ssh

Thanks, they are indented a little, but the camera flash lights up part of the wood and other part is in shadows and makes it look that way. It's nice having it a little indented though because I mounted my amp on the box so it works out nicely. Tomorrow i'm going to tidy up some of the wires and than i'll post pictures.

No job is too small OR too larger change to large. everything else looks good

I installed a stinger voltmeter, mounted amp and put box in with wiring today. It's all wired up and ready to go, just waiting for subs My voltage is looking good, but i'm running the amp with gain set low since its on a alpine type-r and I don't need to fry it with 1500watts. Next upgrade is replacing 4gauge wire with 0gauge.

sounds good then as far as your battery goes... And you wired it correctly if you did parallel positive to positive and neg to neg.

check the voltage on the rear battery with the car off.

Why not post it in both? Yes, I DO have a big truck with a dildo strapped to my BTL that you can sit on.. im thinkin 25Hz test tone will work nicely Don't need to spam the board looking for shit... But I must say this is pretty funny Next time just post in "for sale / wanted" and only there or check Car Audio Classifieds - Buy, Sell & Trade your Gear! Car Audio Forum Good luck finding the amp

Yes and thank you.

The wiring inside an enclosure from one sub to the other can be slack right? Will it produce any noise or move around when the subs are playing? Thanks

Once your build log is up, i'll be subscribed

^x2

What state does he live in?

Yeah I bet the rain gets annoying, knowing you could finish it up but you gotta just sit there and wait for it to stop

Your craftsmanship is pro Going to be an awesome one of a kind box. Can't wait to see it finished and pounding.

Car is looking awesome, cool to hear a father and son build Wish my dad was into car audio, but at least were able to dirtbike and 4x4 together haha

It does look pretty good for cardboard, but I'd still replace it

Ya I don't remember but Andrew might not have been able to do it because the width is only 14"

Yeah there suspension seats got them off quadratec. Took out the rear bench seat and made custom bracket for a bucket seat thanks everyone

Here's the box finished:

damn, that's cool

I do too

I got some stuff in the mail I don't have my drivers yet but decided to do a test fit with the box hooked up the saz-1500d and made a temp amp rack

I bought a used saz-1500d amp from bigrank916, got the amp fast and works great. Couldn't of had an easier transaction or business dealing Thanks Bigrank916

I got my box today! it was christmas all over again. Thanks Andrew

I could be wrong but I think there only a few inches.

your amp is 1ohm stable, so get a dual 2ohm driver and that will put a 1ohm load on your amp, then you'll be set