Incriminator Audio

I want to do round ports on this next box but I am running into problems of how many I can fit. My numbers look about like this, 17.4 cu ft after all displacements 3 10" round ports 18 or 18.5 (can't remember exact) which is ported right around 35 hz. My main consern is will 3 10" ports be enogh port? Thanks for the help

Rearview hates me Young Jeezy- Hypnotize Outkast- Speakerboxxx Intro. Camera sounds like shit on this one. Don't know why but it sounds much, MUCH better in person.

i finished the install of two dp21's powered by two saz1500d's....all gains were set with a DMM for 1600 watts each(amps were each seeing a .5ohm load) my electrical is very good with a 250amp alt and 2 group 31's in rear and all 0/1ga.. now to my problem...i started to notice a slight rattle coming from the port...so i stuck my head in it and it was coming from one of the subs....there is no way that something could have gotten into the cooling on the sub,so thats out...i think it might be a coil unwinding but ive never had this happen so i dont know what it sounds like...i didnt get a chance to take the sub out to look at it before i left.

Well the smoke has cleared and the dust has settled and the Incriminator fighters came out 1 - 1. One of the IA sponsored fighters was injured during training and was not able to fight. IA fighter Justin Merry lost by a split decision. Justin knocked his opponents front teeth out and after that his opponent laid on top of him and didnt do anything and the ref never stood them up so a tough loss for Justin. A great performance by Justin nonetheless. Now for the fight of the night. Former dB drag World Champ William "Mr. NoWall" Collier came out with fire in his eyes. William and his opponent went after each other like there were decades of hate between the them. William's…

im thinking about going from 2 15's to one 21" DP, my question is what is the recommended box size for these? and can they take more then 1500rms daily? i would be putting 2200rms on it daily. thanks!

Like the title says: I promise to get a better/longer video in the very short future. The SD card wasn't in the camera, so I had less than 40 seconds of video. Kef

So my friend Roger decided to throw his LI 15 dual 4 in 3.0 tuned to 30 and his APSM-1500 @ 2 ohm into our friend Kyle's 2001 Mountaineer for giggles, and asked me to put it on the SPL Labs. Results were not shabby: 134.10 on Air Forces 134.66 on a 43hz tone This was with stock alt, battery, and a shitty Walmart wire kit. Just wanted to share the results. Not bad for a amp/sub/box that's less than 400 bucks

I will be powering these with a 40.1 once I get it back from Nick, my question is, which will be a better setup for daily? I'm looking for SQPL as I don't want to be limited to only SPL. I've heard that the DP's are good daily subs but the DR's are good daily subs also. Either will be in the recommended enclosure and tuned to 30hz for the lows. So what do you all think will be a better daily combo? thanks

Trying to put a system together for a coworker. Coworker 1 has an audioque hdc12 with an AQ 1200.1 amp. He loves the way it sounds, but wants more!! I'm going to sell his amp to coworker 2. What should coworker 2 run with that amp? Two choices I was looking at is an Audioque 18", or two 187 15's. What would have the most output from that amp? Budget is around 200-300 I think.... lol Its going into a Bronco, so sub(s) up and ports back is what I'm thinking for that ""SQL"" sound.... Thanks for any input another sub off that amp, what about an re audio sx 18?

i have been out of car audio for a few years and im about to get back into it, i was looking at the DP 21 (i like one sub setups) what do you guys think the best amp for it would be? its going to be used for a few shows in Maryland and everyday use.

Been asking a few people with 40.1s about the ones i just bought, but ill ask here as well: Have heard i need to run remote from batt because 40.1 needs 12v remote to turn on? Cant have them touch, or they protect? Also, has anyone else had to give them RCA input to turn on? (As in for them to power up they need RCA plugged in and radio on vol 1?) Do they like higher rca voltage, say that of a MaxxLink? Just askin before i put these in Thanks

I want some pricing and some info on a 15'' warden. I need a sub that can handle a good 4k rms daily and get downright nasty in a box tuned @29hz My email is [email protected] thats the best way to get ahold of me. Thanks Dylan

I had a thread in build logs but since IA is going in it I figured I would post here. It has 2 12 Dp's in a transmission line enclosure

I am doing a design for someone and one of the designs i am making needs to be angled in a clamshell and i need to know the width of the magnet so i know whether or not the magnet is gonna be touching the box or not in the blueprints. As of right now, the depth is 11 59\64th at a 12.9 degree angle... I know that isn't good enough but once i have the magnet width, i can input that into the design so i can get the right angle and height for the equation i have.

As the topic says we will be gone for dB Drag Finals! Any emails, PM's, calls will be returned as soon as we get back! Thanks, Nick

Does the IA20.1 do more than rated power?

well for the 99 bucks is that just for one speaker or the set? i know sounds dumb but just wanted to know

Ok so i got four of the 21 inch i.a dp's and im not sure what size or style box that would get the most out of them. would it be better with subs up and port back or in a wall either all the way back or right next to the b pillars. keep in mind this is going in an astro panel. also would they be better in an 8 cube box or 10 cube box. i like low bass so im pretty sure ill do a port at 32hz but size im not sure as ive never had 21's i have two 18's in now (audioque) and they are loud as hell with subs up port back in 12 cube net tuned at 35 hz please give me some opinions on what to do

has anyone used or seen a single warden 12 in action ?

Just a heads up - Expect a delay if you've ordered any products recently - we've had a lot of bad weather the last 2 days. This has caused us to have no phone, no internet, and no power. Expect all to be back to normal Monday!

Okay im building a nice custom box for my 2003 honda accord. But I need to know how tall and wide the port needs to be and what hz I need to tune it to. Anything you all can say would be helpful! By the way im making it out of 3/4" mdf plywood.

spirit left the older version DP and the new one go bye bye :/

I need to know how many cubic feet for two 21'' warden? these will be driven by two memphis mojo 4k and is for everyday use and demos ,and how many square inch in the port for both tuned at 34hz ,the box put in my Ford Expedition 2000 thanks

Recently got in on the Incriminator Black and Blue December sale and purchased a pair of D4 15" LI series subs. These will be going in a 1998 GMC Sierra 4X4 extended cab with 3rd door. Rear seat has been removed so I have the whole back area for subs, amps and batteries. This will be a daily driver with an emphasis on SQ but with the ability to get loud. No competing just enjoyment. What I am wondering is, what would be a good design for the box? Will be going ported tuned to 35Hz. Nick recommended 3-4 cubic feet and I forget how much sq. inch of port but I think 60". Can't get to my yahoo email since Im at work to check. I was thinking woofers front with a rear vented s…