Subwoofers / Speakers

What is the frequency response of the D2? I was thinking about using the Koda 6 midbass which starts at 200Hz and wanted to know where the D2 topped out.

Single cab 2003 tacoma. What i have to work with is length: 46 inches depth:11 inches height: 28 inches could go higher if need be and have bench seats so the sub would have to go in a bottom corner. Any help is much appreciated

In a slightl;y better enclosure than the last. Last enclosure was the fibergalss one I built which was 1.9 cu ft tuned to around 33hz using a 4" aeroport. This is a 2.1@31hz enclosure I had fisher customs makle up for me. More port area since space wasn't as critical as the GTO, plus I will have the seat down from time to time, so minimal port noise was wanted. Thje area is 31 sq inches. This setup sounds so much better than the GTO did. A lot louder as well. Most of that has to do with the 2 different vehicles though. The GTO just isn't advantageous to a sub in the trunk. The cavalier is a bit more accommodating, just a chittier car lol. Here is a few short clips. I got…

how far does the port of your sub box need to be away from the back gate of my suv? the box would be subs up port back,thats the way my current box is setup and i have about 6" between. the new box im planning may be a lot closer,just want to know if there is a poit that is to close and affect my sound.

When i was out riding today bumpin, i have my volume 1/4 the way up and my subs stop playing. Last time i had this problem the power wire came out of the amplifier but not this time, all the connections was still in tact and the amp was still on. I thought it was the fuses but if a fuse was blown the amp power light will not be on.....what you guys think? i praying the subs are not blown because the volume wasnt all the way up

ok i think i have narrowed it down to a cmpx2, fi q, utopia, or a w6v2. keep in mind i have a 02 ram single cab w/ the center seat removed and im goin for SQ. i listen to mostly rock and rap but also reggae, classical and most everything else. if i have a choice, do i go w/ the smaller sub? lemme know ur opinion and y. plz tell me if u think other subs would be better for sq thx in advance

I found an old JL 10 for sale, didn't see a number on it. Looks like it was reconed or something but ok job. Motor is near as big as the hole it would go in, its heavy. Kind of well used looking but new JL dustcap and maybe foam on it, it is all black and stamped looking frame....any idea of value? Not sure what I could do with only one. It has thick paper gasket on top edge that is torn up some, the rest is not bad.

i am going to fiberglass my entire trunk to fit 2 12" Magnums, what are common molding materials used for fiberglassing, i was trying cardboard but i figured out thats not going to work very well...... help

Nope

Tru Technology S44 (2x200 @ 4 ohms) to a pair of DLS X-Program SA62 6.5" comps. Speaker wire size recommendation? Thanks!

to bad I can't afford one of these now would do sweet under my bed. good news is I should have 400lbs of subs coming to my house soon

running a single fi bl 15 on a saz-3000d at 2 ohms? would that be okay and not blow it the options i have on it is cooling,daily, universal d1 until i get my next fi bl its ported of course in a 4.5 cuft tuned to 30hz

just kidding. I am just anxious to see SI back up and running. Ever since SI was robbed I have turned alot of friends onto the Mag. They keep asking me when will more be for sale. Its amazing how people will talk crap about your sub cause its not down at the local sound shop then gauk at it after hearing it and try to buy it from you. Any recent info on how things are coming for SI? sure hope Nick and them don't abandon the SI 8" midbass. I have been holding out.

hello there, while searching for some components I came across these QSC-164 - MB Quart. I am looking for a set of components that will match up to 2 BM's subs. what I really want is clarity and I know MB Q has been around for a while so I figured I cant go wrong with them. My other choices would be the JL ZR650-CSi and Hertz ML165 but these come with out tweeters. I need a total of two sets for my truck, so if you guys can advice on these speakers or recommend others I will appreciate it thanks..

Ok, so yes I was one of the lucky ones to demo the prototype of this new Mag. And I "kinda" knew what to expect, though the proto 15 had some chrome problems leaking into the pole causing non 100% performance. So I did know how much better to expect from the production driver. So it came in wed. and I put it in thursday. I just completely swapped it out with my other Mag (previous version) same box, same amp, same amp settings, xover settings, same everything except the new driver. So I let it break in for 2 days on my drives to work (45 min one way). Didn't turn it up past 20, out of 35, just to warm her up and all. just some good ol Panic to break her in. (schools is r…

First, excellent place for information these forums are. I'm sure I'll lose a ton of sleep pouring over these pages. Now on to my situation. I don't need my vehicles to get extremely loud (I'm very happy at 125db), but I like it to be pretty clean. For this reason I usually prefer older equipment... running a pair of Kicker s12d solobarics until very recently (very happy with those btw). Newer stuff, especially "main stream" stuff tends to be more spl oriented and is usually pretty muddy for my tastes. Due to a downsize in vehicle (it's a 91 318is bmw) I am looking for a single sub I can stick in around a sealed 0.9-1.2ft^3 and sound clean, and loud when desired. …

anyone have the full diameter of these tweeters????

my friend just got a 15" memphis power reference sub in a q logic box, and i'm thinkin about tradin him all this for it...... 1. fultron crossover<---freebie 2. RF fused distro block<---freebie 3. Clarion apa4100 (25x4)<---freebie 4. RF 17' power wire w/fuse and all<---freebie 5. 2 or 3 scosche rca cables<---came in a walmart wiring kit ($25.00) 6. I told him i'd throw in some cash, i said just whatever he thinks after all this (shouldn't be more than around $20-$30) http://www.memphiscaraudio.com/products/de...?cat=&id=58&p=2 heres a link to it, in case u were wonderin what it was (doubt u were though) i've never heard them before, but being memphi…

well, as you know SSA is now a mach5 distributor. Right now i have 2 infinity perfect 12.1's. I was planning on doing these with a ported box, but the more i read, the more id like to try a mach 5 maw15. The maw would cost a little more, because i can probably only get about 80 or so for the pair of perfects. I have one sealed in my car now with 300 watts, but its not loud at all, and i would just be worried about the output. I know this is the mach5 forums and may be a little biased, but most\ of the mach 5 knowledge comes from here. So i ask you, keep the perfects and go ported with about 700-800 watts, or do one maw15 ported with about as much as it can handle? t…

Would a Kicker 750.1 zx be an ideal amp for a 15" 4 0HM L7?

I have a ED Nine.1 and I need help deciding on what subs to get. The amp supposed to do 1200w RMS @1ohm 12.5v. I have a MB Quart 4125 powering a pair of ID CTX65cs comps and a pair of ID CTX65 coaxials. This is all going into a '09 Jeep Wrangler Unlimited. I listen to all types of music. I want something to get low and loud. Would 2 Icon 12's be a better choice than 1 Xcon 12 with that amp?

What are the specs on a ssa zcon 12 ? (Ported)

built new box today..waiting for it to dry now.total volume is 3.4 cubes gross.port is 2.25x14x27long so net volume for sub is 2.85 plus the port which is .5 cubes.hows that sound on paper?and whats it tuned to?around 30 i think.

ok so i have a ten inch re audio sx sub d2 and an usamps md1d at one ohm the amp will do 1200 watts just exactly how do i get it to do one ohm do i just wire the sub up differently cause in the manual for the sub it shows how to wire it up parrallel is that it or what?

I've been out for a while, had kids and gotten old. I need some info comparison between the DC audio 8" sub and the American bass 8" sub and how does each compare the let's say the benchmark is the JL W7 8", thanks for the info.