Test 1, 2, 3...

Finally... Ok, to set things straight here, this unit was sent to Stratus from someone who promised to perform a full review but never followed through. After several months, I finally asked the man to forward the unit on to him so Stratus could follow through with a proper testing. The pictures Stratus posted warrants clarification so those who read this can fill in the blanks: 1.) The SPL-12 is wrapped in a thick plastic bag with four layers of cardboard that sits over the surround. It is then topped off with a flat cardboard piece to protect the cone. 2.) The SPl-12 comes with an aluminum trim ring for owners to switch out with the rubber gasket. It is normally pl…

hi

I don't hold items, but contact me at that time and I'll let you know if I still have any.

New items added.

We went through this before. Take another 24 hours to think about what you are doing and read the stickies. The next time you do this, you will be gone for good.

Exactly I only want 1. And Dual 2 Ohm can only be wired to 1ohm & 4 Ohms loads. Where Dual 4 Ohm can be wired to 2Ohms.

Still plenty to go around... for now!

...I'm Confused.

Yup. I just don't see the infatuation with wanting to modify production drivers. Some ideas may sound great in your head. I think the design engineer knows best though. . nG

practice subs

x2

I ask questions so people can get answers, most are predecided and want someone to just reiterate what they like even if it is the wrong answer. I won't do that. It's not the questions; it's the firm opinions on configs/gear that you've never heard. That doesn't exactly make one credible. Exactly why I rounded down to 10lbs or 66% of the weight of MDF. It won't be quite that light though. .9 came from ID direct: http://www.imagedynamicsusa.com/manuals/iD/ID8D2%20V.pdf .35-.45 is recommended. I used the lower of the two and then added the volume of the two drivers which gets us to .8-.9. I did read that you said .6, but again you ask to have a nice sounding system an…

any updates on SD amps for sale?

I try the polyfill and see how that sounds. Also how much power can i safely give the sub right now it getting about 870watts? Also dbjunior i see u have a Q ported did u ever have it sealed and if so which did u like better?

Thank you. Lock the thread.

so if a engine runs .5 Hp @ 29,000 RPMs can I just simplify that and say it produces that power in one cycle?

Are you making sure to subtract port volume from box volume before getting the port length?

the woofer is dual 1 ohm.

Dude, this is a home audio thread.

Should I get fogs in HID too?

i dont think that you can... http://www.the12volt.com/caraudio/woofer_configurations.asp Yeah actually you can.

didnt we do this topic already.... that amp puts out more then 960 watts... and i know it was another topic... but someone else wanted to run a sub and 2 6x9's on one saz 1500 D

Thanks!!!!