Subwoofers / Speakers

Ok guys i know that in my previous threads i said i was going with the xcon 12 but dunds are a littke tighter than before so but i could still get the xcon but it would be a little longer of a wait so my question is on 1000 watts which would be louder in a 2.5cft box tuned to 33 hertz

Guys I know just enough to get into trouble and looking for some advise. I've got 2 Fi btl n2 15's that are going to be sealed off from the trunk with a blow thru in the rear deck. Each sub is going to be ran at 1ohm with a Rockford t1500-bdcp amp. I've got 4 sets of Rockford T3 6.5" components and plan on running one set on each channel of my Rockford t800-4bdcp. My question is this..what freq should I cut the subs off at..where should my components pick up at..and are my components enough? Will they be loud enough? Will they go low enough? Thanks for any help you can offer.

i need some new tweets for my RE 6.5 comps. theyre just not loud enough. i had some polk db tweets, and i really liked them, but they're long gone now. since i don't know alot about tweets i'm basing my search off of the polks sensitivity rating of 94db @ 1w/m. that is how loud (more or less) it'll be right? here is a couple that i found on ebay. if you know of something else let me know..... p.s. i only got about $25 http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...5786730772&rd=1 http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...5785599027&rd=1 http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...5785363901&rd=1 http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...5786702185&rd…

I would like to try and build a ported box for a 12" Kicker CompR but need some direction. I downloaded some apps and did some reading but I think it may have confused me even more. Does anyone have plans for a box design? Thanks for any help.

Please read and abide by the rules. Thank You.

How are these subs? Are they loud? Do the sound clean? How do you think they compare to the SSA dcons? I'm getting either a pair of the Level 2 15s for sealed operation, a pair of Level 2 12s for ported or a pair of the dcon 12s for ported operation. I'm looking to purchase one of these pair of subs today! Do the Level 2s get loud sealed? I just want a loud and clean setup. Either pair will be powered by 700 watts.

When will these be available again?

I have 2 Rockford Fosgate rfr3110's and Im planning on building a ported box for them both but I want to know the difference between separating the 2 subs to one sub per chamber (2 ft^3) with 1 square port each OR having both subs in the same chamber (4^ft3) with 2 same sized ports. Basically, I have the size and dimensions of the box ready to draw up, but should I have a divider between the 2 subs in the box?

Hello guy was really looking at some new subs to replace my old jl audio w6 12"s. I was interested in the sundown sa12 model and been checking out some nasty videos where these sub can take a beating and put up some numbers. But was wondering if there where any standard cut sheets on these subs? I've seen on there website for box volumes. Was thinking on going ported and i have not built any ported boxes, but was just wanting to just get the dimensions and go.

I have a 09 Silverado and I'm thinking about getting something like a console custom built so I can mount my iPad in it. I always have my iPad connected to my radio and I think it will look much cleaner mounted.. but anyway I want to have a set of components installed I'm the console also. how do you guys think it would should and will it be a waste of money to do so? these are the component sets that's I'm most interested in alpine type r sundown sa series comps incriminator audio comps

Its come the time to glass some kicks and a pillar pods for the truck. so far im leaning toward the 6.5" MB Quart Premium comps for the kicks and 4" Premium comps also. im open for suggestions i want matching sets so top and bottom looks even. tweeter does not have to match woofer though. just as long as both sets look the same Any opinions/ experience/ suggestions would be appreciated

please delete

nvm

Nevermind sorry Mags gonna be out of commission for awhile.... Or perhaps I can give her about 400 watts to get me by. Jordan

Well I currently have a solox 18 and I know that they are two different subs but I got the opertunity to pick up an 18 that hasn't been used for a used price and then I figured I would purchuse another to even it out. I understand that the 2 subs are totaly different. The RLP's will see about 1200 rms. I know thats a little over rated but I figured in the 4 months that I have owned the solox I have cranked it 2 maybe 3 times for about 2 seconds a time so I figured I would be pushing it but should be ok. I would install them in 10 cubes at 27 hz in a dodge ram extended cab. I think that they would sound good and still get pretty loud but would they get louder than the…

Hey Mark, Just curious how much it would cost to get one of my Mach 5 SPL-12s fixed. It fell in my box, and cracked the basket. My dad and I used some epoxy and got the basket as true as it could be before we epoxied it, however I'd like to get it repaired right. It would need a new recone and basket I would think. Are you able to repair your subs, and if you can, how much would you figure it would cost?

I think I am going to run either two 15" Audiopulse Revos or 4 12" AP Epics. What do you all think? Any other suggestions? Either will PROBABLY be run sealed off of a zx2500.1.

I saw this video and though it was insane and wanted to share. Enjoy.

im gonna make a box for the girlfriends 02 bug for the RE SRX 10 and which would be the best. sub back port up, sub back port side, or sub back port back? or does it not matter really. not goin for a major setup, just a little smooth bump. thinking 1.5 cubes 35hz

Ok well I thought I was gonna get me a few lvl4 12's to put in my car and do a lower class in NSPL. But I found a pickup that I am thinking about buying and just cutting the hell out of it. So if I get this truck I believe I may do a bit of serious bass racing. So My question is could a lvl5 15/18 take an IA 40.1 daily. I have never been known to care for the one note wonder and never shy enough not to let any one that wanted to take a listen and look around. So I am in search of a sub that can take 3000+ for a good duration. I figure I may as well make a wind tunnel out of it for the fun. I am also looking at a few other subs for the job but I seem to be really dr…

I have an 18" TC 5200 and it works just fine, however, one of the tinsel leads came off from the spider and there is a hole in the spider. There are also some marks on the coil, not sure if its coil rub or what exactly since I dont hear any coil rub. The driver still functions just fine and I've been using it in its condition for several months now, but I would like to have a sub with no flaws, I guess I'm just picky like that. I was wondering who can recone the sub or perhaps get me a new top assembly to match the adapter I have. I might even be interested in another driver, but of course, I'd prefer to go the route that saves the most money. Any suggestions would be …

i know this isn't really the sight for marine audio, but i got sooooo much help from the forums here about car audio. i recently put a 18" fi btl sub in my jeep. I have a brand new mb sports wakeboarding boat, and the stock system it has is weak! i want to replace the stock speakers, head unit, and put tower speakers, and at least 1 12" sub in the boat. i don't know anything about marine audio though, i need to know good brands out there, install tips, and pretty much everything there is to know about installing boat systems. so if any of you know a thing or two, or could point me in the right direction, it would be AWESOME!!! thanks! Dave [email protected]

I have a pair of PPI Pro 124's that I am going to be running off a MB Quart DSC 1500.1. The thing I want to know is if anyone has experience with these subs, especially using a ported enclosure. I have heard that they can only be ran sealed so that is why I want to know if anyone ever did port them and how did they sound? Any input would be appreciated.

So i have 2 of the old orange basket mojo motors and im trying to find a place i can get some three bolt style baskets to fit them and recones to rebuild them and run about 1750w a piece on them. Any ideas where i could find some parts?

i've been running my magnums sealed for awhile now i feel it's time for a ported box. SI recommends 1.5 cubes per sub tuned to 32 hz. my question is doesn't anybody have there subs in this type of enclosure and how does it sound? or will it sound better in a different size/tuned box?