Amplifiers / Head Units / Processors / Electrical
Discuss Head Units, Amplification, Processors, And All Electrical System Inquiries Here.
5,712 topics in this forum
-
Need help deciding between the sundown saz1000d or the rockford t1000-1bd(09 edition). Will be going on a Fi Bl 15 dual 2. The box will be 4 cubes at 32 hz. Any help is appreciated
-
0
Reputation Points
- 9 replies
- 968 views
-
-
I'm planning to upgrade my electrical. My battery is in the back of the car (Magnum). Couldn't I just run new wire from the alt to a pair of separate batteries? Rather than wire all three together? I'd be running a pair of 105 AH marine deep cycle batts, dry cells, separate from a regular dry cell car battery. I've never seen it done, although i'm sure it has been. Thanks.
-
0
Reputation Points
- 2 replies
- 538 views
-
-
I have a jl 500/1 gains are supposed to be set at 31.6 v ac. I have tried two different decks at 3/4 volume with bass flat and with the gain turned all the way down Im getting 40 volts using 50hz signal at 0db. the sub 12w6 sounds loud with the test cd but barely audible with music. Is there anything obvious to look for? thanks Todd
-
0
Reputation Points
- 3 replies
- 582 views
-
-
How do I hook up the o-scope to tune my 1. Sub amp, and 2. component amp. I need to know the settings, and what to set the dials on, thanks.
-
0
Reputation Points
- 3 replies
- 642 views
-
-
So. my hifonics brutus bxi1208d is causing distortion, it doesn't start up instantly but as it gets going it starts to CLIP hard, the clipping light isn't going off or anything, im assuming its the heat? its about 100 degrees Fahrenheit. i have an Kinetik Hc 600, 4 gauge wire, stock alt. i get what i'd payed for right?
-
0
Reputation Points
- 17 replies
- 1.3k views
-
-
So my amp is 3500watts and my alt only puts out 90amps....so if i hook those up is my amp gonna draw as much power as it can, or does it only draw a certain amount of power depending on how much i turn up my subwoofer?......................................Actually i just took a look at my amp and their is a level control im guessing for the power of the amp,,,,,,,,,,,,so ill just adjust that,,,,but can anyone tell me what the max rms i should put out ????
-
0
Reputation Points
- 11 replies
- 1.1k views
-
-
I bought a Boss audio blx 3500m amp about a year ago when i knew nothing about car audio and just tried to buy the cheapest amp i could find. I've read that boss audio products aren't that good. Is this true and does this reputation also go with this amp. I'm just wondering because i had it hooked up to a Boston Acoustics g5 12" single 4 ohm and the sub made a funky slapping sound (not tinsel lead slap, those are fine) that i could just not live with. Could this be a problem with the amp.
-
0
Reputation Points
- 8 replies
- 2.6k views
-
-
First question: What is a "float charge"? I've heard the term a few times, but never what it means. Second: How do you maintain a "float charge"? Again, I've heard about it and from what i hear it seems like a good thing, but don't know how. Third: What are some "budget" batteries? I don't need to power a small country, but i would like a decent reserve, as my RF 200.2 beats up on my current battery, a somewhat old Interstate 1000cca. Fourth, and finally: What are some ways to help keep your batteries healthy, or functional for longer? Thanks guys! I forgot to add, that for the time being, i am using a Pyramid 3amp constant/4amp surge AC/DC converter to charge my battery,…
-
0
Reputation Points
- 14 replies
- 1.1k views
-
-
Finally got around to taking pics of my HellFire 1000.1 Pics & Test Results From Diablo Audio Technologies Forum.
-
0
Reputation Points
- 2 replies
- 1.5k views
-
-
Amps Sundown: sae-1200d Sundown: sax-50.4 For the 1200 Gain- (will be set with DMM) Sub Sonic- I was thing about 27hz Bass Eq-0 X-over-??? For the 50.4 Channels 1&2 Gain-DMM Sub Sonic-??? HPF-??? Bass Boost-Lowest Settings Range-??? x1 or or x10 Channels 3&4 Gain-DMM Sub Sonic-??? HPF-100hz Bass Boost-Lowest Settings Sub Fi Q 15 w/BP 4^3 Box 30hz Speakers: Channels 1&2 Infinity Perfects 6.1 Frequency Response (
-
0
Reputation Points
- 2 replies
- 537 views
-
-
i just installed an excess amperage 300 amp alternator ... for some reason something is not working correctly ... i am only getting 12.5 volts and it drops a tad to 12.4 when i rev it up ... what is going on ... the stock alt was connected to the fuse panel but i ran the new wire to the battery and fuse pannel to the battery
-
0
Reputation Points
- 21 replies
- 1.8k views
- 1 follower
-
-
Kenwood KDC-MP205 Anybody familiar with this? My step bro just got one and we CANNOT figure out how to get it to play his itouch through the AUX input
-
0
Reputation Points
- 8 replies
- 711 views
-
-
Here's the deal - I'm working on putting my system together. I want to make sure I have my electrical taken care of. Amp will be 3000rms I was thinking about the following options: Option 1: Big 3 HO Alternator - 165amp Idle / 260amp higher rpm ---------- Option 2: Big 3 Stock Alt - new, but stock. XS Power D3100 Battery --------- Option 3: Big 3 Stock Alt 2 HC1800 Batts ------------------------------------------------------ Amp would probably be GP3000D running to 2 15" MTX 9500s. Or could I do a HO Alt - which is going to be $500 for the one i'm looking at, and maybe an optima yellow up front? Any help appreciated.
