General Audio

I have 2 alpine type R 15's. They are both dual voice coil 4 ohm. I wired them both in parrell to get a 1ohm load to the amplifier. My question is I have a 1500 watt class ab 2ohm stable amp until i can get anotha amp. Can i still hook up my 15's even though it will be 1ohm load.

Hi, I am new to this sight my name is tony.I have a couple of questions that i need help with.My car is a dodge charger (05),i want a windshield flexing system my favorite sub is the FIBTL im going to be running two 12 inch subs any amp suggestons?

can you put a pair of AQ3500 on apair of fully loaded FIBTL 15 i know thats 7000 watts but there pricing is very good and would it get loud with them amps my goal is SPL ? thanks foe any answers

my trunk is 19 inches high 42 inches deep 52 icches width now i have room for amps and batts thats the space im worling for subs thanks for any help?happy hollidays to all....its a chysler 300

is the audioque 2200d a good match with the 15 inch fibtl?has anybody used or heard this amp?

ok well i hooked up my new rw and blew my amp after 2 days and i put a new amp on it and it has ground noise and i tryed another amp it still had ground noise i redid my ground new washer and such and looked at my power and remote wire and i still have the ground noise can you help me thank you

Well, on the Fisher Customs site, there is an enclosure for sale for a HDC3 15", 4.02 @ 36 hz.. Then I look at their loaded enclosures and there is the SSA ICON 15", 4.0 Cubic Feet, Tuned to 32 hz.. I'm going for something more SPL, based. I love the lows, but I also like the sub to be able to go through the higher ranges nicely too. So I'm not too sure which to go with? Any opinions and experienced users of either with some stories would be nice. Note this will be in a Honda Civic 2005 coupe, I will do what I have to do to make the box fit... but if anyone else has a Civic I'd like to now how easy it is to fit 4.0 cubes in the trunk. I will be swapping vehicles after the…

I have 5.38 cubes after displacements other than port. My tuning is 32hz. I have an 8'' port going 12.75'' in the box, 12.75'' is my limit because I want 8'' of clearance from the bottom of port to bottom of box. Anyways, I have 12.75'' in and I have 7.8'' out of the box for a total of about 20.6'' of port. The port inside the box takes up .38 cubes so that leaves me with 5^3 inside the box after displacements. I think I have too much port length on the outside of the box, but I can still cut the port down. Any idea on what it should be?

As the title says Where can I get remote wire? Is it possible to get it without a car kit? I need to connect my new Sundown amp but I dont have any remote wire lol

Does anyone know the weight of the saz4500 and the saz100.4?ive looked but cant locate this information.

I am a Mecp advanced level installer working on my masters certification, and I was just wondering I work for Best Buy and the certifications are mainly for pay raises because you make a lot more if your certified. Anyway my question is how much does the certifications matter outside of buisness like Best Buy. I have looked at a lot of job opportunites and none of them really seem to care if your certified or not as long as you can install.

Sup, Everyone been out the lime light for awhile now, well funny thing happened today. First things first, been mia, cus someome took my system last year about this same time. So jumped on craigslist and there my sh** wuz right there looking at me, a box w/ 2 dc lvl4 beefed up w/ lvl5 coils, 12's that is ,box 3.24^3 per sub tuned @ 32hz, and a saz 1500d, for $350. Called dude here in town showed him the pics. on my phone of the box and subs. wanted to argue about it but he bought it from someone last year, paid the cash got my system back but, just doesn't feel right, had to do it tho, fool didn't even know what he had, had to get that back mad and grinning at the sameti…

whats the diffrent sound between a pair of nightshade 15 hooked up to he saz3500 compared to 2 of the ssa icon hooked up to that same amp?

When making a box can the whole backside of the box be made of plexi i really like when you open the trunk and see the magnet..

ok i 2 alpine type rs dual 4 ohm voice coils. i have 2 cadence txa750ds.....you can hook them together to get more power...but my problem is that when you hook up the two amps it can only handle a 2ohm load...bbut if i hook up just 1 amp it can handle a 1 ohm load......so what iwant to know is should i bridge the 2 amps and run it at 4 ohms or should i just run 1 at 1 ohms....there is no spec for the amp if its bridged with a 4 ohm load..............thanks

Thinking of running 4 FUSION REACTOR 4" Coaxials http://www.fusioncaraudio.com/north-....aspx#addninfo, 2 in each door. I want to make a plate to fit 2 in each of my factory 2003 Mazda Protege ES 5x7 positions in my front doors. Will be running them off a DSC450 bridged, so 100 watts rms a set. With 2 Kenwood KFC-ST30 tweets in the factory mounts run off the deck, 22 watts rms. No rear fill, gonna leave 6x9 holes open. I want to try something different, tired of just replacing factory speakers with same size upgrades, but not ready to do full blown door pods yet. So, what do y'all think? I think it would be nice and loud yet crisp. Not really anal about having alot of mid…

i was browsing through the internet at different car audio companys and i saw one called audioque and a 3500 watt amp for 549 does anyone know much about this product?

i measured my trunk i dont know if i did it right ,from front to back its 46 inches the height is 19 iches and the length 42 inches and then more towards the back of the car trunk its 56 inches if youve seen a chrysler 300 trunk then you know what i mean.i wanted to know if i could fit 3 xcon 12s in there i know zero about boxes anything will help...thanks

does anyone know of any soundoffs or any car audio shows coming up in the next few months or so in phoenix az?is there any sites that list that information i always miss them..

when doing a system in a trunk whats the best way to get the sound intko the cabin so its not stuck just in the trunk?can you make a cut out in the rear deck?

Okay I think I finally figured out what I'm going to get for my boyfriend again but I'm not exactly sure what kind he needs. I am looking for a clamp on volt meter. He just got a craftsman one but it isn't very good. He said tthe kind he wants is I guess really expensive. please if you know anything about volt meters....good ones please help me out! =] thankss

i live in Phoenix Az and i am gonna start ordering my equipment but all we have is little shitty shops out here who never heard of ssa or sundown does anyone know of any installers out this way?Even a little travling distance from me ...

would the saz 4500 be way to much for two 15 x con subs?The reason i ask is i know i can get 2 fibtl and be good but i like and support ssa subs i have a chrysler 300 and as far as i know i can get 2 subs in there,and i love the price on the 4500 i know people are gonna say the saz 3500 will work but i cant pass up the saz 4500..can the subs take it and will it be loud?

Hey guys just a quick qustion. I was digging through some old amps I have and i found an old school orion hcca 250 digital reference 2 channel. On this amp there is a clipping indicator, Should i trust this light? how accurate is it.? Also i have a rubicon with the same thing.

I have a kinda small box for a ported 6 1/2" Bose woofer. It sounds alright, but i can't fit much more in the bag. I was wondering if polyfill would have somehat of the same effect in a ported box as it would in a sealed box. I did want to ask the difference in effect, between stuffing and padding, because i have heard of both being used. I am looking to shift the tuning down a little bit.