Test 1, 2, 3...

Not really sure what I am asking here but here goes. I am running a TC3000 15"DVC sub. Each coil is 2ohms. I am running this parallel to a SAZ1500d for a 1 ohm load. With no music this specs out at about a perfect 1 ohm at the box terminals. Now whem I measure resistance while music is playing using my trusty calibrated Fluke 87 DMM, The lowest I am seeing resistance-wise is above 3 ohms. It never gets below and of course we are not going to discuss the high point. This is all done on a 60-20 htz sweep. So one of my questions is, does this mean that my sub is at most only getting 500 ish watts? I suppose what I need to do next is measure voltage and current. Was just doin…

I am taking a little vacation since I keep posting diarrhea.

Yes the donor has been found. Now they just need the cash. Insurance pretty much bailed on the family since this surgery has not been done very many times. I believe they classified it as ''experimental''.

Good show attendance and scores don't hurt: http://mecacaraudio.com/memberpoints.aspx?...memberid=390028 thank you, i try to give back to the community... kinda dropped off at the end of the year due to rebuilding the system ^all those scores was with 2 L7 15's and ZX1000.1

tell me this...if the w7 is so over rated...then why the does unique whips and all the infamous sweet whip car shows on tv install them??

you know...ive looked for jackhammer's before, i know mtx makes them right...? what is the specs on them? and where do you purchase them

Availed USED AMPS updated above! Four 1500Ds and Two 100.2s available. B-STOCK Nightshade 12s still available!

Can't go wrong with some Late Night Tip...welcome to the site.

You guys really are nuts, I wouldn't have wanted any of that in my dorm room Heck, we didn't even have a TV...used to go to our neighbor's room to watch it.

wrong place

cell #910-520-5213

Can anybody tell me about DB Drive amps are the any good

nvm...

Not hatin or ne thing but once that kid gets his car.. He will relize how much car audio really is when he has to pay for gas and other expenses.. Unless his parents will pay fer everything.. I found out the hard way by paying for everything myself.. He will find out once he turns 16 and gets his first whip.

Here is what full clipping sounds like. Use this function generator. Listen to a 60Hz sine wave (unclipped) and then listen to a 60Hz square wave (this is full clipping). This is a gross example, but you wanted to know what clipping can sound like.... http://www.marchandelec.com/fg.html

jim-j

spam

Awful thats what that is... just awful.

i ran a saz 3000d on my 2 15 bl's

wrong section please delete

I'm sorry that you couldn't understand. Is this better? It's not like I'm writing an paper for school. I would still like some feedback please. I thought this was a reasonable question. Either you have 2 18's with 6 cuft a piece or you have 3 15's with 4 cuft a piece. The 15's are rated at 2.8-4 cuft @ 28-33Hz per speaker. The 18's are rated at 6-10 cuft @ 28Hz per speaker. If I only have 12 cuft to build a box then I need to know if 3 15's in optimal conditions would be louder than 2 18's with less then optimal conditions. THANK YOU to everyone that helps me out.

spam

wow in all this im surprised nobody offered the idea of a nice fiberglass or carbon fiber enclosure. they look incredible painted to match the car are very strong if done properly and the lightest enclosures you can make

circular reasoning? are you in politics?