Subwoofers / Speakers
Discuss Subwoofers And All Aspects Of Speakers here.
6,865 topics in this forum
-
What's the popular vote on these setups? -2 12" SSD's w/copper coil ported to specs -1 12" BL w/ cooling and universal ported to specs (Could also do 15", only reason for 12" was the possible addition of a second later) -1 15" Q w/ BP sealed to specs Looking for Rap/Hip-Hop based Daily Driver with low end and gets loud while being run off a KX1200.1 at 1ohm (1350rms) Thanks Chris
-
0
Reputation Points
- 2 replies
- 804 views
-
-
Looking for a 12" sub that can handle 1500w daily like champ and be fine in a slightly smaller ported enclosure tuned in the lows 30's. Looking for mainly SPL right now. This is just for daily, no competitions will take place. Looking to keep the price under $700 for the pair if possible. Need to buy them new. 12" XCON? 12' Nightshade? 12" BTL? 12" HW? I like good customer service and subs that have good information available about optimal enclosure sizes.
-
0
Reputation Points
- 4 replies
- 804 views
-
-
I need to bring my brahma back from the dead, its been sitting in my garage for over 3 years now (adire audio is no more) and i finally have the motivation to fix it. Where can i find a kit to re-cone and will the replacment effect the xbl2 technology or is that built into the sub itself. Id also need new tincle lead brakets (the things the leads are slolderd too marked + - ) a nice torque twist set would be nice. idk help me out ppl
-
0
Reputation Points
- 1 reply
- 803 views
-
-
Here is the delima, I can either run 2 15" Fi Q sealed in a 4.5 cuft enclosure (net vol.) or 1 15" ported in a 4 cuft enclosure (net vol.) tuned to 30 Hz. Now what am looking for is clean, low end bass with the potenial to get loud. Looking at both setups, which would produce cleaner low end bass. Am not looking to compete or anything, its just a nice low end daily setup for my personal uses. Am also willing to play around with tuning if there is any suggestion. Thanks in advance for the response.
-
0
Reputation Points
- 4 replies
- 803 views
-
-
I'm trying to decide between a pair of 12s for sealed operation. As most of you know I had an Icon 15. My girlfriend just got a new Nissan Murano and I gave it to her to start her system with. The 15 was just taking up too much space in my trunk not to mention I've been missing having a sealed setup. I have always favored sealed setups with a pair of 12s and need help deciding between these pairs. BTW, I may also hook her up with my amp in favor of picking up a new SAE-1000D. 2 Audiopulse Epic 12s 2 Mach5Audio IXL-12s 2 JL Audio W6v2 12s
-
0
Reputation Points
- 7 replies
- 803 views
-
-
where can i get prices and see about some good deals on adire to see about thier subs??? i was looking at either these or the re xxx....
-
0
Reputation Points
- 2 replies
- 802 views
-
-
Hi there, im looking to get a new 12" sub sealed and focusing more towards SQ than SPL. Im pretty well decided on the Fi SSD 12" with the copper coil. It seems to fit the budget and sounds like it will do what i want it to. Im currently using the Mach 5 audio MAW-15 and want to change it up and regain a little trunk space. The amp im running is the Alpine MRP-M850 so it should be enough for the SSD. What would be the benefit of getting the Q over the SSD, they both look pretty similar except the Q would take more wattage which i dont have anyways. Thanks
-
0
Reputation Points
- 1 reply
- 802 views
-
-
ok i curently have a set of rsd65cs installed. im getting rdy to install new door panels and i dont want to cut holes for tweets. do you think installing coax in all factory locations would sound better then my current comps? was going to go to front 3 1/2 kappa 32.7's in the dash kappa 652.7i in the doors ran in parallel and kappa 692.7i in the rear. was thinking of getting a sd 100.4 or dc 120.4
-
0
Reputation Points
- 5 replies
- 802 views
-
-
hi i have the new mag and wanted to know if 2cf tuned to 30hz sounds good for a single 12 or what would be more efficient?
-
0
Reputation Points
- 1 reply
- 802 views
-
-
I have been trying to search this forum for info on this sub but i can't find anything so i just started a topic. I am looking to upgrading. I currently have 2 12 inch pioneer champion pros. (TSW3002d4). I just came across the Sundown Audio x-12 and watched a few youtube videos. These things look like they will silence my pioneers. I want to know if anyone has seen them in person and what they think about them. The amp I currently have is Hifonics Zrx3000.1d
-
0
Reputation Points
- 1 reply
- 802 views
-
-
a friend of mine from work told me he came across a really nice pair of 10 inch kicker solobaric sub's the model they made when they first came out and he was wondering if these subs are good for sq ?
-
0
Reputation Points
- 1 reply
- 802 views
-
-
I can't seem to find another place to buy a Cerwin Vega Vmax 12.2 anywhere but a local shop and from sonicelectronix. Anyone know of where i could pick one up for a decent price? Sonicelectronix wants $189, plus $31 in shipping fees. I am looking for the newest model, which is this one if anyone knows where to get one it would be appreciated. Thanks!
