Subwoofers / Speakers

What sub would hit harder, the sa8 in a 1cu ported box or the dcon 10 in a 1.25cu ported box. This will be run on about 300rms in the trunk of a car

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...AMEWN%3AIT&rd=1 $100 shipped. I'm still hoping they'll come up with some 15's

i rounds sounds better but square hits harder, and do square subs tend to blow quicker??

Ok well getting ready to start work on my van and looks like im going to have to make a few slightly changes. The plans were as followed Midbass 60-100hz : Sundown Audio SD-1 10" x4 Mids 100-2500hz : PHL 2002 x2 Mids/Highs 2500hz + : Image Dynamics CD1E Mini x2 Mids/High Amps : Sundown 100.4 x3 (Bridged To Each Driver) Here is the problem, i dont have the space under the dash or anywere to mount my ID horns. I deffintly want to keep the midbass. So what i need is suggests for mids and highs drivers. What im looking for is an extremly loud and clean sound mids ands highs set up to keep up with my wall. Power will be coming from sundown amps. Corey

i dont think my car will handle my 1200d amp.. if i switch to a 600-700watt amp will that still get the 15 MAG moving good. any harm done underpowering it?

Just tryin to see how close the two are. the Mag will be n a 03 chevy impala in a 2 cubic box tuned to 32 runnin off a sundown 1500d the rf punch hx2's are in a 02 chevy impala in a 3 cubic sealed box runnin off a rf 1501bd Just see if the mag can get as low and loud as the Hx2's?

The pics pretty much speak for themselves.

Whats goin on guys, i'm going to be running 2 15's sealed and I can't make up my mind with all the quality runnin around these days. I am looking into: DC lvl 3 IA Lethal Injection SSA Icon RE SE FI Q I don't know how to read the t/s to see what would act best but I have ~5 cubes gross so I have enough room for them, just no clue what to run subwise. I want loud, and I want a good quality of sound. Oviously ported would be best but I want 2 15's, and i'm not against sealed so that's what i'm going with. Any help is appreciated.

i've been running my magnum with about 800w for the last couple weeks, and its just dying for more power. i am having a new box designed, and i was thinking of buying a 1500bd. now obviously i dont wanna wire the sub to 4ohm, as i will have the same power as now, but i wanna wire it to 1ohm, so im looking at 1600w rms+ (assuming the amp is fine at 1ohm, which i've heard it should be) i will probably have it scoped and setup the gains so it makes around 1.5k which i think is reasonable for a daily drive what i wanna know is what is the maximum i can give it for a daily drive? i probably wont risk anything over 1.5k, but is anyone running more than that?? thanks in advance

Aaron (denim) was gracious enough to give us this forum, so thank him for this. We here at Stereo Integrity are about helping you with any of your audio inquiries. We strive for nothing more than sonic excellence at incredible volume levels, and moderate volume levels. Be sure to check out our web site, www.stereointegrity.com , for all of the latest updates and news releases. Please post anyquestions/concerns you have about any Stereo Integrity product. Marty, Jacob, and myself will do everything necessary to help you out. And remember to try and have fun. Do not post questions that should be addressed via email. All such topics will be promptly deleted. Those…

Okay so I have a 2002 Chevy Malibu. I just want to get a few ideas on how big of a box you guys think I can fit in it. I want to try to fit some xcon 15's ported and firing into the cabin sealed off from re trunk but I don't think that is going to be possible. Lol I would like to do them ported. I think 2 15's sealed would probably fit. Or should I just fit 2 12's ported with the same install, trunk sealed. What do you guys think? I have only owned a sealed prefab box, under powered, kicker L7 15's. I want to feel the lows alot better and have it sound better. Probably tune the box to 28 for 15's and 30 for 12's. I just don't want to get 12's and not be satisfied? But I'm…

ok there is this kid with 3 12" AW1200Qs nad they r not that bad it gets loud it hurt my ears a lil bit. so i know audiobahn r not good but these we decent what ya think

I wanted to know how many DB's you all think I can get out of a pair of these subwoofers? American Bass VFL Series DVC Subwoofers Common Features: * Dual 3" 6 Ohm High Temperature Voice Coils. * 1.4" Wide Multilayer Foam Surround for Better Stable Linear Exclusion. * Non-Pressed Black Treated Paper Cone. * Vented Deep Bumped Back Plate * 180 Ounce Double Stacked Magnet Structure * Dual Black Mirror-Image Spiders For Linear Stability. * Sleeved High Power Tinsel Lead Wires to resist Lead breakage. * Blackened Motor Parts for Superior Heat Dissipation & Long Life * Hyper extended Pole Piece Increases Accuracy, raises Induction. * Deep Bumped Back Plate to Increase Power…

