NB50

Could have just fixed it.

Cyberpunks are Dead! - Atari Teenage Riot. http://www.youtube.com/watch?v=Kl5swNfFinY

People Are Strange - The Doors

Waves of Disaster - Atari Teenage Riot

Alright good to know, thanks guys.

That is a retarded amount of money for a 32". The picture on my panny is better, it is 3 years old, and was the same price then for a 46" Well I'd imagine its because of using the LED technology, its on a 48 hour sale for ~650.

It's going to be hard to find an amp in that power range to handle a .5 ohm load. Most of the amps that handle that type of load will be larger output amps. You could get a used 1500d that Jacob has but it makes no sense to run an amp a .5 ohm for daily use, just way to much stress on all your equipment to be logical.

Anyone have any experience with LG tv's? http://www.newegg.com/Product/Product.aspx?Item=N82E16889005156&nm_mc=EMC-IGNEFL080510&cm_mmc=EMC-IGNEFL080510-_-EMC-080510-Index-_-LEDLCDTV-_-89005156-LT0D http://www.newegg.com/Product/Product.aspx?Item=N82E16889005148&nm_mc=EMC-IGNEFL080510&cm_mmc=EMC-IGNEFL080510-_-EMC-080510-Index-_-LCDTV-_-89005148-LT0C Curious about picture quality , reliability, etc.

Reflection - Tool.

Don't know that one, I made mine. I would email them to you but its over 250mb.

Got screws?????

I use single tones from 20 to 60hz in 1hz increments. A sweep may work but could be to fast to adjust while its playing, depends on the duration of the sweep.

If you have a scope they why would you use one tone? Use tones from 20 to 60hz and keep adjusting it until you don't have clipping. You can set you amp with one tone at 40hz but move it up to 50 hz and have clipping.

Its been a while since I've done a kerf port, can't recall exactly, but its easy to draw in sketchup and figure out how long the board needs to be and where to start cutting. Thats what I did last time, when I made this.

The RE calculator isn't all that accurate. The box is to small, After all displacements you end up with 1.5ft^3 tuned to ~ 29hz, and you should do a double baffle and bracing will take up space in the box.

4.337 ohms Play through the frequencies taking voltage and current measurements for each, then use ohms law to calculate impedance R=V/I. R= Resistence/impedance V = voltage I = Current.

Liar - Henry Rollins.

Complication - NIN

One continuous piece.

Peace Frog - The Doors

Assuming 3/4 inch MDF, after all displacements 3.73ft^3 @ ~35hz ~14.9 in^2/ft^3 I'd really seriously consider a double baffle and some bracing with the BTL.

I believe he is asking if there is any difference in the wiring like the picture, which there isn't

There is no difference in wiring, they both deliver electricity in the same way.

They are not shielded, I would think most people dont have tube tvs or CRT monitors any more. Andrew I still rock both. In short there is a shield around the magnets to prevent picture distortion in CRT(Cathode Ray Tube) monitors.