-
0
Reputation Points
- 2 replies
- 802 views
-
-
I did some searching all over the net and here and really didn't see anything much on MB Quart stuff. I am checking out components to pair with a sundown amp in the future and MB Quart kinda caught my eye. I know they were good in the past when they werent owned by maxxonics and have heard mixed reviews since their merge. I am kinda wishy washy with what i actually wind up doing but i am looking for comps for the front to replace the ones i have no, 6.5's, my rear doors have midbass which i want to replace with a second set of comps and my rear deck is compose of 2 6x9's which i want to swap out for 2 midbass addons. Any input? Im looking around the 200ish mark for ea…
-
0
Reputation Points
- 3 replies
- 802 views
-
-
What tweeters to match MBQuart RSD-216 woofer? I'm tired of the ear bleeding sound of the titanium tweeter that I have. What tweeter should I replace it with?
-
0
Reputation Points
- 4 replies
- 801 views
-
-
which would be louder and which would be more accurate between.... 1 12" d2 in a ported box to specs with a jl 500/1 or 2 12" d2s sealed with the 500/1 any help or comments would be appreciated! thanx Tom
-
0
Reputation Points
- 2 replies
- 801 views
-
-
I built this box for my sons Scion. I did it this way so we could still use the area for light duty cargo space. 1.8 ft^ @34 hz with the port running straight along the back. It hit's decent for the L7 10 and Cadence 600ish watts. I know this isn't a killer build but as of right now I only have about $200 in the HU, amps, sub, and comp sets. Budget build for a kid kinda thing. Unfinished because I'm still on the fence... Messy here too for now... Here's the current port exit area. It's a little tighter toward the bottom than I like and why I brought all this up. I've been thinking of switching to a Sundown SA-12 in the same box running the same amp. Is the downfire/…
-
0
Reputation Points
- 2 replies
- 801 views
-
-
my friend has a dual 4 ohm old school cerwin vega stroker that he has told me i can get for $100, the only problem is that i metered the voice coils and they are reading 3 ohms apiece. what do you guys think, does it still have some playing time left or should i not purchase it?
-
0
Reputation Points
- 1 reply
- 801 views
-
-
I ended up getting a clarion 785usb and i have been wanting to go active for a while. I need some help with drivers tho. I really like the Eminence alpha 6 mids and i was looking at selenium horns, but i think theyd be pretty hard to get into the doors. Could you guys reccomend a decent metal dome tweet with a relatively shallow mounting depth that gets pretty darn loud? I have about 50 watts at 4 ohm and 70 at 2 ohm to work with and i think the crossover point would be like 3khz with that mid? oh and budget would be like 25ish for an 8 ohm driver or 40-50ish for a 4 ohm driver.
-
0
Reputation Points
- 5 replies
- 800 views
-
-
Whats going on .. So I just wired my xcon 15 back up today noticed a slight coil noise... Anyone close to south Chicago for a recone.. Or anyone do any thing nice with the xcons besides psi ... And has anyone reconed through ssa if so wondering around how long I'll be waiting for it to come back thanks
-
0
Reputation Points
- 2 replies
- 800 views
- 1 follower
-
-
Anyone use any ribbon tweets? I have heard them in home but never seen them in a car audio application. Any have opinions?
-
0
Reputation Points
- 4 replies
- 800 views
-
-
Do the 3" Legatia mids have grilles available? I need to find something to fill these holes left by the 3.5" DLS Ultimate Iridiums the previous owner had and these seem to be one of the only good fits
-
0
Reputation Points
- 1 reply
- 800 views
-
-
i was wonderin if i should get the diamond audio speakers or the type r's. any recommendations? i wont be usin a amp right away but ill get one like a month after i get the speakers. an i listen to rap.
-
0
Reputation Points
- 1 reply
- 800 views
-
-
Okay I just installed a pair of 12s in a ported inclosure and I get this popping sound coming from the sub. Today I was sitting there looking at them trying to figure out what was happening when the sun got down low enough and shone on the face of the sub, it was then that I saw the face of the sub pop out in the top corner, It just made a little bubble and created the popping noise. Has anyone ever seen this?????????????????
-
0
Reputation Points
- 2 replies
- 800 views
-
-
I have had weird issues off and on with my amp (teac 200.1) and my components( phoenix gold radials ran passively). little things like sounding muffled at start up in cold weather. I bought the amp on here a few years ago for $15, so no big loss. The other day i was involved in a fender bender and the power wire from the front battery to the back came undone. I didn't notice this until a few days ago. The tip off should have been that the sound deteriorated over the course of a week . Yesterday I took an old speaker and some wire and tested the amp and rca's for a clean signal. Left channel is dead and right is static-y. I said screw and attempted to run my components off…
-
0
Reputation Points
- 1 reply
- 800 views
-
-
Well lets get this part out of the way, I have a Dodge Magnum, and I'm currently running a FI Q 12 D2 with BP power in about 2.2^3ft at 31ish hz on a Sundown 1500d. I love the sound of my setup (listen to primarily rock), very happy with it, EXCEPT i want my cargo space back! For fun I had it metered and put down a 140.8 on the TL. So what I'm looking to do is build enclosures for my rear storage pockets as you can see here. I want to attempt building them myself, but am using this for planning which means somewhere about .7 cu ft and 6.5 inches deep to work with. Obviously this would limit me to a sealed 10 or sealed or ported 8. For budget let's say 200ish a piece for a…
-
0
Reputation Points
- 2 replies
- 799 views
-
Who's Online (See full list)
- There are no registered users currently online