Whats up fellas, I wanted to get some input on what you guys think. I have 4 Sundown audio SD-10's that will be pushed bey a Planet audio BB2400.1. After doing some measurements I dont think I can get optimal box volume for all 4 in a ported box so I was thinking of dropping it to 3 of them in a ported enclosure, that would raise the impedence a bit so I figure about 1500 watts. Or I can run all 4 of them in a sealed box and give them about 2K watts. I am more concerned with the lower frequencys which is why I am thinking of giving up cone area and wattage to be able to tune lower. Do you guys think with the extra cone area and wattage that I could get as much low frequen…

Hey guys, Recently I have been really unhappy with my subwoofer. After my install of the HAT I haven't been using my sub. I have it all the way down on 0 just because it sounds so sloppy. My amp pushes 400 watts at 2 ohms. Give me a few suggestions on a good sub to blend with my hybrids... Edit: Oh and I'm gonna go sealed Thanks, Mike

Whats the ohm load if you wire eight dual four ohms drivers? I know four of them ran "series/parallel" is 2ohm load. Would that mean adding four more in the same wiring configuration make it a final load of 4ohms?

Hello guys, first thread on here Was just wondering, how do you think a D2 will take 2500wrms, on a daily BASSis, i.e streetbass, daily listening, i can't see it being a problem just playing music nicely, but what about when i crank it ? The whole system will be scoped, so it will be getting a purely clean signal, will be ported, about 4cuft, then port displacement, so say even 3 cuft ? I have seen this thing take 1700wrm quite nicely, but what about over quite a period of time ? i mean i know how to treat a sub, i know how they work and how to set a system up. So what you recon ? Go for it ? Also, can they be reconed ? or will i have to buy a new one ? Thanks in advance…

I currently have two Fi SSD 15's being powered by an Audioque 2200d. The output and accuracy of these speakers is amazing, but I feel it is time for a new system to toy with, so they will be going up for sale soon. Also, the box that they are in is slightly too large for my vehicle, so the configuration had to be sub up, port up. I am looking to do four 12's in about 6 ft^3 with a sub up, port back configuration. The only concern I have is losing the low notes. I absolutely love them and play a lot of slowed or chopped and screwed music. The 15's are tuned to 30hz and that is probably where the 12's will be tuned to. I am looking into four sa-12's, but am still kee…

First off... not paying that price... found some used... Boston Acoustics SR60 http://www.crutchfield.com/p_065SR60/Boston-Acoustics-SR60.html?tp=106&nvpair=FFBrand%7cBoston+Acoustics Anyone ever used or had experience with this set??? Specs look pretty good... It's either that or Hi-Vi F1600 probably... I don't think I have the effort in me to go active...

I recently decided on CDT ES-07s as my midrange speakers but i was looking for suggestions on a beefy midbass. THe cdts lack much more midbass then my last speakers but the midrange sound is awesome. anyone played with morel or any diy speakers?

OK heres the deal I went to quite a few audio shops today to price a box for two ported 15's and the answers that i go wasnt the ones i wanted. The only shop that was willing to do the work and told me they would fit is closing for renovation. so now im looking for some 15's that would work great sealed 15's or some that will work good in a small pored enclosure. Like i said in last thread i dont have an amp yet but im purchasing my whole system Monday. the max for each sub is $400...and yea im stuck on two 15's now even though everyone is going to suggest 12's

Hi, What sub can you recommend that are loud and also able to play wide variety of music from rap/rnb to techno/trance/house. 1500wrms and up only Thanks!

Got my new Fi bl 12 with a flatwind coil. i had it hooked up to a pioneer 2 ohm amp at like 600 rms. it was making a strange sound that i couldnt detect. maybe the tinsels hitting the cone? but it wasnt flexing very much. it is a dual 2 ohm voice coil btw.

just curious, (need to ask here to keep out the fan boys) what was the advantage for RE to move to SC on the new XXX (other than more power handeling)?

well i wanted 8's but i like spl. i have a 10" Jl w0 in a sealed cube and that thing slams. im looking for sum 10's that really slam but dont require alot of airspace. ive looked around and cant really find any that are under .75 cu. ft. im looking for sumthing thats under $150. so wats the best 10" sub that performs good in a small sealed box? thanks