Everything posted by shizzzon
-
Installing vinyl graphics on tinted windows
i'm not worried about a broken window, i have ACE Security protection. I'm just worried about vandalism.
-
KnuKoncepts Wiring
yes, u find me some speaker wire that doesnt come as a pair of wires and i'll.... well, you can't, they all do.
-
KnuKoncepts Wiring
my reasons are probably different than his. if this wire is for your single ICON, you can use 10awg just fine, probably 12 but i'd personally do 10. For me, it's for comps so totally different reason. For the OP, i'd stick with speaker wire too. Not necessary to go crazy.
-
KnuKoncepts Wiring
That's what i'm about to do. I need 95ft though for 4 15s, I'm considering runnin 2 runs of 8awg for every terminal.
-
Bad voltage drop w/ new ho alt ?
You guys arent seeing what he did. PUT THE SMALLER PULLEY BACK ON. The smaller pulley lowers the pulley ratio allowing the new alternator to start charging at idle. Since you have removed it and put a larger one on it, the alternator is NOT ON. It's idle charge isn't being kicked in until at a later stage, anything over idle. Pulling any current at the state it's in right now at idle is the same as doing it with the car off. Also, it's VERY bad to keep it like that because it's pulling lots of current out of the battery to keep the car running. I hope you aren't in a traffic jam anytime soon with that large pulley on there. It's common to have to change belts when installing a high output alternator.
-
What causes the subs to stop hitting?
i guess because he has loads of money and his builds are of very high quality. Of course they are not of the highest potential but he seems to be a smart man, cool person to be around and it isnt everyday that people roll up with setups like his. He just got himself a lot more public recognition on the internet which is why he is so popular. Take me for example. I'm about to wall off my Scion tC. There is no other scion tc i have ever seen walled off... so technically i could go get myself recognition for all the scion lovers out there... I'm not but just sayin.
-
Your Favorite show off Songs!
I have been looking for this song for 2 days and cant find it any=where. Can anyone send it to me??? I cant find it as well can some one send it to me to please????? Most of the mainstream music listed previously, lil jon, three six mafia, etc are well known but the majority of music i use is mostly underground only so it's not mainstreamed and lots of it are very very hard to obtain. So... when i start makin my impression videos once my new setup is complete soon, you guys will be seeing a new list of songs to choose from.
-
ShiZZZoN's Build Log
Some more pics for u guys Thanks To AutoCAD, look how close i got to the side of the car without it causing a problem.
-
ShiZZZoN's Build Log
OK, got everything workin again on the car. Dealership ordered a replacement module for the HVAC controls and the check engine light was due to pressure being escaped out of the gas tank... The gas cap was on properly but somehow it was still leaking air out of it.. They re-tightened it and it cleared it. Fedex just stopped by to show u guys this-
-
Installing vinyl graphics on tinted windows
i have one. The only fear i ever have is driving it to a movie theater or especially a theme park.... I usually go to theater during the day right now so it's less risky. Theme parks... well, haven't figured that one out yet.
-
I have a surprise coming!
does this have anything to do with the idea SSA recently announced about selling certified used subs that customers send back to upgrade to something else?
-
Parallel or Series, which yields better results?
burps and bass race. For bass race, i highly doubt i could ever wire down to 0.17 ohms on a 1ohm stable amp so this is purely focused for burps.
-
Parallel or Series, which yields better results?
ok, if my impedance rise in my install is high enough to wire down to 0.17 ohms(all parallel), this will yield a very low BL then correct? i must be very careful.
-
Parallel or Series, which yields better results?
I'm assuming if i had one of those woofer testers to pull the T/S parameters of a speaker, it would pull different specs if i took a single DVC subwoofer and tested it wired in series, then tested it again in parallel. Well, i dont have one so i'm gonna rely on those experienced here to relay some info to me. I will be using 4 subwoofers, 2 subwoofers per amp. Each pair of subs are dual 1 ohm. I have 2 ways of wiring this- 1 - Parallel both subs then series them to the amp 2 - Series both subs then parallel them to the amp Is there a difference in SPL potential between the 2? this info is pertaining to a meter, not the ear. I notice when looking at specs of subs, in general, when comparing their Dual 1 and Dual 2 versions, Dual 1s have less MMS, higher efficiency, but lower BL. Is this what to expect if i parallel then series them? Educate me.
-
Level 4 owners, need magnet measurements
ok, i'll be around hoverin this thread.
-
Level 4 owners, need magnet measurements
dont forget about me
-
best 1500 rms amp for the money
Audioque 1200d = 1470w That sundown 1200 is probably in the same power league as the AQ anyway.
-
2nd battery
if u need to charge a battery up, go with the slower method. Fast charging doesnt top them off as good as slow charging.
-
Got something from UPS Wed
hey are you still comin down and gettin that batt since u had to buy a new sub?
-
Level 4 owners, need magnet measurements
do it. The XL is larger so that would give me safer measurements.
-
Level 4 owners, need magnet measurements
Hey you owners, lol. I need to know what is the mounting depth of JUST the magnet itself. The website says 8" for the whole subwoofer but i am designing my wall and need to draw out the magnet so i can properly run allthread without running into the magnets. So... just the magnet itself, what is the depth? Thank you.
-
ShiZZZoN's Build Log
another delay... Got a check engine light on the car out of the blue today so gotta go take it and have it diagnosed and see what's wrong. During this whole time, i was suppose to install the side walls... There is another problem with the HVAC controls as well so they might keep my car.. wont know til later on tomorrow.
-
When it rains, it pours
take it however u want but i'd look for a job that has a demand that will never end. An example is hospitals and food industry. The odds of being let go in the food industry is very rare. But it also depends what part of the food industry you work in.. I can see people getting laid off in hospitals.. too many employees. I work for a restaurant warehouse and the company cannot fire anyone there unless of course you do something crazy stupid... They will instead transfer an employee to a different division of the company. So, point is, since u are free right now, look for a job that has a high future demand.
-
Two 10" SSD build
we did numerous tests one night, this is the one we ended up goin with according to the meter.
-
Two 10" SSD build
u gettin real close now! I hope u go $20-30 next saturday for the comp.