsolutionsaudio.com/products/prv-audio-5mr450-ndy-4-5-inch-4-ohm-mid-bass.html http://store.soundsolutionsaudio.com/products/prv-audio-6mr500-ndy-4-6-inch-4-ohm-…

I had a chance to pick up some 8 in midbass with the cast basket for super cheap cause of a coupon threw parts express, well best decision I've made in a while. So the first day I got them I scrapped my door pods for 2 6.5's per side and modified the factory location to fit an 8in mid. I was blown away with the difference in sound it made. More midbass and depth than the pwx 6.5's. I'll chime back in after they break in. So far they Are running on 50rms per driver high passed at 63hz 12db slope and no lpf until more power is applied. I'm highly pleased as of now. Definitely a great buy.

I have a set of Sony XS-GS1720S 6.5 x components that I put in my Focus over the summer running off the stock Base headunit. The drivers side woofer has blown. I am looking at the PRV Audio 6MB200-4 6.5 Inch 4 ohm Mid Bass as a replacement for the Sony midbass speakers but still use the Sony crossover and tweeter. I plan on adding a second set of components to the rear doors and getting a decent 4 channel amp to run it all a little later down the road. Would the prv's listed above be a decent replacement for these Sony's in all the doors. Or am I looking at the wrong speakers?