Amplifiers / Head Units / Processors / Electrical

Found thisamp while browsing ebay and did not know much about power acoustik as a company. Are they any good? Thanks, Matt Cusack

Ok I got to thinking the other day about the way I wired my sub to my amp. I am sure this has been discussed before. But I have been unable to locate the answer. If it has I appologize now. The sub is an Alpine SWR-1222D and the amp is a MB Quart Discus 1000.1 Monoblock. The way I have it wired now is in parallel to 1Ohm with one set of wires to the amp on the outer positive and outer negative terminals. According to the manual that is for single svc sub. Is that way ok or should I physically wire each coil straight to the amp. As the amp automatically parallels both sets of terminals which would make this a 1Ohm load as well. Which way is better the way I h…

I'm going to install two amps one is mono and the other is a 4 channel for my mids and highs. I already have the power, ground, and rem wire, but the only thing is how can i get two rca's if my headunit only has one connection?

So as you all know I have been getting very mixed information trying to figure out what to do with my subs, my box and all that junk. Well I finally got a response from Bob at American Bass, turns out I am having such trouble finding info cause my speakers are 12 years old, although he says they are very good speakers, so I am still determined to use them with my setup. He informs me that I should run 300 rms to each sub, but once again my trouble is finding the info I need since these are dual 6-ohm speakers. I have been looking at tons of amps, monos, 2-ch, 4-ch bridged, you name it, I just can't make sense of it with the speakers I have, with my options being 3 ohm eac…

Last week my CDA-9886 started doing this thing where, from what I've noticed, at high volumes it will just restart in the middle of a song and keep restarting unless I turn it down. Running 1 Treo SSX 12 powered by an RD 1750.1D at .5 ohms for 2500 watts. Got a nice wal mart bat up front with 800 cca and a shuriken bt100 in the back, big 3 and all 0 gauge of course. Talked to the guy who's sold me RD stuff before and he said if it were the amp it wouldn't making the HU restart like that...which I pretty much knew. From what I gathered it's either a loose wire or worse, the HU isn't getting enough amps because of a shitty power cord to it... just wanted to get some opinion…

So lastnight I installed a digital volt meter in my dash, and today I noticed that when starting the car it reads around 14.5v, when not running it reads around 12.8v...However driving around a bit I see my voltage drop down to around 12.8v, not staying at 14.5v, even if I'm not pushing my subwoofers... Is this normal? I assume it has something to do with the alternator?

My neighbor happened upon a xtant 3300 its a big ass chrome amp unlike anything ive seen before. I went over there and hooked up on the mono sub channel to a couple Memphis 15's and it sounded good but what im wondering is what else can it be used for I googled it and found its a 3 channel with 5 channel capabilities more SQ oriented but what is this thing worth? Also ive never seen an amp like this without knobs and little plugs instead. I would have taken a pic but it was night and my cell wasn't capturing it well. Anyone have any knowlegde on it? I can probably get it for pretty damn cheap or trade my RF 450.2 for it.

So I'm pretty sure I'm getting knukonceptz wiring for my set-up. my set-up: 2 fi q12's fully loaded (subs) Fi: 2 sets of alpine spr-13s components (speakers- 4 total) Alpine Electronics of America, Inc. 1 audioque 2200d (amp for sub) Audioque: Amps: AQ2200D 1 Alpine PDX-4. 100 (amp for speakers) Alpine Electronics of America, Inc. So, for the Audioque amp i'm thinking about getting the Kolossus Flex 0 Gauge Dual Amp Power Kit ( 0 GAUGE DUAL AMP POWER KIT ) And for the Alpine amp I'm thinking about getting the Complete 4 Gauge 4 Channel Amplifier Installation Kit ( 4 Gauge Amplifier Installation Kit ) Does this Installation Kit include enough speaker wire for 4 speake…

Alright guys i finally got my FI Dual 1 ohm 12 Bl today and went to installing the sub. As I turned on my deck i received sound from the speakers but no sound came from the subwoofer. 1. I checked the amp (Alpine MRP-1000) Amp light turns on. 2. I checked the rCA'S even switched the RCA'S between both amps no sound from the subwoofer. 3. I checked the deck and switched the subwoofer rca's from subwoofer input and rear space input. still no sound 4. I checked to see if the amp was getting enough power and it was at 12.5 volts at rest 5.i turned on the subwoofer option on and off on the deck and still no sound. 6. I turned th e gain up on the subwoofer from minimum to max…

I'm new to car audio and i need help to figure out what wires and/or wiring kits would be a good purchase for me. My system: 2 Fi Q12's fully loaded (subs) Fi: 2 Alpine SPR-13s (speakers/ 4 total) Alpine Electronics of America, Inc. 1 Audioque 2200D (amp for subs) Audioque: Amps: AQ2200D 1 Alpine PDX-4. 100 (amp for speakers) Alpine Electronics of America, Inc. 1 Alpine CDA-105 ( head unit) Alpine Electronics of America, Inc. I was looking to get wiring stuff off of knukonceptz.com but give me other websites please, and help me find all the wire i'm going to need. thank you

I bought a 50 farad Stinger capacitor (dont make the whole cap vs battery argument thats not what im here for) and it came with instructions on how to install it using 2 amps, but i need the diagram to hook up 1 amp to it i need to figure out where i wire it up, it has 2 + and 2 - connectons and i cannot figure out which one is input and which is output i have correct grounds, atl, and wiring and it still dims with an fi bl12 and 1500 amp, please help me wire it up Patrick

I am going to be using my crossfire vr4000d. 4K @ 2ohms. I believe my 2009 caliber srt4 has a 140A stock alt. No H.O. alts are made for this car yet I don't think. What kind of electrical would you guys do for 4K?

