US Acoustics

New 12" Subs will be ready for shipping by July 1 2016. Features: Diameter: 12" 300mm Basket: die cast aluminum Cone: non pressed paper cone with high foam surround Voice coil: 4" 4layers with winding height 60mm CCAW flat wire Magnet: 3*100OZ φ220*20mm triple tacked Nominal impedence: dual 2ohms RMS power handing: 1500w

Mike Nichols, of the original US Acoustics, (think USA series), has brought the great name back. The "Mike", a 1500@1ohm mono block and the "Barbara Ann" a 4x100 A/B multi-channel are the first offerings. Larger monoblocks, a small 4 channel, and some 2 channels are planned. More info will follow soon. You can check out the first two models here: http://store.soundsolutionsaudio.com/categories/amplifiers/us-acoustics.html

I noticed that the big ben amp calls for a 400A fuse, however it only has single 1/0 input terminals, that seems like its pushing it a little. Considering a fuse of 400A could sustain likely more current for much longer than music typically peaks. Most other amps I see with a single input were using between 200A and 300A fuses. Were you having issues with the amp blowing lower rated fuses? Since I typically fuse my 1/0 runs with a 300A ANL fuse, I was just going to use that and see if it pops, but if you think it will blow that out of the water I'll save the fuse and order something bigger.

When will you have stickers available so I can put them where my other stickers use to be?

Is it more like a gain or a bass boost attenuation? I presently use the level control for my sub out of my DSP which works really well, but I was thinking about having the big ben knob assembly up front at least for the clip light, not sure yet. If it works like a level control I might be able to use that in place of my dsp control but not likely.

I would recommend the Barbara Ann amp to anyone looking for a great value amp with all the features. Makes my system come alive.

When will the bigger class d amps be available on this website.?

US Acoustics will be at Slamology 2016 June 11-12! Come by our booth and say hello.

Just got my big ben amp delivered, was is supposed to come with this: (from your website) Docking Pads® to reduce vibration and extend the life of your amplifier also my remote knob and the power terminals are already nicked up and its brand new out of the box.... https://lh3.googleusercontent.com/SZwf4pAqQkfFH2x9zPmgxBLRwd5Gtfu7GkZzt9f7ASQ=w561-h747-no https://lh3.googleusercontent.com/cXetjzzcpErJC1-PzaCOsWig4z7CpbNUqdNcxcDXp1Y=w561-h747-no sorry my cellphone camera isn't great in very close range in low lighting, but you can prob see some nicks/scratches, its more prominent on the top where the wires get tightened on the second pic the barbara ann also missing …

Where do I set the x-over switch on 3 & 4 when bridged. I have had people tell me mono. The manual says stereo. Which one is correct?

Hope to see everyone at Slamology 2017 Stop by our booth and say hello

Your specs at ssa say 350 @ 4 ohms. The manual says 400 @ 4 ohms. Which is correct? Not that you will hear the difference.

Check out the new review on the Mike Mono block amp. Thanks Justin Rock On!

You should have one that looks like the logo on your amps.