-
0
Reputation Points
- 5 replies
- 973 views
-
-
I have a 2003 Saturn Ion with a 2.2L Ecotech Engine with a stock 105A alternator, im trying to upgrade my big three but im running into obstacles so im coming here for some creative input. Yesterday I pulled the box out my trunk and finally took the spare out since its pointless in being under there and got to my starting battery (located in trunk where Saturn puts them). I completed the Big 1 so far using Kicker 1/0 Gauge ground wire and my voltage is outstanding so far when I idle I dont stay 14.0v to 14.1v (use to be 13.7v to 13.8v) when I crank my car im at 14.3v to 14.4v (use to be 14.0v to 14.1v in this Texas Summer Heat we been in the 100's last few days) and when …
-
0
Reputation Points
- 3 replies
- 949 views
-
-
I just got an L.A. Sound 4 Channel amplifier, model number S835, it was given to me by my uncle, I tested it with a 6x9 and a PC power supply and all the channels seem to work, it's supposedly 800 watts (max I'm assuming), has anyone ever heard of L.A. Sound or used any of their amplifiers? Were they any good?
-
0
Reputation Points
- 5 replies
- 3.7k views
- 1 follower
-
-
Well I have been looking around a lot for different decks and wondering which ones are the best for what I am willing to pay. I would like one of those that have a touch screen and actually come out of the dash, but it is not necessity. The more reviews I read on them any of them under 1000$ are cheap and break often. My budget for one of these seems to be no more than 500$. I would like blue tooth for my cell phone, my cars computer has the ability to see what bands /songs are playing on fm radio (no idea what its called), and have the capability of iPod usage (I have an iPod touch). Anybody know what I should be looking at off the bat? I have been looking at a lot of cr…
-
0
Reputation Points
- 6 replies
- 872 views
-
-
i recently got an internship and in our engineering lab where i work we have many oscopes. i was wondering how i would be able to use the oscope to set the gains on my amplifier
-
2
Reputation Points
- 31 replies
- 3.4k views
- 1 follower
-
-
Ok so I have a kicker zx2500.1 laying around my house and since I blew my previous amp, This may besomething I can stick in my car. So my question is (after doing some digging that led to nowhere) does ANYBODY know the MAX of this amp? I have read quite a few things most of which say this # RMS Power Rating: * 4 ohms: 1250 watts x 1 chan. * 2 ohms: 2500 watts x 1 chan. # Max power output: 2500 watts x 1 chan. How can the rms and the max of the amp at 2ohms be the same?
-
0
Reputation Points
- 3 replies
- 666 views
- 1 follower
-
-
Hi. Don't know if there was a thread already, looked back but couldn't find one. I need help. Alright. So, not too long ago, a friend that seems like he knows a decent amount about car audio set the gain and bass boost on my amp. My amp is a 1000w mono block, and it was pushing a 15" spl sub rated at 1400rms. It sounded really good, but all of the sudden, it blew a single voice coil. Obviously, I was upset. I got a replacement for the sub, the same one, but I just don't want to blow it again. Can anyone help with tuning the amp by gain? And I've also heard to NEVER touch the bass boost. Is that true? Oh, and when setting the gain, should I have my head unit as high as I…
-
0
Reputation Points
- 5 replies
- 702 views
-
-
ok so when i first turn my car on my volts are usually 14.2 when im not even playin my sub or have my ac on it slowly drops to 13.5 and sits there. then the rest of the day i never see 14s again i had my alt checked and its fine so i have no idea wat it is. any ideas?
-
0
Reputation Points
- 12 replies
- 868 views
-
-
Hey guys Im looking for a single din flip out for my car. Reason why I am choosing a flip out is because I have limited space, and still want my A/C. I could put in a double din below it but I dont want to do that. I am looking for a NAVI/GPS h/u with basic features, cd/dvd. I don't want to spend a fortune on it. My price limit is about $700. So far after some research, I am looking at a Pionner AVIC-n4 or n5. Anyone have any input on whats a good h/u? Brands? Thanks!
-
0
Reputation Points
- 6 replies
- 1.1k views
-
-
I was wondering if there was a kelly bb for car amps i couldent find one so I thought ild ask here. I have a Treo ssx80.4 its still in the box never hooked up how much do you think it would be able to sell for? any help would be great SSA is the best!
-
0
Reputation Points
- 1 reply
- 1.5k views
-
-
ive already got the big 3 all done in 1/0 with terminals soldered and all the goods, but im gonna install the alt soon and i was wondering if its necessary to double up on the 1/0 or no? and it says in the paperwork to add another ground from the closest ear on the alt to the frame..is that necessary too or just a good idea?
-
0
Reputation Points
- 2 replies
- 514 views
-
-
Hey so...what kinda amp would anybody recommend for the Fi BT12" Subwoofer?
-
0
Reputation Points
- 2 replies
- 572 views
-
-
Alright, so I got my amp yesterday (Diablo Audio Technologies 1000.1) and it's great, except for one problem. Every time I turn on the truck, about 5 min. later the amp turns off and a blue light (alarm) on the amp goes on, even if I don't have it that loud. Can somebody tell me what might be the cause? P.S.- There is only one L.E.D. and Red means On/Power Blue means Alarm
-
0
Reputation Points
- 12 replies
- 1.2k views
-
Who's Online (See full list)
- There are no registered users currently online