YAY my sundown sae1200d and nikon camera. couple pics, also is this a sae 1200 V2? cause it just says 1200d i was jw

Looking to get a H.O Alternator. I have read some bad feedback about DB and Iraggi. What brand would you suggest? I have read good things about Excessive Amperage! Any others? Thanks

Hey everyone! im new to the forum, but i decided since i purchased my amp from ssa that this would be the forum id make my account on. ive got a sundown saz-1000d pushing 2 alpine type r 10"s at 1ohm along with a 3.5 farad cap. in a 1993 ford tempo I got bored one day and decided to do the big 3 upgrade with some JL 4 awg i had lying around in my room. for some reason i feel unsure about the wire i have going from the engine to the chassis, and was wondering if it'd be ok running a wire from the alternator cage to the chassis instead? if doing this is it still ok to leave the stock engine to chassis wire? is this even possible? or will i just run into electrical problems…

Hello i am relatively new here and was hoping to gain from the experience of some other members i am currently using a Sony CDX-GT340 and it sounds okay, but i was told the sound quality could be much much better. i am running alpine type r 6.5 components in the front and pioneer 4 inch (3 way) coaxials in the rear doors i am hoping to run these speakers off the head unit for a bit longer and then i will amp them my subwoofers are 2 15 inch fi Q's in a sealed box each receiving ~1200-1300 watts from it's own rockford fosgate t1500-1bd (currently off a y splitter of the rear channel) (electrical system has been upgraded significantly to account for this i don't want a…

ok, so i just upgraded my stock head unit to a double din non touch screen thing, JVC something. its alright. i kinda miss my other.... i miss my steering wheel controls, and i hate how my antenna goes up when the thing is on, not just when the radios on. and it sucks that my ipod would be one of the 2 it supports that you cant control from the ipod. only the head unit... but besides all that so, a few problems i might get professionally fixed tomorrow unless its a simple fix. before, i had my suboofer amp hooked up to the back speakers. i splaced into that. i know stupid, i got bitched out on another forum,which is why i have the new deck. so now, ts almost all hooked u…

I have a powerbass 300.2x which does 80 wrms per channel at 4 ohm im running a set of alpine type s 6.5 coaxials they are 80 wrms i have to turn the gain all the way up on the amp to hear them/sound good would a headunit with 4 volt preouts help? Btw i have a speaker wired to each channel. And i have an alpine cde9876 i think two preouts that are 2 volts.

can i run my speaker wire and rca cables in the same door jam or do i need to run them seperate. power wire is seperate from rcas but does speaker wire matter or not another questions trying to wire up my apline 6.5 coaxils how do i know which one is the postive and which one is negative or does it matter

Alright so I am wondering which amp would be better for my setup. The SAZ 1000 or SAE 1200 hooked up to a BL 15 wired at 1 ohm? I know the SAZ is more of a performance amp and the SAE is more commercial I guess. But which one would power the BL better and not cause me to worry about blowing my sub or frying my amp?

ive been told that this is a good amp for the money im not sure if this has been posted yet or not haven't seen it. but i here its just about the same as the saz 3000d but cheaper. ive called the place and they said a couple people that have fi subs bought this amp and have good reviews on it. i mean the amp looks good he told me its just as the saz 3000d they don't believe in charging a lot of money on their amps it comes with a two year warranty whether i have it or i give it to someone else i just wanna know if anybody here has had any experience with it personally?? thank you Crescendo Audio :: Amplifers :: 3KWP Monoblock Amplifier

Whats a good amp that puts out about 1000RMS on 2 ohm for a cheap price thnx for the help! stupid budget

i was worndering if these amps do true rated power and if anyone had experience with any of their amps?

Hey guys, I'm bullshittin' ideas around in my head about a temp daily set-up. until i do my BL What kind of electrical would i need for the set up listed below? I'm thinking a 350amp Alt from DC Power and a D3100 as a starter battery. AQ3500D.1 4 ohm power @ 14.4V @ 1% THD 1400W x 1 2 ohm power @ 14.4V @ 1% THD 2600W x 1 1 ohm power @ 14.4V @ < 1% THD 4300W x 1 AA SMD 18" RMS 3500w Also, if i were to double the equipment, could i still use a single alt and add another D3100? -- Or would that add too much then recommended stress on the alternator? Thanks guys!

I just recently sent my subwoofer out to be repaired. I have 2 amps in my car 1 Boston for my speakers and 1 hifonics Brutus 1610 d class amp. I was playing music through my speakers but I didn't realize my Brutus RCA cables were still plugged in and it is getting power. Have I damaged my amp by playing music with no woofer hooked up the past few days?